In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Sedimentation of terrigenous red soils in coastal area adjacent to an estuary and coral reefs,the Okkubi River estuary,Okinawa Island,Japan

Sedimentation process of fine-grained terrigenous red soils was observed on the seafloor by coral reefs near an estuary using a paired mooring of turbidity meter and sediment trap or a mooring of sediment trap and current meter. Silty clays contained in the bottom calcareous sands were mainly resuspended and trapped in both surface and bottom layer traps, at noncatastrophic normal sedimentation periods. In addition, silty clays were supplied to this mooring site by inflowing river. Turbidity and the flux rate determined by sediment traps show certain relationship accompanied with the coefficient, which is changed by precipitation, current, and other conditions. Resuspension process caused by a typhoon was recorded as both core sequence of sediment trap and time-series data of bottom current. Maximum velocity of 49.5 cm/s was recorded from bottom currents resulting from the passing of attyphoon at the mooring site. A graded sand layer is interbedded in dark-gray, silty clay and considered to be a resuspended sediment resulting from the passing of the typhoon. Flux of the resuspended sediments by the typhoon was estimated from this core sequence and compared to the flux observed at the normal sedimentation.     

Issues of Globalization and Reflexivity in the Japanese Tourism Production System: The Case of Whistler,British Columbia

This article examines contemporary Japanese overseas tourism from a supplier‐side perspective using the concept of production systems. We first outline characteristics of the evolving structure of Japanese overseas tourism, with an emphasis on the global spread of Japanese travel companies. This provides a frame for presenting an empirical account of the transactional relationships in the Japanese package tour production system in Whistler, British Columbia, where Japanese tour operators play a pivotal role. We conclude that the recent expansion of Japanese travel companies is fostering the functional integration of the global tourism production system and exhibits increasing reflexivity.     

Observations of flux rope – associated particle bursts with GEOTAIL in the distant tail

Geotail energetic particle, magnetic field data and plasma observations (EPIC, MGF and CPI experiments) have been examined for a number of energetic particle bursts in the distant tail (120Re < |X_GSM| < 130 Re), associated with moving magnetic field structures, following substorm onsets. The features obtained from this data analysis are consistent with the distant magnetotail dynamics determined first by ISEE3 observations and explained in terms of the neutral line model. At the onset of the bursts, before plasma sheet entrance, energetic electrons appear as a field-aligned beam flowing in the tailward direction, followed by anisotro-pic ions. Within the flux rope region, suprathermal ions exhibit a convective anisotropy, which allows determination of the plasma flow velocity, assuming that the anisotropy arises from the Compton-Getting effect. The velocities thus determined in the plasma sheet are estimated to be 200–650 km/s, and compare favourably with the velocities derived from the CPI electron and proton experiment. The estimated length of magnetic field structures varies between 28 and 56 Re and depends on the strength of the westward electrojet intensification. Finally, the three structures reported here show clear magnetic field signatures of flux rope topology. The existence of a strong magnetic field aligned approximately along the Y-axis and centred on the north-to-south excursion of the field, and the bipolar signature in both By and/or Bz components, is consistent with the existence of closed field lines extending from Earth and wrapping around the core of the flux rope structure.     

Carbon isotopes and petrography of kerogens in ∼3.5-Ga hydrothermal silica dikes in the North Pole area, Western Australia

More than 600 specimens of ∼3.5 Ga-old hydrothermal silica dikes from the North Pole area, Pilbara craton, Western Australia, have been studied petrographically. The kerogens in 44 samples have been analyzed isotopically (C and N) and chemically (C, N, and H). The silica dikes are composed mainly of fine-grained silica (modal abundance: >97%) and are classified into two types by minor mineral assemblages: B(black)-type and G(gray)-type. The B-type silica dikes contain kerogen (0.37 to 6.72 mgC/g; average 2.44 mgC/g, n = 21) and disseminated sulfides, dominantly pyrite and Fe-poor sphalerite. In some cases, carbonate and apatite are also present. Their silica-dominated and sulfide-poor mineral assemblages suggest precipitation from low-temperature reducing hydrothermal fluid (likely 100-200°C). On the other hand, the G-type silica dikes are sulfide-free and concentrations of kerogen are relatively low (0.05 to 0.41 mgC/g; average 0.17 mgC/g, n = 13). They typically contain Fe-oxide (mainly hematite) which commonly replaces cubic pyrite and rhombic carbonate. Some G-types occur along secondary quartz veins. These textures indicate that the G-type silica dikes were formed by postdepositional metasomatism (oxidation) of the B-types, and that the B-types probably possess premetasomatic signatures. The δ¹³C values of kerogen in the B-types are −38.1 to −33.1‰ (average −35.9‰, n = 21), which are ∼4‰ lower than those of the G-types (−34.5 to −30.0‰; average −32.2‰, n = 19), and ∼6‰ lower than bedded chert (−31.2 to −29.4‰; average −30.5‰, n = 4). This indicates the preferential loss of ¹²C during the metasomatism (estimated fractionation factor: 0.9985). Considering the metasomatic effect on carbon isotopes with probably minor diagenetic and metamorphic overprints, we conclude that the original δ¹³C values of the kerogen in the silica dikes would have been heterogeneous (∼5‰) and at least some material had initial δ¹³C values of ≤ −38‰. The inferred ¹³C-depletions of organic carbon could have been produced by anaerobic chemoautotrophs such as methanogen, but not by aerobic photoautotrophs. This is consistent with the estimated physical and chemical condition of the hydrothermal fluid, which was probably habitable for anaerobic and thermophilic/hyperthermophilic chemoautotrophs. Alternatively, the organic matter may have been possibly produced by abiological reaction such as Fischer-Tropsch Type (FTT) synthesis under the hydrothermal condition. However, the estimated condition is inconsistent with the presence of the effective catalysts for the FTT reaction (i.e., Fe-Ni alloy, magnetite, and hematite). These lines of evidence suggest the possible existence of biosphere in the ∼3.5 Ga sub-seafloor hydrothermal system.     

