腐殖酸对烤烟根系生长和生理活性的影响

对腐殖酸和基肥混施进行了烤烟盆栽试验。结果表明 ,腐殖酸能有效刺激根系的生理活性 ,提高根系抗坏血酸氧化酶、多酚氧化酶等呼吸酶的活性 ,增强根系的活力 ,并能有效促进烤烟根系生长 ,根干重、体积和长度均有提高。     

A simple mathematical analysis on the effect of sand in Cr(VI) reduction using zero valent iron

A simple mathematical model was proposed to analyze the enhancement of Cr(VI) reduction when sand materials are added to the zero valent iron (ZVI). Natural decay of Cr(VI) in a control experiment was analyzed by using a zero-order decay reaction. Adsorption kinetics of Cr(VI) to sand was modeled as a first-order reversible process, and the reduction rate by ZVI was treated as a first-order reaction. Natural decay of Cr(VI) was also included in other experiments, i.e., the adsorption to sand, the reduction by ZVI, and both adsorption and reduction when sand and ZVI are present together. The model parameters were estimated by fitting the solution of each model to the corresponding experimental data. To observe the effect of sand addition to ZVI, both adsorption and reduction rate models were considered simultaneously including the natural decay. The solution of the combined model was fitted to the experimental data to determine the first-order adsorption and reduction rate constants when sand as well as ZVI is present. The first-order reduction rate constant in the presence of sand was about 35 times higher than that with ZVI only.     

Determination of shear strength values according to EN 408

This paper presents the results of 382 shear tests carried out according to EN 408. The test pieces consisted of spruce (Picea abies) and varied in density and ring width orientation (radial, tangential and at an angle of 45° to the steel plates). In addition pieces containing pith and knots were tested. The paper discusses problems observed when using this test configuration and shows that the test results do not support the characteristic shear strength values as given in EN 338. Moreover, the test results do not support the relationship between characteristic shear strength and characteristic bending strength as given in EN 384.

---

Résumé Cet article présente les résultats de 382 essais de cisaillement menés conformément à EN 408. Les éprouvettes d’essai sont en épicéa (Picea abies) et présentent une variabilité en termes de masse volumique et d’orientation des cernes d’accroissement (radiale, tangentielle, à un angle de 45° par rapport aux plaques métalliques). Des éprouvettes supplémentaires contenant du cœur et des nœuds ont également été testées. L’article évoque les problèmes qui ont été mis en évidence lors de l’utilisation de ce dispositif expérimental et montre que les résultats expérimentaux ne sont pas en accord avec les valeurs caractéristiques de résistance au cisaillement données dans EN 338. De plus, ces résultats ne confirment pas la relation entre résistance caractéristique au cisaillement et résistance caractéristique à la flexion telle que stipulée dans EN 384.

     

Growth of Fe on Si (100) at room temperature and formation of iron silicide

Low-energy electron diffraction (LEED), Auger electron spectroscopy and X-ray photoelectron spectroscopy (XPS) investigations of both the growth of an iron film on silicon (100) at room temperature and the subsequent formation of iron silicide are the subjects of this paper. An in-situ cleaned silicon (100) wafer without carbon or oxygen contamination exhibiting the known 2 × 1 reconstruction in the LEED pattern served as the substrate. Iron was deposited on this reconstructed surface at 300 K. The comparison of theoretical calculations based on three growth mechanisms with XPS data obtained with take-off angles of 0° and 50° clearly demonstrates a layer-by-layer growth of the iron film on silicon (100). At 300 K no formation of iron silicide was observed, although an interaction between iron and silicon could be detected at the interface. The formation of iron silicide was observed at annealing temperatures of 630–730 K. Quantitative XPS analysis yields the presence of FeSi₂, when the thickness is large enough. Neither the iron film on silicon nor the silicide shows any LEED pattern.     

激光辐照对不同饵料微藻生长的影响

利用Nd:YAG激光(波长1.06μm,功率5W,照射时间0.5-3min)和Ar 激光(波长:488nm,功率70mw,照射时间5-20min)分别照射角毛藻和叉鞭金藻,辐照后进行细胞增殖和生长速率的测定。实验结果表明:照射剂量为1min的Nd:YAG激光及剂量为5min的Ar 激光对叉鞭金藻有较明显的促长效果,这两种激光处理组的细胞增殖量在辐照后的两天内较对照组分别高42.9%和48.1%,但这种促长效果随时间的推移逐渐消失。不同剂量的两种激光辐照角毛藻后,在延滞期均出现生长抑制现象,但进入指数生长期或传代培养后,剂量为1min的Nd:YAG激光及剂量为10min的Ar 激光对角毛藻有明显的促长效果,其中在指数生长期1min剂量的Nd:YAG激光处理可促长27.0%,传代培养后10min的Ar 激光处理组生长速率提高达51.2%。本文对不同激光及不同激光参数条件下,两种饵料藻的耐受性及生长特性的差异也进行分析探讨。本实验结果不仅证实了已有研究的推论,还展示出激光技术在饵料藻种选育中的应用前景。     

企业施工定额的编制以及施工成本分析平台的应用

本文阐述了施工企业内部编制定额的必要性和成本分析平台的实用性,并根据多年的工作经验就建筑施工企业对施工成本的控制谈谈一自己的认识和看法.     

新经济增长理论对我国人力资本发展的借鉴

新经济增长理论为人力资本理论注入了新的内容,为各国如何利用人力资本发展经济提供了理论指导。分析了新经济增长理论中有关人力资本的理论,以此对我国经济和人力资本的发展提出了一些借鉴;收益递增模型。     

在（311）面上所生长的Al_xGa_（1－x）As／GaAs单量子阱特性

文章报道了用分子束外延（ＭＢＥ）法在６００℃和６５０℃下，在Ｓｉ掺杂的ＧａＡｓ衬底的（３１１）Ａ和（３１１）Ｂ面上成功地生长了高质量的ＡｌｘＧａ１－Ａｓ／ＧａＡｓ单量子阱材料。计算了光荧光（ＰＬ）峰值能量，并与实验作了比较。讨论了（３１１）Ａ和（３１１）Ｂ面上的不同生长特性。     

General rate equations and their applications for cyclic reaction networks: multi-cycle systems

The network reduction technique and the Bodenstein approximation of quasi-stationary behavior of reaction intermediates were systematically applied to derive general yield ratio and rate equations for multi-cycle reaction networks in homogeneous catalysis. Dual-cycle reaction networks connected by a linear pathway, multi-cycle networks stemming from the same intermediate, and single-cycle with arbitrary number of pathways between two intermediates were considered. The general yield ratio and rate equations derived in this study are applicable for most enzymatic reactions and for homogeneous catalytic reactions. Examples of homogeneous catalysis were used to illustrate the application of the general yield ratio and rate equations for network elucidation.