Response behaviour of triangular tension leg platforms under impact loading

Excellent station keeping characteristics and relative insensitivity with increasing water depth make triangular tension leg platforms (TLPs) a proven concept in deep water oil exploration. TLPs are often subjected to less probable forces which arise due to collision of ships, icebergs or any other huge sea creature. Dynamic analysis of two triangular TLP models at water depths 1200 and 527.8 m is performed under regular waves along with impulse load acting at an angle of 45 degrees at the TLP column. Hydrodynamic forces on these TLPs are evaluated using modified Morison equation, based on water particle kinematics arrived at using Stokes’ fifth order wave theory. Based on numerical studies conducted, it is seen that impulse loading acting on corner column of TLP significantly affect its response while that acting on pontoons dose not affect TLPs behaviour.     

Seasonal variations in river discharge and nutrient export to a Northeastern Pacific estuary

Seasonal variations in dissolved nitrogen and silica loadings were related to seasonal variability in river discharge. Dissolved nutrient concentrations measured weekly at three stations in the Yaquina River, Oregon from 1999 through 2001, and then monthly in 2002 were used as the basis for developing a nutrient loading regression as part of a larger agency program for evaluating nutrient processes. Because realistic models of nutrient transport require dense data sets to capture both long and short term fluctuations in nutrient concentrations, data at one freshwater station also were collected hourly for the same years using an in-stream monitor.The effects of storm events on dissolved nutrient transport were examined during three storms, including one in a high rainfall-discharge year, and two in average years, one of which followed a drought year. During the drought year (WY2001), total dissolved nitrate input was considerably less than in wetter years. Dissolved nitrate concentrations, however, were unusually high in the first winter storm runoff after the drought. The freshwater dissolved nitrate nitrogen loads varied from 40,380 kg day⁻¹ during a high-flow storm event to 0.11 kg day⁻¹ during late summer, low flow conditions. Dissolved silica dynamics differed from those of nitrate because during storm events, silica concentrations in the Yaquina River decreased to near zero at the storm height, probably due to dilution by near surface or overland flow, and later recovered.During the time interval studied, over 94% of the dissolved nitrate and silica were transported from the watershed during the winter months of greater rainfall, indicating that seasonality and river flow are primary factors when considering nutrient loadings from this watershed system.     

Analysis of seabed instability using element free Galerkin method

Wave-induced seabed instability, either momentary liquefaction or shear failure, is an important topic in ocean and coastal engineering. Many factors, such as seabed properties and wave parameters, affect the seabed instability. A non-dimensional parameter is proposed in this paper to evaluate the occurrence of momentary liquefaction. This parameter includes the properties of the soil and the wave. The determination of the wave-induced liquefaction depth is also suggested based on this non-dimensional parameter. As an example, a two-dimensional seabed with finite thickness is numerically treated with the EFGM meshless method developed early for wave-induced seabed responses. Parametric study is carried out to investigate the effect of wavelength, compressibility of pore fluid, permeability and stiffness of porous media, and variable stiffness with depth on the seabed response with three criteria for liquefaction. It is found that this non-dimensional parameter is a good index for identifying the momentary liquefaction qualitatively, and the criterion of liquefaction with seepage force can be used to predict the deepest liquefaction depth.     

江西省永平铜矿西部排土场极限堆载高度确定

国内外对排土场极限堆载高度的理论计算缺乏研究,目前尚无成熟的统一理论计算方法。文章结合永平铜矿西部排土场的工程实例,在进行边坡工程地质条件勘察与排土场岩土物理力学性质试验研究的基础上,采用数值计算方法对排土场进行了分层堆载数值模拟计算。通过对计算结果的分析,得到位移、塑性区与安全系数随堆载高度的变化规律,并确定了该排土场的极限堆载高度。     

Direct shear tests on Mexico City clay with reference to friction pile behaviour

Summary This paper presents results of static and cyclic direct shear tests performed on undisturbed and remoulded samples of Mexico City clays, including results of soil-on-interface tests. Experiments show that the static adhesion coefficient depends on the soils' liquidity index and that it diminishes due to the effect of repeated dynamic loads. Dynamic overstrength effects were not apparent, as has been observed when testing this clay in other apparatus. Interface strength in remoulded clays is initially less than half the strength of interfaces with undisturbed materials but it increases with time. At least in the materials tested in this research, it did not equal the strength of interfaces with undisturbed materials. Correction factors derived from experimental data can be used to modify the adhesion coefficient to account for dynamic and remoulding effects.     

