Mathematical modeling of falling liquid film evaporation process

A mathematical model of evaporation process from a laminar falling liquid film on a vertical plate of constant temperature is presented. The model is developed with and without interfacial shear stress due to the vapor flow at the liquid film surface. The vapor pressure drop, vapor exit velocity and cooling rate are calculated for different liquid mass flow values. It is shown that lower liquid mass flow produces higher cooling rate. The results also show that the interfacial shear stress has a considerable negative effect on the cooling rate. It is proved that there exists an optimum distance between the plates, which gives the maximum volumetric cooling rate.     

Heat and Mass Transfer Analogy Studies of Binary Liquid Mixture in Comparison with Eteanol-n-Heptane Evaporating to Air

An expenmental and theoretical study of heat and mass transfer analogy and a comparison of that to a binary liquid mixture evaporation is presented. Common organic solvents, ethanol and n-heptane, were used to form an alcohol - hydrocarbon mixture. Studies were carried out in a horizontal rectangular channel having air flow velocities of 0.2 - 0.9 m/s. Heat transfer coefficients were measured with a copper plate resistor and mass transfer coefficients with a square pool. The heat and mass transfer analogy is presented for a system having two evaporating compounds with a fixed value of air flow and verified by measuring and comparing mass transfer coefficients for distilled water with air flow velocities of 0.2 - 0.9 mls. An illustrative example of the use of the theory for industrial ventilation is presented.     

Towards computer game studies

It is relatively stress-free to write about computer games as nothing too much has been said yet, and almost anything goes. The situation is pretty much the same when it comes to writing about games and gaming in general. The sad fact with alarming cumulative consequences is that they are under-theorized; there are Huizinga, Caillois and Ehrmann of course, and libraries full of board game studies,in addition to game theory and bits and pieces of philosophy – most notably those of Wittgenstein – but they won't get us very far with computer games. So if there already is or soon will be a legitimate field for computer game studies, this field is also very open to intrusions and colonisations from the already organized scholarly tribes. Resisting and beating them is the goal of our first survival game in this paper, as what these emerging studies need is independence, or at least relative independence.     

Modelling of the lignin peroxidase LIII of Phlebia radiata: use of a sequence template generated from a 3-D structure

A model of the lignin peroxidase LIII of Phlebia radiata wasconstructed on the basis of the structure of cytochrome c peroxidase(CCP). Because of the low percentage of amino acid identitybetween the CCP and the lignin peroxidase LIII of Phlebia radiata,alignment of the sequences was based on the generation of atemplate from a knowledge of the 3-D structure of CCP and consensussequences of lignin peroxidases. This approach gave an alignmentin which all the insertions in the lignin peroxidase were placedat loop regions of CCP, with a 21.1% identity for these twoproteins. The model was constructed using this alignment andthe computer program COMPOSER, which assembles the model asa series of rigid fragments derived from CCP and other proteins.Manual intervention was required for some of the longer loopregions. The -helices forming the structural framework, andespecially the haem environment of CCP, are conserved in theLIII model and the core is close packed without holes. A possiblesite of the substrate oxidation at the haem edge of LIII isdiscussed.     

On exponential convergence and robustness of least-squares identification

Robustness and convergence properties of exponentially weighted least-squares identification are studied. It is shown that exponential convergence in the noiseless case can be obtained for a class of increasing or decreasing regression vectors. The rate of change of the limits in the regressors affect the convergence rates, which are explicitly given. It is demonstrated that for a sub-class of regressors decreasing-in-the-norm exponential convergence without the noise does not guarantee robustness subject to a bounded noise. Instead, exponential divergence of the estimate is shown in a specific case.     

Studies on compatibilization of blends of polypropylene and a thermotropic liquid crystalline polymer

Thermotropic liquid crystalline polymers, LCPs, are frequently blended with thermoplastics to achieve an in situ composite structure. Significant mechanical reinforcement is obtained for the matrix polymer in the direction of the LCP fibers, but the transversal properties are often inferior because of the incompatibility of the components. Blends of LCP with polypropylene, and with three related matrix polymers, and PP/LCP blends with added potential compatibilizers were prepared and studied for their mechanical properties and morphology. A notable improvement in impact strength was achieved when a small amount of ethylene-based terpolymer was added as compatibilizer. © 1993 John Wiley & Sons, Inc.     

