有风情况池火灾热辐射下的最小安全距离

防火间距是石油化工企业平面设计中的一个重要参数,开放环境下的火灾热辐射受大气稳定程度的影响.本文从计算流体力学角度出发,应用CFD(Computationsl Fluid Dynamics)软件Fluent,基于SCI爆炸火灾工程试验"Pool Fire A"的大气条件,对"有风情况下,直径为10 m的苯液池火灾"进行数值模拟,得出非绝热条件下,苯燃烧的峰温以及产物组分、池火灾对周围环境热辐射的空间分布.温度最高点在对称面y=0上,最高温度为1 478 K、火焰倾斜角度为32°(与竖直方向的夹角)、火焰高10.2 m.对于锰钢材料、内径为10 m苯储罐,2～3级风力情况下,相邻两储罐间最小安全距离在上风向为20 m,下风向为27 m.最后对模拟结果进行了分析.     

喷淋塔内气液流场模拟

以实际建设中的燃煤机组为参考原型,使用数值模拟方法对于喷淋塔烟气流场进行了模拟分析.模拟结果表明,两入口塔入口不易积垢,流场均匀度也好于传统吸收塔.     

垃圾填埋场渗滤液运移规律分析与模拟

基于多孔介质流体力学、多相流以及土壤水动力学理论,利用理论分析和数值模拟相结合的方法,研究了垃圾填埋场中渗滤液运移过程的基本规律,并对填埋场底部可渗和不可渗2种情况下渗滤液的运移规律进行了模拟比对,研究成果可为填埋场渗滤液控制系统的设计和管理提供科学的理论依据和技术支持。     

CFD simulation of MSW combustion and SNCR in a commercial incinerator

A CFD scheme was presented for modeling municipal solid waste (MSW) combustion in a moving-grate incinerator, including the in-bed burning of solid wastes, the out-of-bed burnout of gaseous volatiles, and the selective non-catalytic reduction (SNCR) process between urea (CO(NH₂)₂) and NO_x. The in-bed calculations provided 2-D profiles of the gas–solid temperatures and the gas species concentrations along the bed length, which were then used as inlet conditions for the out-of-bed computations. The over-bed simulations provided the profiles of incident radiation heat flux on the top of bed. A 3-dimensional benchmark simulation was conducted with a 750 t/day commercial incinerator using the present coupling scheme incorporating with a reduced SNCR reduction mechanism. Numerical tests were performed to investigate the effects of operating parameters such as injection position, injection speed and the normalized stoichiometric ratio (NSR) on the SNCR performance. The simulation results showed that the distributions of gas velocity, temperature and NO_x concentration were highly non-uniform, which made the injection position one of the most sensitive operating parameters influencing the SNCR performance of moving grate incinerators. The simulation results also showed that multi-layer injections were needed to meet the EU2000 standard, and a NSR 1.5 was suggested as a compromise of a satisfactory NO_x reduction and reasonable NH₃ slip rates. This work provided useful guides to the design and operation of SNCR process in moving-grate incinerators.     

利用计算流体动力学(CFD)方法研究电收尘器斜向气流分布

在讨论了电收尘器电场内气流分布对除尘效率影响的基础上,介绍有效降低粉尘返流损失,提高电收尘效率的斜向气流技术,进而利用CFD方法对电场内的气流分布进行数值模拟,给出了在电场内实现斜向气流分布时气流分布板结构调整方法和参数。     

城市街谷与上游阻挡建筑最不利间距的研究

采用数值模拟的方法,研究了街谷内上风建筑与上游阻挡建筑的间距（D）,即上游建筑间距,对街谷内空气流动特性和气态污染物分布规律的影响.模拟结果表明,街谷内迎风区的气流速度基本不随D的变化而变化,而背风区和中心区的气流速度随着D的增加呈现先减小后增大的趋势,并在D=90m时,气流速度达到最小值.相应地,在D=90m时街谷内污染物浓度最高,表明D存在最不利值,在城市规划中应尽可能避免该间距.当D大于90m时,D越大,污染物浓度越低,而D小于90m时,D越小,污染物浓度也越低,可以同时实现节约用地和减小交通污染的目的.     

大型气候实验室气流组织仿真分析

目的对大型气候实验室气流组织进行仿真分析,获得合理的气流组织设计方案。方法首先通过分析旋流风口的特性,建立旋流风口CFD简化模型,然后设计大型气候实验室气流组织形式,最后对极端低温和极端高温工况下不同温度、送风量和送风角度时的气流组织进行CFD仿真分析。结果低温工况时,地面温度升高将导致室内温度和温度不均匀度整体上升;高温工况时,气流难以抵达地面,且地面温度对高度5 m以下区域有显著影响,对5 m以上空间影响不显著,应增大送风角度,使送风射流方向尽可能向下,以改善地面附近温度均匀性。结论气流组织仿真分析方法和气流组织设计方案适用于大型气候实验室设计。     

低磷浓度下鸟粪石结晶成粒及反应器流态模拟

为扩大鸟粪石(MAP)结晶成粒技术的应用范围,对低磷浓度下MAP成粒最优条件进行了研究.试验得出该技术应用的磷浓度应大于50mg/L,并在此基础上研究得到低磷浓度条件下MAP结晶成粒的最佳条件:pH 9.0,磷氮物质的量比1:8.此时生成的MAP平均粒径为0.56mm,总体积生长率为4.95cm³/h,纯度可达99.9%.为进一步优化流化床反应器中MAP成粒条件,利用CFD商用软件(Fluent 6.3)对反应器流态进行了模拟.结果表明:MAP流化床反应器的生长区能够形成明显的自下而上的水力分级,截面流速也较为均匀,有利于颗粒的生成,但沉淀区和进水区存在死区、涡流等不利条件.因此,有必要改进生长区和沉淀区的连接方式以及进水管的分布,以获得更为优质的MAP颗粒.     

CFD Prediction of Air Quality in the Area between Two City Vehicular Tunnels Considering Moving Cars

Concentration fields of different pollutants that spread outside two roadtunnels predicted with a CFD code will be presented. The solution domain represents the city area located between two tunnel outlets – tunnel Strahov and tunnel Mrazovka in Prague. The vicinity of both tunnels is a heavily built up area with tall buildings forming typical street canyons. The CFD modelling predicts the situation after the tunnel Mrazovka will be finished and traffic will increase considerably between both tunnels. Namely, an interest was given to the prediction of dispersion of emissions leaving both tunnel and the area touched by the traffic. For the CFD predictions, a method previously developed for moving vehicles was used. The method uses combination of Eulerian and Lagrangian approaches to moving objects and is capable of modeling different speeds and traffic rates of cars as well as traffic-induced turbulence. Influence of several meteorological parameters was studied, namely wind speed and direction and traffic parameters, like traffic rates and speed of cars. The method separates contributions from different sources to the total concentration field, namely from background, tunnel outlet and roadway. Results are presented in the form of horizontal and vertical concentration fields of NO_x.     

基于CFD的内构件强化内循环流化床流场结构分析

针对流化床内部流体结构的复杂性和缺乏有效放大设计理论的问题,以漏斗型导流内构件强化的内循环流化床的气液运动为研究对象,利用欧拉-欧拉双流体模型构建了能描述其复杂流动的CFD数学模型,通过宏观流场、气含率分布、液体速度分布解析内构件对气液混合传质的作用原理.数值模拟结果表明:双流体模型能较好地揭示流化床内气液流场结构,流...