Transient analysis of an advanced static var compensator using quad-series voltage-source PAM inverters

This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains.     

Fabrication of blue-light emission fused-silica substrates by using Si-ion implantation and high-temperature annealing

We fabricated fused-silica substrates which emit blue light by using Si-ion implantation and high-temperature annealing. Photoluminescence peak wavelengths are around 400 nm, and the peak intensities can be remarkable after annealing above 1150 °C.     

Novel Constitutive Equation for Predicting Dynamic Recrystallization During Hot Working Considering the Efficiency of Power Dissipation

The efficiency of power dissipation (η) in a dynamic material model has been conventionally used for qualitative predictions to estimate the hot working conditions at which dynamic recrystallization (DRX) is dominant. However, predicting the quantitative value of the DRX fraction (X_DRX) from η remains a challenge. In this paper, a constitutive equation is proposed to quantitatively predict X_DRX using η. The proposed equation for describing X_DRX is derived from the reaction rate equation using the assumption that the DRX rate depends on η. The proposed equation is verified via hot compression tests of equiaxed Ti–6Al–4V ELI alloys (Ti-64) in the (α + β) region. The predicted and experimental X_DRX values are found to be generally consistent with one another, exhibiting an average absolute error of 0.05. Furthermore, the proposed equation provides the same level of prediction accuracy as the conventional Johnson–Mehl–Avrami–Kolmogorov (JMAK) equation. Therefore, the proposed equation can be used to quantitatively predict X_DRX following hot compression tests of equiaxed Ti-64. Moreover, compared with the JMAK equation, the proposed equation is expressed in fewer parameters and constant terms. It is, thus, expected to facilitate the quantitative prediction of X_DRX.

     

Extraction and implementation of muscle synergies in neuro-mechanical control of upper limb movement

This work faces the redundancy problem, a central concern in robotics, in a particular force-producing task by using muscle synergies to simplify the control. We extracted muscle synergies from human electromyograph signals and interpreted the physical meaning of the identified muscle synergies. Based on the human analysis results, we hypothesized a novel control framework that can explain the mechanism of the human motor control. The framework was tested in controlling a pneumatic-driven robotic arm to perform a reaching task. This control method, which uses only two synergies as manipulated variables for driving antagonistic pneumatic artificial muscles to generate desired movements, would be useful to deal with the redundancy problem; thus, suggesting a simple but efficient control for human-like robots to work safely and compliantly with humans.     

Fractionation and enrichment of CLA isomers by selective esterification with Candida rugosa lipase

A commercial product of CLA contains almost equal amounts of cis-9,trans-11 (c9,t11)-CLA and trans-10,cis-12 (t10,c12)-CLA. We attempted to enrich the two isomers by a two-step selective esterification using Candida rugosa lipase that acted on c9,t11-CLA more strongly than on t10,c12-CLA. An FFA mixture containing CLA isomers was esterified with an equimolar amount of lauryl alcohol in a mixture of 20% water and the lipase. When the esterification of total FA reached 50%, two isomers were fractionated in a good yield: t10,c12-CLA was enriched in FFA, and c9,t11-CLA was recovered in lauryl esters. The FFA were esterified again to enrich t10,c12-CLA. At 27.3% esterification of total FA, the t10,c12-CLA content in FFA increased to 64.8 wt% with 89.3% recovery: The ratio of the content of t10,c12-CLA to that of two isomers was 95.9%. Lauryl esters obtained by the single esterification were employed for enrichment of c9,t11-CLA. After the esters were hydrolyzed, the resulting FFA were esterified again with lauryl alcohol. At 62.0% esterification of total FA, the c9,t11-CLA content in lauryl esters increased to 73.3 wt% with 79.4% recovery: The ratio of the content of c9,t11-CLA to that of two isomers was 95.6%. In a 600-g-scale purification, molecular distillation was effective in separating the reaction mixture into lauryl alcohol, FFA, and lauryl ester fractions.     