三峡库区滑坡治理工程设计中推力荷载计算方法初探

随着三峡水利工程的逐步实施，淹没区移民及新城镇建设等人类工程活动的加剧，以滑坡为主的环境地质问题日益突出。本文从稳定系数、安全系数入手，对铁道、公路等部门常用的设计计算原理进行了研究，并由此类比分析研究了三峡区回水后或库水位正常运行条件下，滑坡治理工程设计计算方法。     

Researches on Cartographic Database-Based Interactive Three-Dimensional Topographic Map

With the development of computer graphics, the three-dimensional (3D) visualization brings new technological revolution to the traditional cartography. Therefore, the topographic 3D-map emerges to adapt to this technological revolution, and the applications of topographic 3D-map are spread rapidly to other relevant fields due to its incomparable advantage. The researches on digital map and the construction of map database offer strong technical support and abundant data source for this new technology, so the research and development of topographic 3D-map will receive greater concern. The basic data of the topographic 3D-map are rooted mainly in digital map and its basic model is derived from digital elevation model (DEM) and 3D-models of other DEM-based geographic features. In view of the potential enormous data and the complexity of geographic features, the dynamic representation of geographic information becomes the focus of the research of topographic 3D-map and also the prerequisite condition of 3D query and analysis. In addition to the equipment of hardware that are restraining, to a certain extent, the 3D representation, the data organization structure of geographic information will be the core problem of research on 3D-map. Level of detail (LOD). space partitioning, dynamic object loading (DOL) and object culling are core technologies of the dynamic 3D representation. The objectselection, attribute-query and model-editing are important functions and interaction tools for users with 3D-maps provided by topographic 3D-map system, all of which are based on the data structure of the 3D-model. This paper discusses the basic theories, concepts and cardinal principles of topographic 3I)-map,expounds the basic way to organize the scene hierarchy of topographic 3D-map based on the node mechanism and studies the dynamic representation technologies of topographic 3D-map based on LOD, space partitioning, DOL and object culling. Moreover. such interactive operation functions are explored, in this paper, as spatial query, scene editing and management of topographic 3D-map. Finally, this paper describes briefly the applications of topographic 3D-map in its related fields.     

Study of the liquefaction resistance of a saturated sand reinforced with Geosynthetics

This article presents various tests using a cyclic triaxial instrument, on samples of saturated Hostun RF sand, reinforced with circular sheets of geosynthetic material. Tests performed with different types of geosynthetics of different compressibility, rigidity and roughness characteristics indicate a significant increase in liquefaction resistance for samples reinforced with compressible, non-woven geotextiles. The undrained behaviour of saturated Hostun RF sand reinforced with non-woven geotextiles is analysed on the basis of different test series. This analysis highlights the influence of reinforcement compressibility on interstitial pressure distribution in the sample, thus showing the role of this type of inclusion in the increase in liquefaction resistance.     

华北地区700年来地壳应力场演化与地震的关系研究

目前地震断层相互作用问题已引起地震学家的广泛关注。许多研究表明一条断层的破裂可以影响附近其他断层趋于破裂的进程，两条断层间的确切作用取决于它们的相对位置、破裂机制、错动量和介质力学性质。本研究给出了华北地区700年来由于长期构造加载及地震断层错动导致的累积库仑破裂应力变化(ACCFS)的演化过程。长期构造加载场由GPS观测得到的地壳平均应变率场给出。关于历史地震断层破裂参数的估算，根据的是华北地区有现代仪器记录的大震资料归算地震烈度与断层破裂长度、震级和地震矩的统计关系；根据地质调查得到的地震断层走向、倾角以及本地区的构造应力场方向估计滑动角。考虑粘弹性成层介质地壳模型，计算长期构造加载和地震形变(同震及震后介质粘弹性驰豫变形)造成的累积应力场变化。将累积应力场变化投影到后续地震断层面和滑动方向上得到△CCFS，并研究其对后续地震发生的触发作用。对1303年以来华北地区发生的49个M≥6．5地震研究结果表明：ACCFS对48个后续地震中的38个有触发作用，触发率达到79．2％。应用当今累积应力场变化于华北地区1303年-2003年发生的M≥5地震，我们发现触发率达到75．5％，于1976年以来发生的M≥5地震触发率达82．1％。未被触发的地震中有些是发生在断层破裂区附近的余震，很可能是由于历史地震破裂参量估计的误差落入影区中，若排除这些影响，触发率会更高。研究表明ACCFS与发生的后续地震有很好的相关性。当前ACCFS显著上升的地区包括渤海及其邻域地区、西秦岭北缘断裂带、张家口-渤海地震带西端和太原盆地，其地震危险性应引起重视。