Excitation energy-dependent nature of Raman scattering spectrum in GaInNAs/GaAs quantum well structures

The excitation energy-dependent nature of Raman scattering spectrum, vibration, electronic or both, has been studied using different excitation sources on as-grown and annealed n- and p-type modulation-doped Ga_1 − xIn_xN_yAs_1 − y/GaAs quantum well structures. The samples were grown by molecular beam technique with different N concentrations (y = 0%, 0.9%, 1.2%, 1.7%) at the same In concentration of 32%. Micro-Raman measurements have been carried out using 532 and 758 nm lines of diode lasers, and the 1064 nm line of the Nd-YAG laser has been used for Fourier transform-Raman scattering measurements. Raman scattering measurements with different excitation sources have revealed that the excitation energy is the decisive mechanism on the nature of the Raman scattering spectrum. When the excitation energy is close to the electronic band gap energy of any constituent semiconductor materials in the sample, electronic transition dominates the spectrum, leading to a very broad peak. In the condition that the excitation energy is much higher than the band gap energy, only vibrational modes contribute to the Raman scattering spectrum of the samples. Line shapes of the Raman scattering spectrum with the 785 and 1064 nm lines of lasers have been observed to be very broad peaks, whose absolute peak energy values are in good agreement with the ones obtained from photoluminescence measurements. On the other hand, Raman scattering spectrum with the 532 nm line has exhibited only vibrational modes. As a complementary tool of Raman scattering measurements with the excitation source of 532 nm, which shows weak vibrational transitions, attenuated total reflectance infrared spectroscopy has been also carried out. The results exhibited that the nature of the Raman scattering spectrum is strongly excitation energy-dependent, and with suitable excitation energy, electronic and/or vibrational transitions can be investigated.     

The use of (green field) biomass pretreatment liquor for fermentative butanol production and the catalytic oxidation of biobutanol

In this study, pretreatment liquor of acid-stored green and yellowish barley silage was used for fermentative acetone–butanol–ethanol (ABE) production. Further, the catalytic oxidation of biobutanol over Pt catalysts was studied to investigate the behaviour of butanol as a fuel in the combustion engine. After the hydrothermal treatment of green and yellowish barley silage followed by enzymatic hydrolysis, approximately 88% and 100% of the available sugars were recovered, respectively. Batch fermentations of pretreatment barley silage liquor, supplemented with gelatinised barley grain, showed good fermentability with total ABE concentrations of 9.0 g/L and 10.9 g/L. Butanol yields of 0.20, 0.17 and ABE yields of 0.28, 0.26 (g/g monosaccharide) were obtained, respectively. In catalytic activity measurements, the conversion of biobutanol became appreciable in the 120–140 °C range, whereas conversions greater than 95% were obtained over 200 °C. Selectivities were also high, although formation of by-products, such as butyraldehyde, was observed.     

Titania and titania-silver nanoparticle deposits made by Liquid Flame Spray and their functionality as photocatalyst for organic- and biofilm removal

Titania and titania-silver nanoparticle deposits were made by Liquid Flame Spray technique, in which the liquid precursor is injected into a high temperature flame, where it will evaporate and nucleate to nanosize particles. One-step and two-step methods were used for preparation of titania-silver deposits. The amount of silver added was 1 wt%. The deposits were collected in the flame zone on steel and glass surfaces and were analyzed by TEM, EDS, XPS and SAXS. The titania deposits consisted of porous nanosized titania agglomerates of primary particles (~10 nm). With silver addition, small spherical silver metal particles (~2 nm) were detected on the agglomerates. An increase in the photocatalytic activity was verified by stearic acid decomposition and biofilm removal using Deinococcus geothermalis as the model organism.