Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Radiation detector made of a high-quality polycrystalline diamond

Radiation detector was made of a high-quality CVD polycrystalline diamond composed of frost column like structure diamond grains, and induced charge distribution spectra and drift velocities were measured by using alpha particles. As a result, the CVD polycrystalline achieved maximum induced charge of 83% of HP/HT type IIa diamond. Moreover, the CVD crystal had lower charge loss on electrons compared with the HP/HT type IIa diamond. Drift velocities of electrons and holes were v_e = 7.7 × 10⁴ and v_h = 7.3 × 10⁴cm/s at an electric field of 20 kV/cm, respectively. In addition, response function measurement for 14 MeV neutrons was carried out.     

A non-specific lipid transfer protein from Arabidopsis is a cell wall protein

Lipid transfer proteins (LTPs), mediate the transfer of phospholipids between membranes in vitro. However, the in vivo function of LTPs is not known. To determine the precise location of a non-specific LTP from Arabidopsis, a cDNA clone was used to produce an Arabidopsis LTP:protein A fusion. Antibodies raised against the fusion were used to localize the Arabidopsis LTP by immunoelectron microscopy. LTP was found to be located in the cell wall, mainly in epidermal cells. This location appears to be inconsistent with the proposed role of the protein in intracellular lipid transfer.     

Analysis of brushless three-phase synchronous generator without exciter

Recently, a demand for small-capacity generators has been increasing as electric sources in small ships and automobiles or as portable electric sources driven by engines. It is desired that the structure of small-capacity generators be simple and robust, and that the generators be highly reliable, easily maintained and controlled. This paper describes an analysis of the original brushless synchronous generator without exciter. The output voltage can be adjusted in the wide range by controlling the stator dc current. To analyze the characteristics of this generator, the finite element method is applied. It is found that the results of theoretical analysis agree well with the experimental results.     

Metabolism of tetramethrin isomers in rat: II. Identification and quantitation of metabolites

1. To examine the metabolic fate of (1RS, trans)- or (1RS, cis)-tetramethrin [3, 4, 5, 6-tetrahydrophthalimidomethyl (1RS, trans)- or (1RS, cis)-chrysanthemate], rat was administered a single oral dose of trans- or cis-[alcohol-14C]tetramethrin at dose levels of 2 or 250 mg/kg. 2. The radiocarbon was almost completely eliminated from rat within 7 days after administration in all groups. 14C-recoveries (expressed as percentages relative to the dosed 14C) in faeces and urine were 38-58 and 42-58% respectively in rat administrated trans-[alcohol-14C]tetramethrin, and in faeces and urine were 66-91 and 9-31% respectively in rat administered cis-[alcohol-14C]tetramethrin. 3. Fourteen metabolites found in excreta were purified by using several chromatographic techniques and identified by spectroanalyses (nmr and MS). Five sulphonate derivatives and three dicarboxylic acid derivatives were found. 4. The main metabolites were sulphonate derivatives in the faeces, and in the urine, alcohols, dicarboxylic acid and reduced metabolites derived from the 3,4,5,6-tetrahydrophthalimide moiety.     

Simulation and experimental analyses of electromagnetic transients behaviors of lightning surge on vertical conductors

Simulation of very fast surge phenomena in a three-dimensional (3-D) structure requires a method based on Maxwell's equations, such as the finite-difference time-domain (FDTD) method or the method of moments, because circuit-equation-based methods cannot handle the phenomena. This paper uses a method of thin-wire representation of the vertical conductor system for the FDTD method which is suitable for the 3-D surge simulation. The thin-wire representation is indispensable to simulate electromagnetic surges on wires or steel frames in which the radius is smaller than a discretized space step used in the FDTD simulation. In this paper, a general surge analysis program named the virtual surge test lab based on the Maxwell's equations formulated by the FDTD method, is used to simulate the surge phenomena of a vertical conductor, including the effects of horizontal wave incidence and vertical wave incidence. Experimental results on the reduced scale model have been presented in order to compare among the simulation results by the FDTD method and the results using numerical electromagnetic code based on the MoM.     

Successive overrelaxation method with projection for finite element solutions of nonlinear radiation cooling problems

In this paper, we consider the successive overrelaxation method with projection for obtaining the finite element solutions under the nonlinear radiation boundary conditions. In particular we establish the convergence of the successive overrelaxation method with projection. Some numerical results are also given to illustrate the usefulness.     

Recent developments of high-performance NEOMAX magnets

For further improvement in achieving extremely high magnetic properties of Nd- Fe- B sintered magnets, extensive investigation has been done to densify the magnet up to the theoretical value, to increase the volume fraction of the Nd ₂Fe₁₄B matrix phase, and to achieve a high degree of alignment. By controlling chemical composition and the amount of constituent phases,improving particle size distribution, and adopting the isostatic pressing method to get better alignment of fine particles, we have succeeded in obtaining a high-performance magnet having residual flux density (B_r) of 1.495 T (14.95 kG), maximum energy product [(BH)_max] of 431 kj/m³ (54.2 MGOe), and intrinsic coercivity (iH_c) of 845 kA/m (10.62 kOe).     

Change of characteristics of desulfurization and denitrification by combustion flue gas composition and electrode configuration under pulsed corona discharge

Laboratory-scale and parametric experiments of SO₂ and NO_x removal from the simulated combustion gas by pulsed corona discharge have been performed by changing the combustion gas composition and temperature, the electrode configuration of plasma reactor, and the polarity of high-voltage electrode. The following results are obtained: 1) the higher the concentration of H₂O and O₂, the higher the efficiency of desulfurization and denitrification at the same specific input; 2) the pulsed corona discharge with a voltage pulsewidth as short as 200 ns of negative polarity shows the possibility to attain almost 90 percent deSO_x and deNO_x efficiency at the specific discharge input of 20 J/g, which is almost the same as the specific input in the electron-beam process; 3) the deNO_x characteristics show a little temperature dependence in the range of 70 to 130°C, but the deSO_x efficiency increases rapidly in the temperature region below 100°C suggesting the thermochemical dependence of deSO_x reaction; 4) when desulfurization and denitrification proceed, the white dendritic powder deposits on the plasma reactor whose composition is identified to be 49 mol% (NH₄)₂SO₄ and 47 mol% of 2NH₄NO₃ · (NH₄)₂SO₄, and the ratio of SO₂, NO and NH₃ of the deposit is almost equal to that of supplied gas.