Asymmetrically zoned reaction rims: assessment of grain boundary diffusivities and growth rates related to natural diffusion-controlled mineral reactions

This study explores garnet coronas around hedenbergite, which were formed by the reaction plagioclase + hedenbergite→garnet + quartz, to derive information about diffusion paths that allowed for material redistribution during reaction progress. Whereas quartz forms disconnected single grains along the garnet/hedenbergite boundaries, garnet forms ～20‐μm‐wide continuous polycrystalline rims along former plagioclase/hedenbergite phase boundaries. Individual garnet crystals are separated by low‐angle grain boundaries, which commonly form a direct link between the reaction interfaces of the plagioclase|garnet|hedenbergite succession. Compositional variations in garnet involve: (i) an overall asymmetric compositional zoning in Ca, Fe²⁺, Fe³⁺ and Al across the garnet layer; and (ii) micron‐scale compositional variations in the near‐grain boundary regions and along plagioclase/garnet phase boundaries. These compositional variations formed during garnet rim growth. Thereby, transfer of the chemical components occurred by a combination of fast‐path diffusion along grain boundaries within the garnet rim, slow diffusion through the interior of the garnet grains, and by fast diffusion along the garnet/plagioclase and the garnet/hedenbergite phase boundaries. Numerical simulation indicates that diffusion of Ca, Al and Fe²⁺ occurred about three to four, four and six to seven orders of magnitude faster along the grain boundaries than through the interior of the garnet grains. Fast‐path diffusion along grain boundaries contributed substantially to the bulk material transfer across the growing garnet rim. Despite the contribution of fast‐path diffusion, bulk diffusion through the garnet rim was too slow to allow for chemical equilibration of the phases involved in garnet rim formation even on a micrometre scale. Based on published garnet volume diffusion data the growth interval of a 20‐μm‐wide garnet rim is estimated at ～10³–10⁴ years at the inferred reaction conditions of 760 ± 50 °C at 7.6 kbar. Using the same parameterization of the growth law, 100‐μm‐ and 1‐mm‐thick garnet rims would grow within 10⁵–10⁶ and 10⁶–10⁷ years respectively.     

Carbonyl products of the gas phase reaction of ozone with 1,1-disubstituted alkenes

Carbonyl products have been identified and their formation yields measured in experiments involving the gas phase reaction of ozone with 1,1-disubstituted alkenes at ambient T and p=1 atm. of air. Sufficient cyclohexane was added to scavenge the hydroxyl radical in order to minimize OH-alkene and OH-carbonyl reactions. Formation yields (carbonyl formed/ozone reacted) of primary carbonyls were close to the value of 1.0 that is consistent with the mechanism: O₃+R₁R₂C=CH₂ (HCHO+R₁R₂COO)+(1–)(R₁COR₂+H₂COO) where formaldehyde and the ketone R₁ COR₂ are the primary carbonyls and R₁R₂COO and H₂COO are the corresponding biradicals. Measured values of were 0.58–0.82 and indicate modest preferential formation of formaldehyde and the disubstituted biradical as compared to the ketone and the biradical H₂COO. Carbonyls other than the primary carbonyls were identified. Their formation is discussed in terms of subsequent reactions of the disubstituted biradicals R₁R₂COO. Similarities and differences between disubstituted and monosubstituted biradicals are outlined.     

载荷试验确定基床系数修正方法的讨论

Winkler地基模型是目前工程界应用最广的一种地基模型，但对其关键参数——基床系数k的确定，许多文献的表述并不一致。该文在大量试验资料的基础上，通过对该问题的深入研究，阐明了通过载荷试验确定基床系数修正方法的有关概念。对于砂性土地基，载荷板试验得出的基准基床系数仅需要进行基础大小修正，而对于粘性土地基，则需要进行基础大小和基础形状两项修正。     