Correcting the Smoothing Effect of Ordinary Kriging Estimates

The smoothing effect of ordinary kriging is a well-known dangerous effect associated with this estimation technique. Consequently kriging estimates do not reproduce both histogram and semivariogram model of sample data. A four-step procedure for correcting the smoothing effect of ordinary kriging estimates is shown to be efficient for the reproduction of histogram and semivariogram without loss of local accuracy. Furthermore, this procedure provides a unique map sharing both local and global accuracies. Ordinary kriging with a proper correction for smoothing effect can be revitalized as a reliable estimation method that allows a better use of the available information.     

Raman spectra of methane hydrate up to 86 GPa

High-pressure Raman studies of methane hydrate were performed using a diamond anvil cell in the pressure range of 0.1–86 GPa at room temperature. Raman spectra of the methane molecules revealed that new softened intramolecular vibration mode of ν ₁ appeared at 17 GPa and that the splitting of vibration mode of ν ₃ occurred at 15 GPa. The appearance of these two modes indicates that an intermolecular attractive interaction increases between the methane molecules and the host water molecules and between the neighboring methane molecules. These interactions might result in the exceptional stability of a high-pressure structure, a filled ice Ih structure (FIIhS) for methane hydrate, up to 40 GPa. At 40 GPa, a clear change in the slope of the Raman shift versus pressure occurred, and above 40 GPa the Raman shift of the vibration modes increased monotonously up to 86 GPa. A previous XRD study showed that the FIIhS transformed into another new high-pressure structure at 40 GPa. The change in the Raman spectra at 40 GPa may be induced by the transition of the structure.     

High-reliability zircon separation for hunting the oldest material on Earth: An automatic zircon separator with image-processing/microtweezers-manipulating system and double-step dating

Despite the recent development in radiometric dating of numerous zircons by LA-ICPMS, mineral separation still remains a major obstacle, particularly in the search for the oldest material on Earth. To improve the efficiency in zircon separation by an order of magnitude, we have designed/developed a new machine-an automatic zircon separator(AZS). This is designed particularly for automatic pick-up of100 μm-sized zircon grains out of a heavy mineral fraction after conventional separation procedures. The AZS operates in three modes:(1) image processing to choose targeted individual zircon grains out of all heavy minerals spread on a tray,(2) automatic capturing of the individual zircon grains with microtweezers, and(3) placing them one-by-one in a coordinated alignment on a receiving tray. The automatic capturing was designed/created for continuous mineral selecting without human presence for many hours. This software also enables the registration of each separated zircon grain for dating, by recording digital photo-image, optical(color) indices, and coordinates on a receiving tray. We developed two new approaches for the dating; i.e.(1) direct dating of zircons selected by LA-ICPMS without conventional resin-mounting/polishing,(2) high speed U-Pb dating, combined with conventional sample preparation procedures using the new equipment with multiple-ion counting detectors(LA-MIC-ICPMS).With the first approach, Pb-Pb ages obtained from the surface of a mineral were crosschecked with the interior of the same grain after resin-mounting/polishing. With the second approach, the amount of time required for dating one zircon grain is ca. 20 s, and a sample throughput of 150 grains per hour can be achieved with sufficient precision(ca. 0.5%).We tested the practical efficiency of the AZS, by analyzing an Archean Jack Hills conglomerate in Western Australia with the known oldest(4.3 Ga) zircon on Earth. Preliminary results are positive; we were able to obtain more than 194 zircons that are over 4.0 Ga out of ca. 3800 checked grains, and 9 grains were over 4300 Ma with the oldest at 4371 ± 7 Ma. This separation system by AZS, combined with the new approaches, guarantees much higher yield in the hunt for old zircons.