陈垃圾土的压缩性试验研究

首先介绍了重庆市主城区填埋场的现状，论述了深入研究陈垃圾土压缩特性的重要性。作者在简要总结了采样场内陈垃圾土的基本物理性质后。通过室内侧限压缩试验(亦称固结试验)，得出了描述陈垃圾土压缩性质的基本参数，如αv、Es、mv和Cc等，试验表明陈垃圾土是一种不同于常见土类的高压缩性欠固结土，试验结果可为填埋场再利用和已封闭填埋场的沉降计算提供依据。     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

聚酯纺粘土工布和GCL在垃圾填埋场中的应用

主要介绍了土工布和膨润土防水毯（GCL）在垃圾卫生填埋场应用中的特点和作用，阐述了在卫生填埋场设计中选择土工布和GCL应注意的一些问题。     

城市垃圾渗滤液烟气脱硫体系气液吸收与解吸过程的数学模拟

针对垃圾渗滤液烟气脱硫体系气液吸收和解吸过程反应复杂的特性,基于经典双膜传质理论,建立了填料塔内湿法烟气脱硫模型,包括填料塔反应器模型和烟气SO2在垃圾渗滤液中吸收并伴随氨的解吸过程的数学模型。模型将系统内复杂的多组分反应分解为独立的离子反应,从而在确定的独立反应的条件下,可使模型的数值求解不依赖于特殊的假设条件以及可变的操作条件。根据工艺研究的实验条件对模型赋初值,结合模型参数估值确定适宜的边界条件,采用Maple 8.0对模型方程进行求解,得到了液膜内各组份的浓度分布特性曲线,以及气相分压、pH值、传质阻力、传质速率、吸收增强因子等沿塔高的分布特性,结果表明模型预测结果和实验结果吻合良好。所建立的模型为本工艺过程和其它湿法烟气脱硫过程的传质-反应现象提供了一个定量的理论分析和工程设计基础。     

工业有害废物填埋场渗析液处理设计

根据工业有害废物填埋场渗析液中含有多组份重金属以及水量的不连续性和出水回用的特点 ,采用化学处理法与过滤、吸附相结合的方法处理此渗析液 ,使出水达到国标“农业浇灌用水”标准的要求     

Preparation Polyelectrolyte Complexes of Chitosan-Polyacrylic Acid-Modified Iron Sand Leachate for Proton Exchange Membranes

ABSTRACT

Polyelectrolyte complex (PEC) of chitosan (Chi) and poly (acrylic acid) (PAA)-modified iron sand leachate were prepared and considered for applicability as a proton exchange membrane in fuel cells. Chi-PAA-hematite blended in different weight ratios and the resulting membranes were treated to enable the formation of the polyelectrolyte. The membranes of Chi-PAA polyblend were treated using iron sand leachate and reveal high ion exchange capacity (IEC), proton conductivity, water uptake, and good mechanical stability. The result of research indicated that the membrane with 40 wt% of Chi and 60 wt% of PAA blend which its conductivity of 6.10 × 10^?2 S cm^?1 was potentially for a proton exchange membrane in fuel cell applications.     

考虑降解率下的垃圾土降解压缩量计算模型

从无机物质量不变出发,在考虑降解率与密度变化的情况下,围绕垃圾土的密度、质量与体积三者关系,结合由自配试样进行降解试验获得的降解率规律,推导了垃圾土一维降解压缩模型。研究结果表明,降解压缩量与初始时刻有机物的体积百分含量、降解率及初始高度有关,且成正比关系。利用该模型对重庆市某垃圾填埋场的有机物降解沉降量进行了计算,可以看出降解沉降量与时间呈指数函数关系,在填埋初期降解沉降速率较大,随着时间推移,降解沉降量趋于稳定。     

两级UBF-两级BCOR工艺处理垃圾渗滤液启动研究

采用两级UBF-两级BCOR工艺处理垃圾渗滤液,对工艺的启动情况进行了研究。试验结果表明：当水力负荷为0．42h／L,启动时间为60d时,出水COD平均去除率为67．4％,UBF工艺中出现甲烷八叠球菌,BCOR反应器的填料上已形成基本稳定的微生物种群,启动顺利完成。     

Life cycle analysis of sanitary landfill and incineration of municipal solid waste

1　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｒａｐｉｄｅｃｏｎｏｍｉｃｄｅｖｅｌｏｐｍｅｎｔａｎｄｕｒｂａｎｉｚａ ｔｉｏｎｉｎＣｈｉｎａｉｎｒｅｃｅｎｔｙｅａｒｓｈａｓｒｅｓｕｌｔｅｄｉｎｓｕｂｓｔａｎ ｔｉａｌｉｎｃｒｅａｓｅｏｆｓｏｌｉｄｗａｓｔｅ .Ｉｔｗａｓｅ     

微电极耦合MBR处理垃圾渗滤液

针对垃圾渗滤液难降解、高氨氮和高CODCr的特点,提出了微电极与MBR联合工艺对其进行降解。实验探讨了电流密度、极板间距、氯离子质量浓度和停留时间等4个主要参数对CODCr和氨氮去除率的影响。利用De-sign-Expert.V8.0.6.1软件设计响应面实验确定最佳工艺条件：电流密度13 mA.cm-2、极板间距10 cm、氯离子质量浓度4 200 mg.L-1、停留时间10 h。在此条件下CODCr去除率89.56%,氨氮去除率92.29%,且出水氨氮和CODCr都达到垃圾渗滤液处理排放标准。