A novel brain-derived member of the epidermal growth factor family that interacts with ErbB3 and ErbB4

The availability of an analgesic compound devoid of the side effects associated with the commonly used opioid and nonsteroidal antiinflammatory drugs would be useful during the perioperative period. Although adenosine has analgesic and anesthetic-sparing properties, it also produces dose-dependent cardiovascular depression. Inhibitors of adenosine kinase may be able to provide analgesia without producing acute cardiovascular or respiratory depression. This preliminary study investigated the effects of a novel adenosine kinase-inhibiting drug, GP683, on the minimum alveolar anesthetic concentration (MAC) of desflurane in dogs. Seven mongrel dogs were administered one of three different GP683 dose regimens (or the solvent) by intravenous infusion on separate occasions according to a cross-over study design. After determining the baseline desflurane MAC value, GP683 was infused at 75, 150, or 300 microg x kg(-1) x min(-1) for 5 min as a loading dose, followed by 15, 30, or 60 microg x kg(-1) x min(-1) for an additional 85 min to maintain a stable plasma drug level. The desflurane MAC was redetermined 30-90 min after starting the study drug or vehicle infusion, and 30-90 min and 120-180 min after termination of the infusion. Cardiovascular variables and plasma concentrations of GP683 were determined at specific intervals before, during, and after the MAC determinations. The three GP683 dose regimens produced 22%, 31%, and 50% decreases in the desflurane MAC, respectively. In addition, there was good correlation between the decrease in desflurane MAC and the plasma GP683 concentration (r = -0.78). Although the mean arterial pressure (MAP) was decreased up to 25% by the highest infusion rate of GP683, adjustments in the desflurane concentration to an equi-MAC value resulted in normalization of the MAP values. Furthermore, GP683 produced no changes in heart rate. In conclusion, the adenosine kinase-inhibiting drug, GP683, produced dose-dependent decreases in the desflurane MAC of dogs without producing untoward hemodynamic changes. IMPLICATIONS: An investigational drug (GP683) that can increase the levels of an important endogenous substance in the body (adenosine) has been found to decrease the anesthetic requirement in dogs without producing adverse effects on the cardiovascular system.     

Sensorless control of synchronous reluctance motors using on‐line parameter identification method not affected by position estimation accuracy

This paper presents a novel on‐line parameter identification method for sensorless control of Synchronous Reluctance Motors (SynRMs). Although conventional sensorless control methods based on mathematical models usually need some complex measurements of motor parameters in advance, the proposed identification method does not require them and can be realized on‐line. The proposed method identifies motor parameters under sensorless control, so rotor position and velocity cannot be used to identify these parameters. However, the proposed method does not need rotor position and velocity, and identified parameters are not affected by these estimation errors. The sensorless control using identified motor parameters is realized, and the effectiveness of the proposed method is verified by experimental results. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(3): 62–69, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20258     

A load dispatch method using fractional programming and semidefinite programming

This paper describes a load dispatch method which minimizes power cost—[fuel cost]/[electric output]—for a power system with thermal plants and energy storage facilities. The proposed method employs fractional programming to convert a minimization problem with fractional objective function to a series of quadratic minimization problems, and semidefinite programming to solve converted problems. The method provides the optimum time‐dependent power output/input and storage level of energy storage facilities as well as time‐dependent power output of thermal plants. The method has been applied to a power system with five thermal plants, two energy storage facilities of various performances, and five load demands. The optimum load scheme of four time mesh points is obtained for the thermal plants and energy storage facilities. The fractional programming successfully converges the optimal scheme through a few iterations. The semidefinite programming deals with a variable matrix of 164 dimensions, and 185 inequality constraints. © 2001 Scripta Technica, Electr Eng Jpn, 138(2): 49–58, 2002     

66/77-kV C-GIS using composite insulation in SF6 gas

A second-generation model of cubicletype gas-insulated switchgear (C-GIS) with composite insulation incorporating SF₆ gas has been developed. The design does not require a gas process in field assembly; it has high reliability and its installation is more rapid; and a further reduction in size is achieved. The design principles are described in detail.     

Influence of third monomer on the crystal phase transition behavior of ethylene-tetrafluoroethylene copolymer

Crystal phase transition between the low- and high-temperature phases has been investigated for ethylene (E)-tetrafluoroethylene (TFE) alternating copolymer (ETFE) containing the third monomeric species by the temperature dependent measurements of wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) and differential scanning calorimetry. Nonafluoro-1-hexene (NFH) and hexafluoropropylene (HFP) were chosen as the third monomers, where they are different in the side-branch length, -(CF₂)₃CF₃ and -CF₃, respectively. In the case of E/TFE/NFH copolymer (ET-C4F9), the crystal phase transition temperature of the original ETFE two-components copolymer was not very much affected by the existence of NFH in the range of NFH content from 0.7 to 3 mol%. Contrarily, the crystal phase transition temperature of E/TFE/HFP copolymer (ET-CF3) was found to decrease drastically with increasing HFP content. The melting temperature and the higher-order structure were also affected sensitively depending on the HFP content. This difference in phase transition behavior between ET-C4F9 and ET-CF3 copolymers is reasonably interpreted as follows: the short side groups (-CF₃) of HFP monomeric unit are included in the crystal lattice of E/TFE chains and the unit cell is expanded gradually with an increment of the HFP content, resulting in the decrease in phase transition point because of easier thermal motion of the chains. On the other hand, the long side groups [-(CF₂)₃CF₃] of NFH monomeric units are excluded out of the crystal lattice and located on the lamellar surfaces or in the amorphous region and do not affect very much the phase transition temperature even when the NFH content is increased. In association with such a change in crystal structure, the long period of stacked lamellar structure was found to decrease remarkably in the case of NFH, whereas it does not change very much for HFP, consistent with the interpretation of the above-mentioned WAXD data.     