区域成矿流体的形成与演化

成矿流体是富含挥发份、碱金属的含矿卤水 ,其中碱金属来源于岩浆热液、变质热液、海水及通过水岩作用从岩石中萃取等 ;而挥发份来源于地幔、水岩作用与有机质分解作用。成矿流体中的硫也是多来源的 ,硫的活度与氧逸度有关 ,高温还原环境H2 S的活度降低 ;成矿流体的同位素分馏与水岩作用强度有关 ,控制同位素分馏的基本因素是温度及水岩比值。根据成矿流体的成分及物理化学性质 ,可以分类为高温硅钾卤水、中温碳酸盐卤水及低温硫酸盐型卤水。成矿流体没有固定的来源 ,在一定地质条件下 ,任何来源的热水流体都可以形成成矿流体。控制成矿流体形成的主要地质作用是岩浆作用、变质作用、地热增温作用及构造作用等。文中根据地质作用类型对区域地质流体进行划分 ,可分为岩浆作用区域成矿流体 (以高温硅钾卤水为主 ,可以有高温到中低温的流体分带 ) ,沉积作用区域成矿流体 (以中低温碳酸盐及硫酸盐型卤水为特征 ) ,大洋盆地区域成矿流体 (与岩浆岩区域成矿流体类似 ,有高温到低温的流体分带 )和变质作用区域成矿流体 (变质程度不同而有不同的流体类型混合 )。     

地浸采铀浸出液氧化沉淀法除铁研究

在氧化沉淀法去除铁的过程中,氧化反应分别在自然曝气、充气和除钙的条件下进行,对照结果进行分析,得出最佳的除铁配方,同时还着重对氧化反应速率及其影响因素（pH,Eh等）进行了探索性研究,为以后试验提供了一定的依据。     

凹凸棒石与Zn^2＋的长期作用研究

以凹凸棒石与Zn2＋为例研究粘土矿物与重金属离子长期作用过程,并运用高分辨透射电镜和X射线衍射分析粘土矿物与重金属离子长期作用的次生物相。结果表明：Zn2＋与凹凸棒石的长期作用是一个二阶段的过程,初始阶段为快速吸附作用,其后表现为慢速沉淀反应。高分辨透射电镜和X射线衍射分析表明,凹凸棒石与Zn2＋的长期作用过程中,具有纳米矿物特性的凹凸棒石表面快速水化,提高了悬浮液的pH值,诱导Zn2＋水解沉淀。而后,凹凸棒石缓慢溶解释放Al3＋和SiO44-与Zn（OH）2沉淀反应,形成Zn-A1双氢氧化物和异极矿。这一结果对认识土壤环境中重金属与粘土矿物的作用及重金属的归宿具有重要意义。     

锰矿石脱硫产物处理含铜废水动态实验研究

氧化型锰矿石脱硫产物含大量硫化锰,利用这种材料装填固定床进行净化水中铜离子的动态试验.在材料粒径0.45～0.9mm、进水pH=5.8、进水滤速4.58 m/h条件下,1 t锰矿石脱硫产物可以处理923 tρ(Cu~(2+))=50 mg/L的含铜废水,出水ρ(Cu~(2+))<0.5 mg/L,低于国家一级排放标准.控制进水pH在4～9之间、降低进水滤速、采用较小粒径的材料有利于提高锰矿石脱硫产物处理含铜废水的容量.利用X射线粉末衍射(XRD)和扫描电镜-能谱分析(SEM-EDS)对材料和产物进行表征,证明锰矿石脱硫产物去除水中铜离子是基于离子交换反应的原理.     

热液成矿作用的一般动力学方程

分析了热液成矿作用的基本特点和研究现状，推导出热液成矿作用动力学体系的一般方程，并着重讨论了方程中表征热液与围岩之间化学反应的速率项，除目前一般采用动力学实验实测反应速率常数外，作者根据局域平衡原理，认为成矿作用可视为体系内各点随着温度和压力的变化不断重建平衡的过程，可用温度和压力变化时成矿反应的平衡常数的变化速度表征成矿反应的动力学行为，成矿化学反应的速率还可用主要成矿物质的溶解的变化率来表征。     

华南加里东期金矿床的基本特征

文章分析了安徽月山矿田夕卡岩型矿床形成过程中水岩作用的类型和特征。估算和讨论了水岩作用过程中的质量－体积变化和动力学问题。结论认为：水岩作用对流体成矿系统中夕卡岩和蚀变矿化作用的发生、发展，成矿流体的形成，成矿物质的富集，矿床定位等具有重要意义；水岩作用的水岩比值（W／R）小于0．1；夕卡岩和矿化蚀变分带是开放体系一系列溶解沉淀波反应前锋发生水岩反应后矿物和元素组合的时空分离的结果。