Effect of reaction kinetics of polymer electrolyte on the ion‐conductive behavior for poly(oligo oxyethylene methacrylate)–LiTFSI mixtures

The effect of the reaction kinetics on the ionic conductivity for a comblike‐type polyether (MEO) electrolyte with lithium bis(trifluoromethane sulfonyl)imide (LiTFSI) was characterized by DSC, complex impedance measurements, and ¹H pulse NMR spectroscopy. The ionic conductivity of these electrolytes was affected by the reaction condition of the methacrylate monomer and revealed by the glass transition temperature (T_g), spin–spin relaxation time (T₂), steric effects of the terminal groups, and the number of charge carriers indicated by the VTF kinetic parameter. In this system, the electrolytes prepared by the reaction heating rate of 10°C/min of MEO–H and 15°C/min of MEO–CH₃ showed maximum ionic conductivity, σ_i, two to three times higher in magnitude than that of the σ_i of the others at room temperature. As experimental results, the reaction kinetic rate affected the degree of conversion, the ionic conductivity, and the relaxation behaviors of polyether electrolytes. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 2149–2156, 2003     

Decomposition of Carbon Dioxide to Carbon with Active Wustite at 300°C

Active wustite (FeδO, with a δ value of 0.98) was prepared by keeping normal wustite (δ value of 0.94) in a N₂ atmosphere at 300°C for 10 min. This reaction is given by (4δ₂–3)Fe_δ1O→(4δ₁–3)Fe_δ2O + (δ₂–δ₁)Fe₃O₄ where δ₁= 0.94 and δ₂= 0.98. The equation indicates that the normal wustite undergoes eutectoid decomposition into active wustite and stoichiometric magnetite (Fe₃O₄). Carbon dioxide (1.013 × 10⁵ Pa) was almost completely (100%) decomposed into carbon (zero valence) by the active wustite at the low temperature of 300°C, which was associated with the transformation of the active wustite into the stoichiometric magnetite. The internal pressure of the reaction cell eventually became a vacuum.     

Decomposition of CO2 and CO into carbon with active wüstite prepared from Zn(II)-bearing ferrite

CO₂ decomposition reaction into carbon was studied at 300 °C using the H₂-reduced Zn(II)-bearing ferrite which consisted of the Zn(II) oxide and the active wüstite. The H₂-reduced Zn(II)-bearing ferrite was prepared from Zn(II)-bearing ferrite by the reduction with H₂ gas at 300 °C. The wüstite (FeO) in the H₂-reduced Zn(II)-bearing ferrite had a higher value (=0.97, active wüstite) than those of the normal wüstites (0.90<<0.95) prepared at high temperatures (>570 °C). The decomposition reaction of CO₂ proceeds in two steps: (1) CO₂ reduction to CO, and (2) CO decomposition into carbon. In the initial stage, the reduction of CO₂ into CO takes place, accompanying both the oxidation of the active wüstite to the slightly oxidized wüstite, and the transformation of active wüstite and Zn(II) oxide into the Zn(II)-bearing ferrite. After the reaction of the initial stage attains equilibrium of an apparent state of rest, the adsorbed CO is decomposed into carbon, associated with the transformation of the slightly oxidized wüstite and the Zn(II) oxide into the Zn(II)-bearing ferrite.     

