Right atrial contractile performance in patients with myocardial infarction

To evaluate right atrial (RA) contractile performance in patients with myocardial infarction, we validated a cineangiographic method of RA volume measurement, and investigated RA volume change in 'normal' individuals and patients with a previous myocardial infarction. Sixteen silicone rubber RA casts made from human cadavers were filmed in the postero-anterior and left lateral projections. The cast volumes calculated following Simpson's rule were in good agreement with those measured by water replacement (r = 0.992, P < 0.01). At cardiac catheterization, biplane RA cineangiography was performed in 19 'normal' individuals (N group), in 14 patients with a previous antero-septal infarction (AMI group) and in seven patients with a previous inferior infarction (IMI group). The RA volume-time curve was constructed at 20-40 ms intervals for one cardiac cycle. RA volume at the beginning of the atrial contraction (RAVd), which was defined as the 'preload' of the RA, tended to be larger in both the AMI and IMI groups compared with 'normal' individuals. The RA ejection volume was significantly larger in both the AMI (18.4 +/- 2.1 ml.m-2, P < 0.01) and IMI groups (19.4 +/- 2.8, P < 0.01) than in the N group (14.5 +/- 1.9), even for a comparable level of RAVd (range from 26 to 36 ml.m-2) (18.6 +/- 2.1, P < 0.01, 18.2 +/- 2.0, P < 0.01, 14.7 +/- 1.9, respectively). These results suggest that RA contraction increases in patients with myocardial infarction by increasing both the 'preload' and 'contractility' of the RA.     

A feasibility study of a direct-mapping parallel processing method to solve linear equations in load-flow calculation

With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix.     

Forensic toxicological application of TOXI-LAB screening for biological specimens in autopsy cases and emergency cares

Using the TOXI-LAB drug detection system, emergency toxicological screening was performed in autopsy cases and emergency cares. In 280 autopsy cases (male 182 cases 65%, female 98 cases 35%), drug positive cases were 28 cases of male (15%) and 24 cases of female (24%). The age groups which showed higher rate of drug positive cases were 10s-40s in male (approximately 20%) and 20s in female (67%). In the 238 cases of emergency care (male 129 cases 54%, female 104 cases 44%, unknown 5 cases 2%), drugs were positive in 29 cases of male (22%) and 32 cases of female (30%). The age groups which showed relatively higher rate of drug positive cases were 40s in male (64%), 20s (71%) and 30s (89%) in female. Forty-four different kinds of drugs were detected in TOXI-LAB positive cases, in which the psychotropic drugs and the sedative-hypnotic drugs amounted to approximately 70%. Methamphetamine and amphetamine, which were the main abused drugs showing a socially important problem, were detected in total 15 cases. TOXI-LAB was based on thin-layer chromatography (TLC); however, from the extraction to development, coloration and detection have been accelerated (about 50 min) and simplified. In order to perform the forensic toxicological practice in Japan, it becomes more useful that TOXI-LAB is used in autopsy cases and emergency cares, if the drugs, which have caused poisoning cares in Japan, are added to TOXI-LAB. The present study describes the advantage and problem of TOXI-LAB drug detection system through demonstrating the practical cases of autopsy cases and emergency cares.     

Infrared sensing properties of positive temperature coefficient thermistors with large temperature coefficients of resistivity

Infrared (IR) detecting elements were prepared using positive temperature coefficient (PTC) thermistors with large temperature coefficients of resistivity (α). Their compositions were denoted as Ba_1−x Sr _x Nb_0.003Ti_0.997O₃ + 1 mol % TiO₂ + 0.07 mol %MnO (x=0, 0.2), and their temperature coefficients of resistivity were 78 and 50% K⁻¹, respectively. Their IR sensing properties were measured under the self-regulating heating conditions, and were compared with those of a detector with small α (18 % K⁻¹). It was shown that large α was effective for controlling the element temperature by self-regulating heating and for improving sensitivity. The responsivity,R _v of the element withx=0.2 was 980 VW⁻¹, and was as large as those of pyroelectric detectors. Expressions which normalize the sensitivity and the thermal time constant were derived. From these expressions, criteria for improving some IR sensing properties were obtained.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Correlates and prognosis in relation to intellectual dysfunction in a community-residing elderly population