Swelling of hydrophilic polymers. III

The total volume change included gel and surrounded water with the swelling of five types of speherical cross-linked dextran (Sephadex) that are either nonionic (G) or possess one of four different ionic groups in the same molecular skeleton: CM: sodium carboxymethyl, SP: sodium sulphopropyl, DEAE: diethylaminoethyl chloride, and QAE: diethyl-(2-hydroxypropyl) aminoethyl chloride. All have been studied by dilatometry. The total volume decreased with the swelling of all Sephadexes. The maximum changes of total volume with the swelling in water were all negatives of CM, G, SP, (DEAE, QAE), which decrease in that order. These values did not depend on the concentration of sodium chloride and were closely related to the maximum heats of swelling. Total volume changes occurred by the dissociation of the ionic group of dextran derivatives that subtracted the total volume change due to hydration of Sephadex skeleton from the total volume change: ?21.6 ± 3.1 μL mmol^?1 for CM, ?2.8 ± 8.0 μL mmol^?1 for SP, +13.2 ± 4.4 μL mmol^?1 for DEAE, and +15.4 ± 4.6 μL mmol^?1 for QAE. These values are assumed to be reflected in the quantities of ions-water interaction of Sephadexes. © 1994 John Wiley & Sons, Inc.     

Fate of the human liver after hemihepatic portal vein embolization: cell kinetic and morphometric study

The favorable therapeutic effect of preoperative portal vein embolization (PVE) was analyzed by assessing various volumetric, cell kinetic and morphometric parameters and examining histologically the embolized and nonembolized lobes of 15 patients who underwent extended right lobectomy 2 to 3 weeks after PVE. Each lobar volume was calculated from computed tomography (CT) images, hepatocyte proliferation was evaluated by assessing proliferative cell nuclear antigen (PCNA) expression and mitosis, hepatocyte apoptosis was evaluated by the terminal deoxyribonucleotidyl transferase-mediated dUTP nick end labeling (TUNEL) assay, and the hepatocyte numerical density as well as the sinusoidal volumetric ratio (Vvs) and the mean hepatocyte volume (Cv) were calculated using morphometric methods. PVE induced hepatocyte apoptosis and atrophy of the embolized lobe (from 798 +/- 213 to 708 +/- 222 cm3; P < .05). The increased sinusoidal volume in this lobe (17.7% +/- 4.5% and 21.7% +/- 5.7%, periportal and pericentral area, respectively) may have been attributable to hepatocyte deletion. Cells in the nonembolized lobe entered a highly active phase of proliferation within 2 weeks after PVE. Further evidence of cellular proliferation was provided by the increased nonembolized lobar volume (from 379 +/- 132 to 545 +/- 130 cm3; P < .01) and numerical density of hepatocyte nuclei (Nv) (5.38 +/- 1.26 vs. 3.11 +/- 0.85 x 10(5)/mm3; P < .01, nonembolized vs. embolized lobe, respectively). In conclusion, these results indicate that the favorable effect of PVE is attributable to a net gain of functional hepatocyte mass and/or early induction of hepatocyte proliferation following hepatectomy.     

Flexural and tensile moduli of polypropylene nanocomposites and comparison of experimental data to Halpin‐Tsai and Tandon‐Weng models

This research focuses on the reinforcing efficiency of nanomateterials and the role of the reinforcement's dispersion and orientation on the nanocomposite's flexural and tensile moduli. Polypropylene‐based composites reinforced with (i) exfoliated graphite nanoplatelets, xGnP?, (ii) vapor grown carbon fibers, (iii) PAN‐based carbon fibers, (iv) highly structured carbon black and (v) montmorillonite clay were fabricated by extrusion and injection molding. It was found that graphite platelets are the best reinforcement in terms of flexural modulus whereas PAN‐based carbon fibers cause the largest improvement in the tensile modulus. The difference in the reinforcing efficiency during the flexural and tensile testing is attributed to (i) the degree of fiber alignment along the flow direction during injection molding, which is higher in the thinner tensile specimens than in the flex specimens; and (ii) the different deformation modes of the two tests. The importance of good dispersion of the reinforcements within the polymer matrix and of perfect contact between the two phases is emphasized comparing the experimental modulus data to theoretical predictions made using the Halpin‐Tsai and the Tandon‐Weng models. POLYM. ENG. SCI., 47:1796–1803, 2007. © 2007 Society of Plastics Engineers     

An apparent ensemble effect in the oxidative coupling of methane on hydroxyapatites with incorporated lead

The introduction of small quantities of lead into calcium hydroxyapatite catalysts produces marked increases in the selectivity to C₂₊ hydrocarbons, while the conversion of methane remains relatively constant. Small surface concentrations of lead are sufficient to achieve C₂₊ selectivities of 80 and 90%, with oxygen and nitrous oxide, respectively, in contrast with 18 and 46%, respectively, obtained in the absence of lead. Since surface concentration of lead species sufficient to stabilize pairs of methyl radicals in close proximity to each other would be expected to facilitate the formation of C₂ hydrocarbons, an ensemble effect appears to be extant.