Application of differential electrolytic potentiometry for detection in flow injection analysis

The applicability of differential electrolytic potentiometry as a detection system in flow injection analysis is investigated. A computer-controlled injector which delivers precise volumes of sample solutions in a reproducible manner was developed. Conditions such as current density employed, the concentrations of the solutions used and the flow rate were optimized. Chloride in water was determined by means of this system. The relation between chloride concentration and the measured signal was found to be Nernstian for solutions of concentrations above 6 μg ml⁻¹ chloride. For solutions below this concentration, the relation is linear.     

Equivalences of comodule categories for coalgebras over rings

In this article we defined and studied quasi-finite comodules, the cohom functors for coalgebras over rings. Linear functors between categories of comodules are also investigated and it is proved that good enough linear functors are nothing but a cotensor functor. Our main result of this work characterizes equivalences between comodule categories generalizing the Morita-Takeuchi theory to coalgebras over rings. Morita-Takeuchi contexts in our setting is defined and investigated, a correspondence between strict Morita-Takeuchi contexts and equivalences of comodule categories over the involved coalgebras is obtained. Finally, we proved that for coalgebras over QF-rings Takeuchi's representation of the cohom functor is also valid.     

Synthesis,dynamic light scattering,and luminescence properties of copolymers containing iridium(III) bisterpyridine in the side chain

Supramolecular block‐random copolymers containing [Ir(terpy)₂]³⁺ in the side chain were synthesized via postfunctionalization of a P(S‐b‐AC_terpy) block copolymer. Absorbance and emission spectra compared to a model compound show that the polymer backbone has a minor effect on the polymer absorbance but produces a larger shift for the phosphorescence signals to higher wavelength. Dynamic light scattering of the metal complex containing copolymer studied in various solvents showed monomodal aggregation with decreasing aggregate size as the solvent dielectric constant increased. The copolymer precursor P(S‐b‐AC_terpy) shows multimodal aggregation in different solvents with the major population consisting of single chains. This difference in behavior between the two polymers is attributed to the electrolytic nature of the complex and the amphiphilicity induced by the charged metal complex. Supramolecular copolymers like these will continue to have interesting self‐organizational properties and may find applications in multicomponent systems for photoinduced charge separation processes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 1109–1121, 2007     

Some existence results for quasilinear elliptic equations in a finite cylinder

We study the existence of solutionsu in the finite cylinderS _a=(?a, a)×ω of the quasilinear elliptic equation $$\sum\limits_{i,j = 1}^n {a_{i,j} (x)\partial _{i,j} u + f(x,u,\nabla u) = 0} $$ with Dirichlet boundary condition on flat parts of σS _a and Neumann condition on the curved parts. In this paper, we focus on the technicality caused by the “corners” ofS _a. We prove the existence of such solutions provided that suitable sub and super solutions are known and under the condition that the coefficientsa _1,i,i#1 vanish on the corners. We also prove a more general result in ?².     

Electronic communication through the ureylene bridge: spectroscopy, structure and electrochemistry of dimethyl 1,1-ureylenedi(1-ferrocenecarboxylate)

Dimethyl 1^′,1^′-ureylenedi(1-ferrocenecarboxylate) (1) formed during the synthesis of 1-amino, 1^′-ferrocenecarboxylic acid shows virtual molecular centrosymmetry. Electronic coupling between the two Fc groups through the ureylene bridge results in both Fc groups being individually oxidizable (ΔE_1/2?0.14 V). The possible existence of intermolecular electronic communication has discussed. The oxidation was followed by spectroelectrochemistry. The separation between the two halfwave potentials ΔE_1/2=137±5 mV and the comproportionation constant K_c=207.     

Time-weighted average sampling of volatile and semi-volatile airborne organic compounds by the solid-phase microextraction device

The ultimate goal of the chemist is to perform sample preparation, and analysis, if possible at the place where a sample is located rather than moving the sample to laboratory, as is common practice in many cases at the present time. This approach eliminates errors and time associated with sample transport and storage and therefore it would result in more accurate, precise and faster analytical data. In addition to portability, two other important features of ideal field sample preparation technique are elimination of solvent use and integration with a sampling step. A method is developed which addresses these requirements for the determination of time-weighted average concentration of gas phase compounds using a solid-phase microextraction device. Quantification of target analytes in air using this method can be carried out without external calibration. The volatile and semi-volatile organic compounds in air diffuse into the fiber coating which is retracted a known distance into its needle housing during the sampling period. The coatings used are poly(dimethylsiloxane) and poly(dimethylsiloxane)-divinylbenzene. The sampling rate at which gas phase analytes load onto the fiber is determined for a wide range of hydrocarbons. There is a good agreement between the theoretical and experimental sampling rates. Sampling time ranges from 1 min to 24 h depending on the coating used and its retraction distance. Effect of the flow-rate on the uptake rate by the fiber is studied. The method is tested in the field and compared with National Institute of Occupational Health and Safety Method 1550. Good agreement between the results is obtained.     

