全文获取类型
收费全文 | 87516篇 |
免费 | 7324篇 |
国内免费 | 2654篇 |
学科分类
工业技术 | 97494篇 |
出版年
2024年 | 331篇 |
2023年 | 980篇 |
2022年 | 2198篇 |
2021年 | 2538篇 |
2020年 | 2583篇 |
2019年 | 1949篇 |
2018年 | 1838篇 |
2017年 | 2225篇 |
2016年 | 2530篇 |
2015年 | 2664篇 |
2014年 | 4983篇 |
2013年 | 4959篇 |
2012年 | 5993篇 |
2011年 | 6479篇 |
2010年 | 5115篇 |
2009年 | 5333篇 |
2008年 | 4136篇 |
2007年 | 5753篇 |
2006年 | 5381篇 |
2005年 | 4730篇 |
2004年 | 4055篇 |
2003年 | 3708篇 |
2002年 | 3259篇 |
2001年 | 2557篇 |
2000年 | 2092篇 |
1999年 | 1681篇 |
1998年 | 1320篇 |
1997年 | 1151篇 |
1996年 | 901篇 |
1995年 | 809篇 |
1994年 | 608篇 |
1993年 | 495篇 |
1992年 | 432篇 |
1991年 | 303篇 |
1990年 | 229篇 |
1989年 | 250篇 |
1988年 | 164篇 |
1987年 | 138篇 |
1986年 | 103篇 |
1985年 | 86篇 |
1984年 | 110篇 |
1983年 | 87篇 |
1982年 | 70篇 |
1981年 | 17篇 |
1980年 | 17篇 |
1979年 | 10篇 |
1966年 | 9篇 |
1964年 | 9篇 |
1959年 | 34篇 |
1951年 | 25篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
1.
轻质滤料滤池的试验与研究 总被引:1,自引:0,他引:1
轻质滤料滤池是以比水密度略小的滤料为滤床的滤池,通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象,所取得的结果表明:下向流轻质滤料滤池对浊度和悬浮固体(SS)的去除率分别可以达到80%和45%,而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。 相似文献
2.
Hisakatsu HamaKohji Tashiro 《Polymer》2003,44(22):6973-6988
Structural evolution in the isothermal crystallization process of polyoxymethylene from the molten state has been investigated by carrying out the time-resolved measurements of infrared spectra and synchrotron small angle X-ray scattering (SAXS) and wide angle X-ray scattering. In case of isothermal crystallization at 130 °C, for example, the infrared bands intrinsic of folded chain crystal (FCC) morphology appeared at first, and then the bands of extended chain crystal (ECC) morphology were detected with time delay of ca. 150 s. In the SAXS experiment at 130 °C, the lamellar stacking structure of the long period of ca. 15 nm was observed at first, which changed rapidly to ca. 12 nm in a short time. The SAXS peak with the long period of ca. 6 nm started to appear with a time delay of ca. 150 s after the initial lamellae appeared and coexisted with the initially-observed 12 nm peak. Judging from the timing to detect these characteristic infrared and SAXS signals, a good correspondence was found to exist between the stacked lamellar structure of 12 nm long period and FCC morphology and between the structure of 6 nm long period and ECC morphology. The quantitative analysis was made for the SAXS data on the basis of the lamellar insertion model combined with the paracrystalline theory of the second-kind of disorder. The following structural evolution was deduced from all these results. Immediately after the temperature jump from the melt to 130 °C, the stacked lamellar structure of FCC morphology was generated at first. New lamellae were formed from the amorphous region in between the originally-existing lamellae about 150 s later, where the random chain segments bridging the adjacent lamellae were extended to form the taut tie chains, giving infrared bands of ECC morphology. This inserted lamellar structure of 6 nm long period coexisted at a population of ca. 6% with the initially-formed lamellar stacking structure of 12 nm long period. When the experiment was made at 150 °C, only the formation of stacked lamellar structure of FCC morphology was observed and the insertion of new lamella did not occur. 相似文献
3.
4.
5.
I. Budić-Leto T. Lovrić J. Gajdoš Kljusurić I. Pezo U. Vrhovšek 《European Food Research and Technology》2006,222(3-4):397-402
Identification of anthocyanins in the wine made of the Croatian autochthonous grape variety of Babić (Vitis vinifera L.) was carried out and their profile was determined by means of high-performance liquid chromatography with diode array
and mass spectrometric detection. Dependence of anthocyanins content and profile on maceration treatment conditions was investigated.
Statistically significant differences of anthocyanins concentration in wines Babić produced by various maceration treatments
were confirmed by the use of multivariate analysis of variances. The investigation results indicated that the maceration temperature
exerts higher influence on anthocyanins concentration than the duration of maceration. In addition, on the basis of anthocyanin
composition and using different multivariate statistical analyses, differentiation of wines Babić according to maceration
treatments was procured. 相似文献
6.
7.
洼60-H26水平井套铣打捞技术 总被引:3,自引:1,他引:2
洼60-H26井是一口中曲率水平井,设计井深1 922 m,由于地面条件的限制,设计采用三维井眼轨道。该井水平段在钻至井深1 801 m时,发生卡钻事故。在卡钻事故处理过程中,采用测卡、爆炸松扣技术取出上部钻具后,应用了不同规格的套铣管对被卡钻具进行套铣,采用间歇式套铣方式实现了大斜度井段(45°-90°)的安全套铣,采用短套铣管完成了时水平井段内φ215.0 mm稳定器的套铣,采用φ228.6 mm套铣管成功套铣水平井段被卡LWD仪器,最后通过震击器震击成功解卡。详细介绍了洼60-H26水平井卡钻事故的处理过程,分析了在水平段处理卡钻事故的难点。该井处理卡钻事故的经验,对以后水平井施工中处理井下事故、打捞贵重仪器具有借鉴价值。 相似文献
8.
集成电路生产中废气的污染及治理 总被引:1,自引:1,他引:0
介绍集成电路生产中产生各种废气的种类,废气中有害物质浓度及其危害性,并依据工程实践,评述了各类有害废气的各种处理方法。 相似文献
9.
600 A IGBT开关电路及其散热系统设计 总被引:1,自引:0,他引:1
采用IGBT开关电路,对大功率电阻带进行直流脉宽调制控制,实现了内燃机车大功率直流发电机负载实验中的负载大小的连续调节。为了避免在实验过程中IGBT器件的温度过高,采用独特的双管IGBT结构和双向强迫风冷的散热系统。实验表明该电路运行稳定、可靠。 相似文献
10.
This paper presents a model of heterogenous diffusion in capillary porous materials during the process of drying. The governing heat and mass transfer equations have been established using the liquid as well as vapor flow. Two models have been presented. Model 1 does not consider the heat conduction while the model 2 has been established by considering the conduction. The developed models and the numerical solutions of the resulting differential equations can take into account the moisture and temperature dependent thermophysical properties of the product. All equations have been established in spherical coordinates but the programme written for the purpose of calculations can be used for other geometries also. Numerical calculations have been performed for gas concrete and tiles using model 1, while model 2 has been used for gas concrete only because of the lack of data for thermophysical properties of the tile. For gas concrete it was seen that conduction has only marginal effect on the drying process and the numerical predictions of the drying process were reasonably accurate. 相似文献