Axial convergence in a well-mixed estuary

Transverse secondary circulations involving surface convergence, observed in a well-mixed estuary in North Wales, are made visible by the collection of surface material along an axial line which extends continuously for many kilometres through the estuary. The circulation and axial convergence, however, are seen only during the flood phase of the tide and no similar behaviour has been observed during the ebb phase.Convergent circulations in the estuary are associated with small but steady transverse density gradients in the cross-section, produced by non-uniform advection of the longitudinal gradient through the channel. A diagnostic model, using measured mean distributions of cross-sectional density, indicates surface transverse velocities (～0.1 ms^?1) similar to those observed in the estuary. The model further predicts appreciable transverse divergent currents at a fractional depth of 0.75: a prediction which has been tested in the estuary using a vertical array of accurately resolving current direction indicators.     

Modelling the April 15 spectrum of Supernova 1993 J

We present the modeling of the ultraviolet and optical spectra obtained simultaneously on 1993 April 15 with the HST and at Lick Observatory. A Monte Carlo code is employed in the modeling and a comparison is made between models reported by different groups. With an atmosphere similar to the Sun in chemical composition, the observed spectral lines are well reproduced by a power law density structure of index around 20 except the strong H and HeI λ5876 lines which have peculiar absorption profiles. The photospheric velocity is found to be 9500 km/s and the blackbody temperature of the spectrum is 7990 K. For H and HeI λ5876, we suggest a two-component density structure which has a smoother layer located immediately outside the steeply decreasing inner envelope. The power law indices are most probably 20 and 3, respectively, with the transition point at about 13 000 km/s. In addition, this outer smooth layer serves to flatten the far UV spectrum as observed.     

使用GAMIT进行高精度基线向量解算的方法与实践

GAM IT是国际上常用的GPS定位定轨软件,但由于其安装的平台(UN IX/LINUX)与我们通用的W indow s平台有所差异,使得GAM IT的入门较难。因此本文结合具体实例,介绍GAM IT的安装、基本操作以及应用GAM IT进行高精度基线向量解算,供初学者参考。     

浅谈ARCGIS在国家1︰50000 DLG更新中的应用

通过分析ArcGIS中的ArcMap、ArcCatalog和ArcToolbox的特点,简要讨论了它们在国家1︰50000 DLG更新中的应用。     

一种直线特征标志的子像素定位方法

在近景摄影测量中,常常需要对直线特征的标志进行定位,而标志定位的精度会影响到整个测量的精度。不同特征的控制点标志,对应不同的识别方法,因此控制点标志的选择须根据不同的要求,进行综合研究分析。本文提出一种新的混合方法,首先采用Hough变换对直线特征标志进行直线检测,得到直线初值;然后采用灰度矩边缘直线拟合定位法,对标志点中心进行子像素定位。通过实验证明:经过Hough变换得到粗值的灰度矩边缘直线拟合定位法达到较高的定位精度,证明了该混合方法的有效性。     

Simulations of 3D DC borehole resistivity measurements with a goal-oriented <Emphasis Type="Italic">hp</Emphasis> finite-element method. Part II: through-casing resistivity instruments

We simulate direct current (DC) borehole resistivity measurements acquired in steel-cased deviated wells for the assessment of rock formation properties. The assumed data acquisition configuration considers one current (emitter) and three voltage (collector) electrodes that are utilized to measure the second difference of the electric potential along the well trajectory. We assume a homogeneous, 1.27-cm-thick steel casing with resistivity equal to 10^− 5 Ω· m. Simulations are performed with two different numerical methodologies. The first one is based on transferring two-dimensional (2D) axisymmetric optimal grids to a three-dimensional (3D) simulation software. The second one automatically produces optimal 3D grids yielded by a 3D self-adaptive goal-oriented algorithm. Both methodologies utilize high-order finite elements (FE) that are specially well-suited for problems with high-contrast coefficients and rapid spatial variations of the electric field, as it occurs in simulations that involve steel-cased wells. The method based on transferring 2D-optimal grids is efficient in terms of CPU time (few seconds per logging position). Unfortunately, it may produce inaccurate 3D simulations in deviated wells, even though the error remains below 1% for the axisymmetric (vertical) well. The method based on optimal 3D grids, although less efficient in terms of CPU time (few hours per logging position), produces more accurate results that are validated by a built-in a posteriori error estimator. This paper provides the first existing simulations of through-casing resistivity measurements in deviated wells. Simulated resistivity measurements indicate that, for a 30° deviated well, measurements in conductive layers 0.01 Ω· m) are similar to those obtained in vertical wells. However, in resistive layers (10,000 Ω· m), we observe 100% larger readings in the 30° deviated well. This difference becomes 3,000% for the case of a 60° deviated well. For this highly-deviated well, readings corresponding to the conductive formation layer are about 30% smaller in magnitude than those in a vertical well. Shoulder effects significantly vary in deviated wells.     

GIS中直线元内插点精度及对误差带的影响

基于误差传播定律，考虑参数r误差影响，推导了线元内插点的精度计算公式，讨论内插点精度对线元误差带的影响，并对影响的结果进行了分析，得到了一些有益的结论。     

垂线测量数据管理软件的研制及应用

介绍了基于局域网络开发的垂线测量数据管理软件的组成、原理、功能、操作及应用，该软件操作简单、使用方便、极易掌握，并能通过多方位、直观的图形表示来反映监测对象的挠度、倾斜、水平位移状态。     

地下管线源数据处理方法的研究

为了保障顺利建设上海市地下管线数据库．需要对现存的地下管线的源数据进行一些技术处理，以满足数据入库的要求。本文主要个绍：笔者在从事地下管线源数据处理工作中，碰到的现存的上海市地下管线源数据对于建设上海市地下管线数据库所存在的一些问题：以及笔者利用Autodesk公司的AutoCAD二次开发工具开发的应用程序来处理这些问题的方法。