Numerical modeling of long waves in shallow water using Incremental Differential Quadrature Method

Incremental Differential Quadrature Method (IDQM) as a rapid and accurate method for numerical simulation of Nonlinear Shallow Water (NLSW) waves is employed. To the best of authors’ knowledge, this is the first endeavor to exploit DQM in coastal hydraulics. The one-dimensional NLSW equations and related boundary conditions are discretized in space and temporal directions by DQM rules and the resulting system of equations are used to compute the state variables in the entire computational domain. It was found that the splitting of total simulation time into a number of smaller time increments, could significantly enhance the performance of the proposed method. Furthermore, results of this study show two main advantages for IDQM compared with other conventional methods, namely; unconditional stability and minimal computational effort. Indeed, using IDQM, one can use a few grid points (in spatial or time direction) without imposing any stability condition on the time step to obtain an accurate convergent solution.     

Distribution of trace metals in the Odra River system: Water–suspended matter–sediments

Extensive investigations of trace metals concentrations in water, suspended particulate matter (SPM) and bottom sediments of the whole Odra River system were carried out over the years 1997–2000. The vertical distribution of selected metals and their mobility were also studied in the sediment cores from upper and middle river sections. Significant levels of metal contamination were found. Median concentrations (Cd, Pb, Cu, Zn and As) in the SPM and sediments were (mg kg⁻¹) 7.1 and 8.9 Cd, 128 and 146 Pb, 81 and 119 Cu, 1198 and 1204 Zn, 48 and 54 As, respectively. The highest metal pollution of the Odra River solids was found with cadmium, zinc, lead and arsenic, showing high similarity in their frequency distributions in both SPM and sediments. Cd, Zn and As appear to be of particular concern because of the high levels, that appear to be bioavailable, and their high mobility. The exchangeable and carbonate chemical forms of Cd and Zn reached up to 50% of their total amount. Besides the determination of total metal concentration, the metal chemical forms in river solids were investigated. The results of very wide studies of the Odra River system through 4 years suggest that metal pollution decreased, especially for Zn, Pb and Cu. Among all metals studied in the Odra River sediments, substantial reductions of Cd contamination were observed neither in the period after ’97 flood, nor if compared with the earlier results obtained before ’97. No essential differences of the metal contents were observed among the samples for the same river compartment, from the same locality, taken within the five sampling campaigns. The pattern of spatial and vertical metal distributions in the river solids indicates that a variety of sources might be responsible for the contamination; very intensive, historical and current mining and smelting activities probably are the most important ones.     

近24a哈尔滨机场跑道易结冰月气温统计分析

本文统计分析了哈尔滨机场1986—2009年3月份的气温,得出近24a3月份的平均气温总体趋势为先升后降,最低气温的变化先于最高气温,其对平均温度的影响较大。气温跟降水成负相关关系,暖干、冷湿相伴,且最高温度与降水日数相关显著。低气温对应的除冰日数多,高气温则少。雪深对跑道结冰有一定的作用,如果预报日气温均≤-3℃,且...     

Regional conductance map of Andaman and Nicobar region

To image the electrical conductivity distribution, fluxgate magnetometers are operated at five sites in Andaman and Nicobar region. Transfer functions are estimated for the period range 8–128 min, from nighttime transient geomagnetic variations, using robust regression analysis. The observed induction arrows in Andaman Islands are found to point towards east despite deep sea located towards its west. This indicates that fore-arc basin (Andaman–Nicobar deep) is more conducting than the region of outer non-volcanic Island arc.Thin sheet model requires the conductance of 10,000–35,000 S (with increase conductivity towards the south) for explaining the observed induction pattern. The observed induction pattern at Andaman–Nicobar stations can be explained in terms of high conducting Cretaceous–Tertiary sediments filling the Andaman–Nicobar deep. High conductivity over Invisible bank has been attributed to the partial melts/volatile fluids derived from the subducting Indian plate that are intruding into the eastern margin of fore-arc basin through the West Andaman Fault (WAF).The induction pattern at Great Nicobar station (Campbell Bay) may be related to the highly conducting sediments filling the Mergui basin along with mafic intrusions. Also crustal transition occurs below the Mergui Terrace at the Malayan coast contributing to the enhanced conductivity anomaly.     

Numerical prediction of performance of submerged breakwaters

The results of a numerical model study on the transmission characteristics of a submerged breakwater are presented. Study aimed to determine the effect of depth of submergence, crest width, initial wave conditions and material properties on the transmission characteristics of the submerged breakwater. The results highlight the optimum crest width of the breakwater and optimum clear spacing between two breakwaters. A submerged permeable breakwater with d_s/d=0.5, p=0.3 and f=1.0, reduces the transmission coefficient by about 10% than the impermeable breakwater. The results indicates an optimum width ratio of B/d=0.75 for achieving minimum transmission. By restricting the effective width ratio of the series of breakwaters to 0.75, studies were conducted to determine the effect of clear spacing between breakwaters on transmission coefficient, suggesting an optimum clear spacing of w/b=2.00 to obtain K_t below 0.6.     

