Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

用预先热处理的材料加工长杆高强度双头螺柱

用预先热处理的材料生产长杆高强度双头螺柱新工艺 ,消除了长杆的热处理变形 ,降低了机械性能的不稳定性 ,提高了产品质量及螺纹联接的可靠性。     

锅炉房工艺设计中确定煤场面积的一种方法

本文以管理科学的库存理论为基础，以提高经济效益为目的，提出了一种全新的锅炉房煤场面积确定方法。     

中国科学技术协会五届二次全委会明年在京召开我会两名代表参加全会活动

中国科学技术协会五届二次全委会明年在京召开我会两名代表参加全会活动中国科协第五届全国委员会第二次会议将于１９９７年２月２２日至２４日在北京召开。我会副理事长、中国科协全国委员会委员程映雪教授作为正式代表，我会副秘书长、“中国安全科学学报”主编徐德蜀高...     

不锈钢板式热沉传热特性的实验与模拟研究

目的 研究流量、胀高及焊点排布方式对不锈钢板式热沉传热特性的影响。方法 搭建实验平台,加工出结构参数不同的板式热沉实验件,同时采用静力隐式算法建立相应的几何模型,通过实验与数值模拟相结合的方法,研究流量、胀高和焊点排布方式的变化对板式热沉热阻的影响规律,并分析热沉流道内部流场状态。结果 首先计算了6个工况下的热阻,发现实际换热量为540 W时,数值模拟与实验结果的最大相对误差不大于25%。然后分析了误差来源,最后得到了热沉全流道速度场与温度场的分布情况。结论 实验与模拟结果有较好的符合程度,证明了数值模拟方法的可靠性。在换热量相同时,板式热沉的热阻随流量与胀高的增大而减小,焊点为菱形排布的热沉传热性能相对更好。板式热沉内部的流场具有周期性,焊点使流体扰动增强,并形成射流和旋涡,起到了强化传热的效果。     

沼气增温与控制系统的设计与仿真

冬季北方寒冷地区温度偏低,难以满足大中型沼气厌氧发酵系统对于温度的要求。为了解决该问题,针对天津地区某奶牛场沼气工程,设计了一套回收发电机余热并辅助电加热为发酵罐体供热的沼气增温控制系统,且实验确定最佳控制温度为35℃。在该系统中,罐体内部均匀布置竖直型循环加热管路,从而使料液温度分布更加均匀,热响应更加迅速,6 d左右即可将发酵罐内发酵料液提升到所需最佳温度;另外,采用罐内部温度及循环水流量的反馈调节,使料液的温度波动维持在±1℃范围内,解决了在冬季由于温度过低而导致沼气产气率偏低、甚至停滞的问题;同时,采用MATLAB软件对基于F-PID及传统PID的温度控制系统进行了仿真。对比结果表明,F-PID控制器较传统PID控制器超调量减小3℃,响应时间缩短60%,表明F-PID系统具有更高的效率、稳定性及实用价值。     

聚氨酯泡沫材料阴燃发展过程的特性分析

分析对比了相同加热条件下的聚氨酯泡沫材料在有氧和无氧气氛下的升温过程,并对不同加热条件下的聚氨酯泡沫材料的阴燃传播速度进行研究.结果表明:沿着反应进行的方向,分离点的温度越来越低,不同热流条件下的温度分离曲线斜率在实验稳定发展段的变化规律表现得很相似,并在分离点出现后,有氧气氛中的该位置温度在短时间内急剧上升;在阴燃不稳定传播阶段时,热解前锋的速度小于氧化前锋的速度,在稳定传播阶段时,热解前锋速度与氧化前锋速度近乎相等.     

沈阳市地铁疏干水的利用探析

针对沈阳市地铁疏干水利用的现状,综合考虑沈阳市的实际情况,总结出地铁疏干水利用的几种方法,主要包括作为运河、湖泊的补换水源,用于修复、重建湿地,农业灌溉用水以及作为水源热泵的水源等。提出沈阳市地铁疏干水利用的指导思想和法律保障。     

复合填料热传导过程数值模拟

复合填料由废铸砂、粉煤灰、聚苯乙烯(EPS)颗粒、水泥和水按一定质量比例混合制成,具有低导热性、抗冻胀和轻质特性。根据热阻力法则和比等效导热系数相等法则,将材料视为由大量正方形单元体组成,其中心为一个球形EPS颗粒,这种单元体与总体的导热系数相等。运用AN SY S软件对复合填料单元体的传热过程进行了有限元模拟,根据瞬态法导热系数测试原理,推求不同EPS掺入比情况下的复合填料导热系数,分析EPS颗粒与导热系数的关系,发现材料导热系数随着EPS掺入比的增加而快速降低。将材料导热系数数值模拟与实测结果作比较,发现有限元模拟值与实测值接近,说明采用有限元方法可以实现对材料传热过程的模拟。     

Heat as emergency,heat as chronic stress: policy and institutional responses to vulnerability to extreme heat

Increasingly commonplace in cities, extreme heat events introduce multi-stress vulnerability, affecting people’s health and well-being, financial situation, mobility, social relations, and access to basic services. Planning to reduce heat vulnerability has become part of government business and to some extent community-level responses, cutting across a number of sectors including public health, emergency management, social services, critical infrastructure, and housing. This planning is often framed around heat as an emergency, focusing on preventing loss of life and severe health impacts, yet a vulnerability perspective also draws attention to the chronic and persistent impacts of heat. Our research, based on interviews and desktop research in Melbourne, Australia, found tensions between addressing heat as an emergency and heat as a source of chronic stress, with emergency responses taking precedence over responses addressing the chronic dimensions of heat. Each approach results in different but nonetheless related programmatic priorities for reducing vulnerability. In complex institutional settings, improving relations between policy and programme managers, non-government organisations, and vulnerable people themselves would enable the multiple stresses associated with extreme heat to be more effectively addressed. Policy and institutional responses that better appreciate the interconnections between the emergency and chronic aspects of heat would likely reduce vulnerability and contribute to more just approaches to urban sustainability.