To estimate the risk factors for intellectual dysfunction and examine its prognosis in a community-residing (non-institutionalized) elderly population, a randomly selected sample of 1,473 elderly people aged 65 years and over living in S city, Osaka Prefecture, was studied in October 1992, and data were obtained from 1,383, a response rate of 93.9%. A cohort of 1,383 was followed for 42 months and follow-up was completed for 1,300 (94.0%). The main results were as follows: 1) The prevalence of intellectual dysfunction did not differ significantly between sexes, and there was an increasing prevalence of intellectual dysfunction with age in both sexes. The prevalence of severe intellectual dysfunction was found to increase highly at age 85 and over. 2) By univariate analysis, odds ratios for age older than 75 years, low Activities of Daily Living (ADL), urinary and fecal incontinence, and no participation in social activities were significantly higher than 1 in any level of mild, moderate, and severe intellectual dysfunction. In the multivariate analysis using logistic regression, age older than 75 years and urinary and fecal incontinence showed significant higher odds ratios than 1 for severe intellectual dysfunction, and low ADL and treatment for hypertension also showed significant higher odds ratios than 1 for moderate intellectual dysfunction. 3) From analysis using the Kaplan-Meier method, the cumulative survival rates decreased with a decline in intellectual functioning in both age groups of 65-74 and 75 years and older. 4) Application of the Cox proportional hazards model resulted in adjusted hazard ratio for severe intellectual dysfunction of 1.79 (95% confidence interval, 1.02-3.12), controlling for other factors such as sex, age, general health status, incontinence and social activities.     

Interconnected power systems with superconducting magnetic energy storage

The objective of this work is to discuss the concept of back‐to‐back interconnection systems with energy storage, especially with a Superconducting Magnetic Energy Storage (SMES) incorporated into a back‐to‐back DC link. In this case, each converter of the back‐to‐back system is used as a power conditioning system for the SMES coils. Since the AC–DC converter can be designed independently of the frequency of the power system, a two‐way switch is connected to the AC side of each converter. This two‐way switch can select the interconnected power systems. By using the two‐way switches, this system can provide the stored energy in the SMES system to each interconnected power system through two AC–DC converters. For instance, lower‐cost power of each power network can be stored through two converters during the off‐peak hours and made available for dispatch to each power network during periods of demand peak. Then this system increases the reliability of electric power networks and enables the economical operations depending on the power demand. This paper describes the unique operations of the back‐to‐back interconnection with SMES and discuses the optimal SMES configuration for a 300‐MW‐class back‐to‐back interconnection. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(2): 37–43, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20482     

Mutations in the N-terminal globular domain of the type X collagen gene (COL10A1) in patients with Schmid metaphyseal chondrodysplasia

STATEMENT OF PROBLEM: Improved dental stone has been widely used for producing dies for the fabrication of restorations with the lost-wax technique. Improved dental stone is used for several reasons, but it is selected most often because of its reasonable cost, ease of use, and ability to produce consistent results. PURPOSE: This study evaluated the ability of an epoxy resin die material and a type IV dental stone to dimensionally reproduce a custom-fabricated metal die. MATERIAL AND METHODS: Dies were fabricated and measurements were made from three reference lines. Measurements were repeated three times for the master die and for the specimen dies. A mean measurement and percent relative change for each dimension was calculated. RESULTS: A significant difference in the relative change for die height was found between the groups studied (p < 0.003). CONCLUSIONS: This epoxy die system will provide a degree of dimensional accuracy comparable to gypsum when used with addition silicone impression material.     

Expert system for dispatch control in restoration of ehv power system after complete blackout

Present-day power systems operate with high reliability, and it is rare that a blackout will extend over an entire system swiftly and securely. This paper considers automatic power supply to loads after a complete blackout of a system. First, taking into account characteristics of generators, loads, and initial power sources, a method is proposed of allocating several generators to each load in parallel to the system and supplying power to the load sequentially. Second, to remove the imbalance between supply and demand of power, a method is proposed of adjusting the amount of supply and generation according to a present imbalance and the sum of past ones. Third, to automatically issue orders for start-up, parallel, follow-up, stand-by, and stoppage of generators, several rules for each power station are set and an expert system is made based on them. Finally, the expert system is applied to a model power system, and it is verified that it can restore loads without any trouble for a complete blackout which occur at any time of a day and in any restoration pattern.     

Analysis of polarization plane rotation characteristic in 2D photonic crystal waveguide with chiral medium by condensed node spatial network

Using the photonic band gap in photonic crystals, the fundamental waveguide structures for the light wavelength range have been developed. Based on the fine structure of these many functional devices have been proposed by analytical or numerical simulation methods and the experiments of trial manufacture. In this paper, the treatment of chiral dielectric in the Condensed Node Spatial Network for the vector potential is explained, and we show the polarization plane rotation property in air‐hole and pillar type photonic crystal waveguide structures with the chiral medium substrate. Then, we show the fundamental advantage of the air‐hole type photonic crystal waveguide structure in application to a mode converter. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 152(1): 7–14, 2005; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/eej.20098