Identification of the adverse effect of nitrate on the phosphate release rate and improvement of EBPR process models.

The adverse effect of nitrate on the phosphate release rate in the anaerobic phase was observed and was hardly explainable with conventional EBPR process models. Four possible mechanisms were proposed including substrate competition, reduced fermentation, parallel reaction and sequential reaction. Batch experiments were designed and conducted to identify the dominant mechanism. Results showed that the sequential reaction was the only possible mechanism where only denitrification occurred if any nitrate existed in the anaerobic phase. Then the phosphate release following after the nitrate was completely removed. Nitrate inhibition effect was added into the PHA storage rate to incorporate the sequential reaction in the conventional ASM3 plus EAWAG bio-P module (ASM3 + P). Nitrate inhibition coefficient, K(I,NO,PAO) was found to be as low as 0.05 mg/L. This correlated well with experimental observation where no also meant that the anaerobic compartment of a continuous flow reactor could be seriously affected by the residual nitrate contained in the sludge recycle flow. This phenomenon caused overestimation of the phosphate uptake rate and consequently underestimation of PO4(3-) -P concentration. This problem was resolved by incorporation of a nitrate inhibition term in the ASM3 + P for more accurate simulation of the EBPR process.     

Reducing cycle times in manufacturing and supply chains by input and service rate smoothing

A key performance parameter of a manufacturing network or supply chain is its cycle time; the time that a typical item spends in the network. A previous simulation study on a semiconductor assembly and test facility showed that cycle times could be reduced by having smooth input and service rates. This suggested that there is a “cycle time principle” that, for a system with a specified throughput or input rate, the shortest cycle times are obtained when the input and service rates do not vary over time. We prove that this principle is true for the M/G/1 and M/M/s queueing systems and Jackson networks. The analysis involves establishing several results on the concavity of waiting time probabilities and the convexity of expected waiting times and queue lengths, as functions of input and service rates. These results also have natural uses in other optimization problems.     

Effects of a K+ATP channel opener, lemakalim, on systemic, coronary and regional vascular dynamics in conscious dogs: comparison with nifedipine, adenosine, nitroglycerin and acetylcholine

The systemic, coronary and regional vascular responses to the K+ATP channel opener lemakalim were compared to other potent vasodilators (i.e., nifedipine, adenosine, nitroglycerin and acetylcholine). Experiments were performed in 12 conscious dogs 2 to 4 weeks after implantation of aortic catheters and flow probes on the ascending aorta, left circumflex coronary, celiac, mesenteric, renal and iliac arteries, and solid-state miniature pressure gauges in the left ventricular cavity. Dose-response curves induced by bolus injection (i.v.) were examined. For doses that reduced total peripheral resistance by 22%, lemakalim reduced celiac (-28 +/- 2%), mesenteric (-24 +/- 3%), renal (-17 +/- 3%) and iliac (-18 +/- 3%) vascular resistances (i.e., by amounts similar to those observed with the other vasodilators, except for adenosine, which increased renal resistance). At these doses, lemakalim induced a greater decrease (-52 +/- 3%) (P < .05) in coronary resistance, as compared with nifedipine (-35 +/- 3%), adenosine (-38 +/- 3%), nitroglycerin (-25 +/- 2%) and acetylcholine (-32 +/- 3%). However, when near maximal vasodilation was elicited, adenosine elicited the greatest (P < .05) decrease in coronary resistance (-81 +/- 1%), as compared with lemakalim (-74 +/- 2%), nifedipine (-67 +/- 2%), nitroglycerin (-63 +/- 2%) and acetylcholine (-72 +/- 1%). Both the time to maximal increases in regional blood flow and the time for recovery in all vascular beds were significantly prolonged for lemakalim compared with the other vasodilators. Thus, the K+ATP channel opener lemakalim dilates the coronary bed out of proportion to other vascular beds, is relatively more potent at lower doses than other vasodilators and exhibits a delayed and more prolonged action in all regional vascular beds.     

