中原油田深井大井眼段钻井液工艺

濮深8井是中原油田在西部洼陷南部寻找接替储量的一口重点深探井,也是中原油田第一口井深达6000m的超深井。分析了濮深8井钻井液的配备及维护和处理技术,得出深井大井眼段钻井液工艺技术存在以下问题:井眼大,钻井液量及钻屑量多,处理时间长,处理剂用量多,处理频繁;返速低使钻井液清洗井眼的能力减弱;井下温度高使处理剂的作用明显降低,二氧化碳的侵入使钻井液性能变差。钻井液维护处理的较好方法是定时、定量补充处理剂胶液。固相控制是深井大井眼段钻井液工艺中的关键问题,必须配套并且有效地使用固控设备,以维护好钻井液性能。     

Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

借鉴英国经验完善中国土地产权流转

本文在简要介绍中、英两国土地产权制度和土地产权流转的基础上，分析了我国土地产权流转过程中出现的问题，如征地过程中的赔偿过低且不完善、国有土地拆迁补偿不公以及补偿的分配方式不公平等问题。由于英国在土地制度方面与中国的相似性，文章借鉴英国土地补偿中的补偿金与改善金相结合原则、土地使用权的租赁行为以及开发收益回馈社会的方法，为完善和健全我国的土地产权流转机制提出措施和建议。     

Targeting optimum resource allocation using reverse problem formulations and property clustering techniques

Decoupling the constitutive equations from the balance and constraint equations allows for reformulating a conventional forward problem into two reverse problems. The first reverse problem is the reverse of a simulation problem, where the process model is solved in terms of the constitutive (synthesis/design) variables instead of the process variables, thus providing the synthesis/design targets. The second reverse problem (reverse property prediction) solves the constitutive equations to identify unit operations, operating conditions and/or products by matching the synthesis/design targets. Visualization of the problem is achieved by employing recently developed property clustering techniques, which allows a high-dimensional problem to be visualized in two or three dimensions. The clusters by definition satisfy intra-stream and inter-stream conservation through linear “mixing” rules, which allows for the development of consistent additive rules along with their ternary representation.     

丙烯酸树脂涂料的近期进展

介绍了丙烯酸树脂涂料的国内外发展的概况及其性能和应用.提出了我国发展丙烯酸树脂涂料的建议。     

试论E62型精梳机

提出E7／5模式，详述了E62型精梳机在E7／5型精梳机的基础上的改进、利用计算机辅助工程优化设计进行优化组合的成功之处以及管理、维护方面的建议，指出了E62型精梳机的九项缺陷，建议有关纺机厂避免同一模式重复性竞争，开发有自主知识产权的精梳机。     

Rheological behaviour of concentrated yeast suspension

The effect of yeast cell volumetric concentration on the rheological properties of the suspensions was measured in a pipe-flow viscometer at 30°C: at low microbial concentrations the suspensions were Newtonian; however, non-Newtonian behaviour, which could be described by the power-law equation, was observed with suspensions at high microbial volumetric concentrations. At conditions of constant microbial morphology and growth rate, the results also indicated that a relationship could be developed between the power-law constants and the microbial volumetric concentration.     

镀液中SiC含量和粒径对Ni-P-SiC复合化学镀层性能的影响

采用化学镀方法制备了Ni P SiC复合镀层 ,系统研究了镀液中SiC含量和粒径对镀层结构及显微硬度的影响。结果表明 ,镀层中SiC析出量随镀液中SiC含量的增加而增加 ,在SiC含量一定的情况下 ,当SiC粒径为 7.0 μm时 ,析出量最大 ;镀液中SiC的含量和粒度对原始镀层的硬度影响不大 ,但对 4 0 0℃热处理后的镀层硬度有显著影响     

微波等离子体化学气相沉积的 a-Si∶H 性能研究

本文着重对微波等离子体化学气相沉积法高速沉积的 a-Si∶H 膜的物理性能进行评价研究.测量了沉积膜的光电性能、暗电导激活能、光禁带宽度、光吸收特性、沉积膜中悬键态密度以及氢含量等,并讨论沉积条件对膜性能的影响.结果表明,在沉积速率高达30～90(?)/s 情况下,膜的光电导(光照强度10~5Lux)与暗电导比值可达10~3～10~5,暗电导率从10~(-3)到10~(-11)((?)cm)~(-1),其激活能在0.23～0.88eV 之间(0～200℃温度范围内),光禁带宽度为1.40～2.20eV,氢含量约为2～20%.     

Effect of fluoropolymer antidripping agent on the microstructure and properties of polyesters

Poly(ethylene terephthalate) (PET) is of excellent mechanical properties and melt processability and is widely used as raw material for textile fibers. However, the flame retardant properties of PET were rather poor, and both reactive and additive phosphorus- and halogen-containing compounds have been employed to enhance the reaction-to-fire properties while the meltdripping behaviour during burning hasn’t been handled properly with the flame retardants. In this work, fluoropolymer was blended with both pure PET (pPET) and reactive phosphorus-containing flame retarded copolyester (fPET), and the flame retardance and char formation and mechanical properties of the resulted pPET and fPET blends were investigated. The tensile strengths of modified pPET samples were worsen whereas those of modified fPET samples were improved at low concentrations. The initial thermal degradation in nitrogen was accelerated remarkably for the two polyesters with fluoropolymer. The oxygen indices of the all modified samples were reduced while char formation and meltdripping suppression were encouraged. The apparent melt viscosity and elasticity for the two polyesters were gained much with antidripping agent. Therefore, fluoropolymer improved char formation of the two polyesters based on the gaseous phase mechanism while the partial suppression of meltdripping behavior and the decrease of mechanical properties mainly originated from the increase of melt viscosity via fibrillation for pPET.