Water Cherenkov detectors:MILAGRO

This paper discusses the properties of using the water Cherenkov technique to detect air showers in the few hundred GeV to 100 TeV energy range. The responses of a 6 m² 2 m deep water Cherenkov counter and that of a 6 m² 10cm thick scintillator-lead sandwich counter to air shower electrons and photons is described. The advantages of water Cherenkov detector is outlined. Its application to do VHE gamma ray astronomy is discussed with particular reference to the MILAGRO telescope currently under construction. Milagro, a water-Cherenkov detector to do gamma ray astronomy above 100 Gev, uses an existing pool 60m × 80m by 8m, located in the Jemez mountains near Los Alamos, NM. The threshold of the MILAGRO detector is comparable to atmospheric Cherenkov detectors, however it has several advantages over these optical detectors. MILAGRO can operate 24 hours a day in all weather conditions and it has an open aperture which allows it to view the entire northern sky every day. These capabilities allow for a systematic all-sky survey to be done for the first time at these energies. MILAGRO will measure the Crab spectrum with high significance over a wide energy range, it will detect and measure the spectra from AGN's such as MRK 421 and it will search for short duration bursts from GRBs and possibly evaporating PBHs.     

高精度算术运算

本文针对当前各种计算机高级语言运算精度的不足，用PASCAL语言实现了高精度的加、减、乘、除算术四则运算。以满足教学、科研的实际需要。     

低轨道带可变翼的平板型极高真空分子屏

本文计算了在低轨道自由飞行的平板型分子屏（ＷａｋｅＳｈｉｅｌｄＦａｃｉｌｉｔｙ）加了可变翼后，分子屏后实验区的压力分布。计算中考虑了分子屏和翼材料出气对实验区压力的影响。本文并对加可变翼和不加可变翼、考虑出气和不考虑出气几种情形进行了计算和比较。我们的结果表明：给轨道分子屏加上可变翼后，其实验区的压力可比不加可变翼降低一个数量级以上，压力达１０－１３Ｐａ。本文的研究表明，这种给轨道分子屏加可变翼的模型对更好的利用分子屏环境是非常有利的。     

炭/炭复合材料防氧化涂层研究进展

介绍了近两年国内外开发的几种C/C复合材料高性能抗氧化涂层的微观结构和高温氧化行为,表明SiC-Al2O3-莫来石、SiC晶须增韧陶瓷、硅酸钇等涂层1500℃静态空气环境下均具有长时间防氧化能力,部分涂层还具有优良的抗热震性能。其中采用原位形成法制备的硅酸钇涂层具有极佳的抗氧化性能,可在1600℃空气中对C/C复合材料有效保护200 h。此外,还介绍了部分涂层的失效机理,并就C/C复合材料抗氧化涂层下一步研究重点提出一些见解。     

碳纤维复合材料高压球形容器研制

采用变带距方法对球形容器进行优化设计，并研制了一批产品。试验结果表明，在纤维设计应力相同条件下，采用变带距缠绕的球形容器，其复合材料重量比等带距缠绕的轻２４．５６％，而其容器特性系数高出１０．４％，能同时满足设计提出的强度和重量两方面要求。     

Effect of Counterface Material on Friction and Wear Behavior of Ni-Cr-W-Al-Ti-MoS_2 Composites

Ni-Cr-W-Al-Ti-MoS2 self-lubricating composites were prepared through the powder metallurgy (P/M) method. Their friction properties were investigated by a pin-on-disk tribometer in the range from the room temperature to 600 ℃. Alumina, silicon nitride and nickel-iron-sulfide alloys were selected as the counterface materials. Results indicate that the lowest friction coefficients under 0.22 can be obtained at 600 ℃ when rubbed against alumina. When rubbed against nickel-iron-sulfide alloys, are presented the lowest wear rates in the magnitude of 10-6 mm3/N·m, one order of magnitude lower than those when rubbed against ceramics. In the case of three rubbing pairs, the wear rates of the composite containing MoS2 present themselves inversely proportional to friction coefficients. With alumina ceramics used as a counterface, transfer films and glaze layers will form on the contact surface playing a main role in lubrication at high temperatures. However, when silicon nitride and nickel-iron-sulfide alloy are used, the lubricating transfer films appear not to be promi-nent.     

细长尖头旋成体大迎角非对称涡系结构

本文采用数值计算方法,对细长尖拱旋成体大迎角背风侧非对称涡系结构以及与沿轴向交变的侧向力分布的关系进行了研究.求解的是N-S方程,采用Jameson中心格式,湍流采用修正的B-L模型.通过数值模拟揭示了在头部开始产生非对称涡,形成二次涡的机理以及在背风侧形成集中涡的过程.从而说明了采用集中涡来模拟这类流场的正确性,表明了二次涡对多个脱体集中涡形成的贡献.     

热暴露对IMI834近α高温钛合金组织和拉伸性能的影响

测试了ＩＭＩ８３４高温钛合金在６００～７５０℃的空气中热暴露１００小时后拉伸性能，利用透射电镜和扫描电镜观察了合金暴露前后的组织变化及拉伸断口，认为表面氧化是造成合金热暴露后塑性下降的主要原因，但基体组织内有序α２相和硅化物的析出变化也在不同程度上造居了合金热暴露后的强度和塑性的下降。     

DA4169合金高温疲劳裂纹扩展速率

实验研究了直接时效ＤＡ４１６９合金５５０℃、６５０℃下的疲劳裂纹扩展行为，并进行了带上峰值保持时间的试验。结果表明：连续循环的ｄａ／ｄＮ值基本上与普通４１６９的相当，但在６５０℃下略优；６５０℃带上峰值保时１５ｓ的ｄａ／ｄＮ值比连续循环的大大加速。     

三角翼低速动态大攻角气动特性试验研究

对后掠角分别为X=60°、70°和80°尖前缘平板三角翼模型和一个前缘后掠角为（76° 40°）的双三角翼模型在低速风洞中作大攻角俯仰摩波运动，振幅am=30°、60°和90°，缩减频率K=0.01～0.12，基于根弦长雷诺数Re=2.76×10^5～8.23×10^5。进行了六分量动态气动载荷测量，动态流动显示和70°三角翼上翼面非定常压力测量，并分别与对应的静态试验结果比较。分析了运动参数包括缩减频率、振幅和Re数、后掠角对气流动态迟滞特性的影响。