The band areas of proteins determined by fluorescent scanning in the commercial automated gel electrophoresis apparatus

An automated gel electrophoresis apparatus, recently available commercially, allows one to follow the band during electrophoresis in real time, and lends itself therefore to an evaluation of bandwidth as a function of migration time (the dispersion coefficient), resolution and band shape. These determinations assume the constancy of band area with migration time and at various gel concentrations. The purpose of the present study was to verify these assumptions. Representative proteins and sodium dodecyl sulfate (SDS)-proteins, either natively fluorescent or fluorescein carboxylate labeled, were found to exhibit band areas which approach constancy as a function of migration time in both agarose and polyacrylamide gel electrophoresis, provided that (i) the protein concentration under the band was low enough to obviate self-quenching of fluorescence; (ii) the separation of the protein of interest from contaminants had progressed sufficiently during the time at which band areas were measured; (iii) the baseline under the peak was sufficiently well defined. However, band areas decrease with increasing gel concentration. Protein peaks exhibited leading and trailing tails. The ratio of the combined tail area to total area appeared to be near-constant at varying migration times. However, that ratio increases with increasing gel concentration. The tail area does not appear to be an artifact of fluorometric detection since it is reproduced upon fluorimetric analysis of the protein eluted from gel slices after electrophoresis. However, it may be due to photochemical destruction under the conditions of repetitive fluorometric peak detection.     

Distributed self-stabilizing placement of replicated resources in emerging networks

Emerging large scale distributed networking systems, such as P2P file sharing systems, sensor networks, and ad hoc wireless networks, require replication of content, functionality, or configuration to enact or optimize communication tasks. The placement of these replicated resources can significantly impact performance. We present a novel self-stabilizing, fully distributed, asynchronous, scalable protocol that can be used to place replicated resources such that each node is "close" to some copy of any object. We describe our protocol in the context of a graph with colored nodes, where a node's color indicates the replica/task that it is assigned. Our combination of theoretical results and simulation prove stabilization of the protocol, and evaluate its performance in the context of convergence time, message transmissions, and color distance. Our results show that the protocol generates colorings that are close to the optimal under a set of metrics, making such a protocol ideal for emerging networking systems.     

Using classification techniques for informal requirements in the requirements analysis-supporting system

In order to efficiently develop large-scale and complicated software, it is important for system engineers to correctly understand users’ requirements. Most requirements in large-scale projects are collected from various stakeholders located in various regions, and they are generally written in natural language. Therefore, the initial collected requirements must be classified into various topics prior to analysis phases in order to be usable as input in several requirements analysis methods. If this classification process is manually done by analysts, it becomes a time-consuming task. To solve this problem, we propose a new bootstrapping method which can automatically classify requirements sentences into each topic category using only topic words as the representative of the analysts’ views. The proposed method is verified through experiments using two requirements data sets: one written in English and the other in Korean. The significant performances were achieved in the experiments: the 84.28 and 87.91 F1 scores for the English and Korean data sets, respectively. As a result, the proposed method can provide an effective function for an Internet-based requirements analysis-supporting system so as to efficiently gather and analyze requirements from various and distributed stakeholders by using the Internet.     

Toughening mechanism for a rubber-toughened epoxy resin with rubber/matrix interfacial modification

For a rubber-toughened piperidine-DGEBA epoxy resin, the interface between the rubber particle and the epoxy resin matrix was modified by an epoxide end-capped carboxyl terminated butadiene and acrylonitrile random copolymer (CTBN). The end-capping epoxides used were a rigid diglycidyl ether of bisphenol-A (Epon 828), a short-chain flexible diglycidyl ether of propylene glycol (DER 736), and a long-chain flexible diglycidyl ether of propylene glycol (DER 732). The microstructures and the fracture behaviour of these rubber-modified epoxy resins were studied by transmission electron microscopy and scanning electron microscopy. Their thermal and mechanical properties were also investigated. In the rubber-modified epoxy resins, if the added CTBNs were end-capped by a flexible diglycidyl ether of propylene glycol (DER 732 or DER 736) before curing, the interfacial zone of the undeformed rubber particle, the degree of cavitation of the cavitated rubber particle on the fracture surface and the fracture energy of the toughened epoxy resin were all significantly increased. The toughening mechanism based on cavitation and localized shear yielding was considered and a mechanism for the interaction between cavitation and localized shear yielding that accounts for all the observed characteristics is proposed.     

Recovery of SDS-protein and DNA using commercial automated gel electrophoresis apparatus

Forty-seven children afflicted with acute leukemia were studied at the Tata Memorial Hospital Bombay to record the occurrence of oral manifestations prior to and during chemotherapy. Lymphadenopathy was the most frequent single finding suggestive of leukemia during head and neck examination. Gingival abnormalities, bleeding gums and oral mucosal pallor were the other findings on initial oral examination. Due to immunosuppression caused by the chemotherapy drugs oral mucosal ulcerations, uncontrolled herpes, candidiasis and pseudomoniasis were observed.