Depth of closure: New calculation method based on sediment data

Obtaining depth of closure (DoC) in an accurate manner is a fundamental issue for coastal engineering, since good results for coastal structures and beach nourishment depend mainly on DoC. Currently, there are two methods for obtaining the DoC, mathematical formulations and profile surveys. However, these methods can incur important errors if one does not take into account the characteristics and morphology of the area, or if one does not have a sufficiently long time series. In this work the DoC is obtained from the break in the trend of the sediment with the depth, that is, in general with the increase of the depth a decrease in the size of the sediment takes place. However, at one point this tendency changes and the size increases, and then decreases again. When comparing the point where the minimum sediment size occurs before the increase, it is observed that the error incurred is small compared to other methods. If the Standard Deviation of Depth Change (SDDC) method is considered as the most accurate method, the error incurred by the proposed method is less than 7%. In addition, it can be seen that the dispersion of the sediment method always occurs outside the zone of bar movement. Whereas in the methods of profiles survey (using 2 cm precision profiles), sometimes the DoC is obtained within the active zone of bar movement. In addition, where the relative minimum of the median sediment size is found, and the sizes of 0.063 and 0.125 mm predominate in the composition of the sample. Therefore, this new method allows the precise location of the DoC to be obtained in a fast and simple way. Furthermore, this method has the advantage that it is not affected by the modifications that may be experienced by both the study area and the cross-shore beach profile.     

甘肃礼县新生代玄武岩的特征及其与地震的关系

本文对甘肃礼县新生代玄武岩及邻区超基性、基性岩的岩石特性进行了简要的叙述，并测定了它们的化学成分，同时还在１×１０３ＭＰａ高压下测定了它们的地震波速度。文中还对玄武岩的物源深度及其与地震的关系进行了探讨。     

Analysis of a large extent aeromagnetic survey near the geomagnetic equator (Minas Gerais,Brazil)

A large extent aeromagnetic survey, covering a 9°×9° degree of a Precambrian shield area in SE Brazil, was used to analyse long wavelength magnetic anomalies with the purpose of determining the magnetic structure of the lithosphere.Data analysis based on a novel approach to the estimation of the parameters in the statistical model ofSpector andGrant (1970), reveals a highly magnetized lower crust, bounded by an essentially non-magnetic upper mantle. The highly magnetized layer can be associated with a higher density lower crust model, derived from gravity and seismic data available in the area, suggesting a compositional transition from upper to lower crust.It was also verified that the operation of reduction to the pole, which is singular at the geomagnetic equator, performs quite satisfactorily at the low geomagnetic inclination of the area, bringing into accordance the long wavelength anomalies with the structural trends.     

2005年新疆克孜尔震群的重新定位

用双差地震定位法对2005年9月23日克孜尔震群进行重新定位。 从平面上, 重新定位地震集中分布在一个长约14.5 km, 宽约 9.0 km的长方形内, 其长轴为N30°W向, 与克孜尔断裂近乎垂直。 从震源深度来看, 重新定位地震的震源深度全部分布在21 km以内, 集中分布在10~19 km, 平均深度为13.6 km; 震群中绝大部分小震发生在沉积层内, 而震级较大地震基本发生在结晶地壳的上地壳内。 其剖面图显示, 这次震群是从结晶地壳开始沿着N30°W方向向上破裂至沉积层。 根据震区附近断裂性质和该区历史小震震中分布分析认为, 克孜尔水库库区附近可能存在两条共轭断裂, 右翼断裂可能是这次震群的发震构造。     

Improving the accuracy of tipping-bucket rain records using disaggregation techniques

We present a methodology able to infer the influence of rainfall measurement errors on the reliability of extreme rainfall statistics. We especially focus on systematic mechanical errors affecting the most popular rain intensity measurement instrument, namely the tipping-bucket rain-gauge (TBR). Such uncertainty strongly depends on the measured rainfall intensity (RI) with systematic underestimation of high RIs, leading to a biased estimation of extreme rain rates statistics. Furthermore, since intense rain-rates are usually recorded over short intervals in time, any possible correction strongly depends on the time resolution of the recorded data sets. We propose a simple procedure for the correction of low resolution data series after disaggregation at a suitable scale, so that the assessment of the influence of systematic errors on rainfall statistics become possible. The disaggregation procedure is applied to a 40-year long rain-depth dataset recorded at hourly resolution by using the IRP (Iterated Random Pulse) algorithm. A set of extreme statistics, commonly used in urban hydrology practice, have been extracted from simulated data and compared with the ones obtained after direct correction of a 12-year high resolution (1 min) RI series. In particular, the depth–duration–frequency curves derived from the original and corrected data sets have been compared in order to quantify the impact of non-corrected rain intensity measurements on design rainfall and the related statistical parameters. Preliminary results suggest that the IRP model, due to its skill in reproducing extreme rainfall intensities at fine resolution in time, is well suited in supporting rainfall intensity correction techniques.