Comparison of land surface emissivity and radiometric temperature derived from MODIS and ASTER sensors

This study compared surface emissivity and radiometric temperature retrievals derived from data collected with the MODerate resolution Imaging Spectroradiometer (MODIS) and Advanced Spaceborne Thermal Emission Reflection Radiometer (ASTER) sensors, onboard the NASA's Earth Observation System (EOS)-TERRA satellite. Two study sites were selected: a semi-arid area located in northern Chihuahuan desert, USA, and a Savannah landscape located in central Africa. Atmospheric corrections were performed using the MODTRAN 4 atmospheric radiative transfer code along with atmospheric profiles generated by the National Center for Environmental Predictions (NCEP). Atmospheric radiative properties were derived from MODTRAN 4 calculations according to the sensor swaths, which yielded different strategies from one sensor to the other. The MODIS estimates were then computed using a designed Temperature-Independent Spectral Indices of Emissivity (TISIE) method. The ASTER estimates were derived using the Temperature Emissivity Separation (TES) algorithm. The MODIS and ASTER radiometric temperature retrievals were in good agreement when the atmospheric corrections were similar, with differences lower than 0.9 K. The emissivity estimates were compared for MODIS/ASTER matching bands at 8.5 and 11 μm. It was shown that the retrievals agreed well, with RMSD ranging from 0.005 to 0.015, and biases ranging from −0.01 to 0.005. At 8.5 μm, the ranges of emissivities from both sensors were very similar. At 11 μm, however, the ranges of MODIS values were broader than those of the ASTER estimates. The larger MODIS values were ascribed to the gray body problem of the TES algorithm, whereas the lower MODIS values were not consistent with field references. Finally, we assessed the combined effects of spatial variability and sensor resolution. It was shown that for the study areas we considered, these effects were not critical.     

Elevated Expression of CCN3 in Articular Cartilage Induces Osteoarthritis in Hip Joints Irrespective of Age and Weight Bearing

Osteoarthritis (OA) occurs not only in the knee but also in peripheral joints throughout the whole body. Previously, we have shown that the expression of cellular communication network factor 3 (CCN3), a matricellular protein, increases with age in knee articular cartilage, and the misexpression of CCN3 in cartilage induces senescence-associated secretory phenotype (SASP) factors, indicating that CCN3 promotes cartilage senescence. Here, we investigated the correlation between CCN3 expression and OA degenerative changes, principally in human femoral head cartilage. Human femoral heads obtained from patients who received total hip arthroplasty were categorized into OA and femoral neck fracture (normal) groups without significant age differences. Gene expression analysis of RNA obtained from femoral head cartilage revealed that CCN3 and MMP-13 expression in the non-weight-bearing part was significantly higher in the OA group than in the normal group, whereas the weight-bearing OA parts and normal cartilage showed no significant differences in the expression of these genes. The expression of COL10A1, however, was significantly higher in weight-bearing OA parts compared with normal weight-bearing parts, and was also higher in weight-bearing parts compared with non-weight-bearing parts in the OA group. In contrast, OA primary chondrocytes from weight-bearing parts showed higher expression of CCN3, p16, ADAMTS4, and IL-1β than chondrocytes from the corresponding normal group, and higher ADAMTS4 and IL-1β in the non-weight-bearing part compared with the corresponding normal group. Acan expression was significantly lower in the non-weight-bearing group in OA primary chondrocytes than in the corresponding normal chondrocytes. The expression level of CCN3 did not show significant differences between the weight-bearing part and non-weight-bearing part in both OA and normal primary chondrocytes. Immunohistochemical analysis showed accumulated CCN3 and aggrecan neoepitope staining in both the weight-bearing part and non-weight-bearing part in the OA group compared with the normal group. The CCN3 expression level in cartilage had a positive correlation with the Mankin score. X-ray analysis of cartilage-specific CCN3 overexpression mice (Tg) revealed deformation of the femoral and humeral head in the early stage, and immunohistochemical analysis showed accumulated aggrecan neoepitope staining as well as CCN3 staining and the roughening of the joint surface in Tg femoral and humeral heads. Primary chondrocytes from the Tg femoral head showed enhanced expression of Ccn3, Adamts5, p16, Il-6, and Tnfα, and decreased expression of Col2a1 and -an. These findings indicate a correlation between OA degenerative changes and the expression of CCN3, irrespective of age and mechanical loading. Furthermore, the Mankin score indicates that the expression level of Ccn3 correlates with the progression of OA.