Substitutional carbon defects in silicon: A quantum mechanical characterization through the infrared and Raman spectra

The infrared (IR) and Raman spectra of eight substitutional carbon defects in silicon are computed at the quantum mechanical level by using a periodic supercell approach based on hybrid functionals, an all electron Gaussian type basis set and the CRYSTAL code. The single substitutional C _s case and its combination with a vacancy (C _sV and C _sSiV) are considered first. The progressive saturation of the four bonds of a Si atom with C is then examined. The last set of defects consists of a chain of adjacent carbon atoms C, with i = 1–3. The simple substitutional case, C _s, is the common first member of the three sets. All these defects show important, very characteristic features in their IR spectrum. One or two C related peaks dominate the spectra: at 596 cm⁻¹ for C _s (and C _sSiV, the second neighbor vacancy is not shifting the C _s peak), at 705 and 716 cm⁻¹ for C _sV, at 537 cm⁻¹ for C and C (with additional peaks at 522, 655 and 689 for the latter only), at 607 and 624 cm⁻¹, 601 and 643 cm⁻¹, and 629 cm⁻¹ for SiC, SiC, and SiC, respectively. Comparison with experiment allows to attribute many observed peaks to one of the C substitutional defects. Observed peaks above 720 cm⁻¹ must be attributed to interstitial C or more complicated defects.     

Highly sensitive catalytic determination of molybdenum

A novel, highly sensitive, selective, and simple kinetic method was developed for the determination of Mo(VI) based on its catalytic effect on the oxidation of 1-amino-2-naphthol-4-sulfonic acid (ANSA) with H₂O₂. The reaction was followed spectrophotometrically by tracing the oxidized product at 465 nm after 30 min of mixing the reagents. The optimum reaction conditions were: 10 mmol l⁻¹ ANSA, 50 mmol l⁻¹ H₂O₂, 100 mmol l⁻¹ acetate buffer of pH 5.0 ± 0.05 and at 40 °C. Addition of 200 μg ml⁻¹ diethylenetriaminepentaacetic acid (DTPA) conferred high selectivity for the proposed method. Following the recommended procedure, Mo(VI) could be determined with a linear calibration graph up to 2.5 ng ml⁻¹ and a detection limit, based on the 3S_b-criterion, of 0.027 ng ml⁻¹. The unique sensitivity and selectivity of the implemented method allowed its direct application to the determination of Mo(VI) in natural and industrial waste water. The method was validated by comparison with the standard ETAAS method. Moreover, published catalytic-spectrophotometric methods for the determination of molybdenum were reviewed.     

Proposed Mechanism for the Antitrypanosomal Activity of Quercetin and Myricetin Isolated from Hypericum afrum Lam.: Phytochemistry,In Vitro Testing and Modeling Studies

The in vitro activity of L. donovani (promastigotes, axenic amastigotes and intracellular amastigotes in THP1 cells) and T. brucei, from the fractions obtained from the hydroalcoholic extract of the aerial part of Hypericum afrum and the isolated compounds, has been evaluated. The chloroform, ethyl acetate and n-butanol extracts showed significant antitrypanosomal activity towards T. brucei, with IC₅₀ values of 12.35, 13.53 and 12.93 µg/mL and with IC₉₀ values of 14.94, 19.31 and 18.67 µg/mL, respectively. The phytochemical investigation of the fractions led to the isolation and identification of quercetin (1), myricitrin (2), biapigenin (3), myricetin (4), hyperoside (5), myricetin-3-O-β-d-galactopyranoside (6) and myricetin-3’-O-β-d-glucopyranoside (7). Myricetin-3’-O-β-d-glucopyranoside (7) has been isolated for the first time from this genus. The chemical structures were elucidated by using comprehensive one- and two-dimensional nuclear magnetic resonance (1D and 2D NMR) spectroscopic data, as well as high-resolution electrospray ionization mass spectrometry (HR-ESI–MS). These compounds have also been evaluated for their antiprotozoal activity. Quercetin (1) and myricetin (4) showed noteworthy activity against T. brucei, with IC₅₀ and IC₉₀ values of 7.52 and 5.71 µM, and 9.76 and 7.97 µM, respectively. The T. brucei hexokinase (TbHK1) enzyme was further explored as a potential target of quercetin and myricetin, using molecular modeling studies. This proposed mechanism assists in the exploration of new candidates for novel antitrypanosomal drugs.