Clarification of a wheat straw‐derived medium with ion‐exchange resins for xylitol crystallization

BACKGROUND: Xylitol bioproduction from lignocellulosic residues comprises hydrolysis of the hemicellulose, detoxification of the hydrolysate, bioconversion of the xylose, and recovery of xylitol from the fermented hydrolysate. There are relatively few reports on xylitol recovery from fermented media. In the present study, ion‐exchange resins were used to clarify a fermented wheat straw hemicellulosic hydrolysate, which was then vacuum‐concentrated and submitted to cooling in the presence of ethanol for xylitol crystallization. RESULTS: Sequential adsorption into two anion‐exchange resins (A‐860S and A‐500PS) promoted considerable reductions in the content of soluble by‐products (up to 97.5%) and in medium coloration (99.5%). Vacuum concentration led to a dark‐colored viscous solution that inhibited xylitol crystallization. This inhibition could be overcome by mixing the concentrated medium with a commercial xylitol solution. Such a strategy led to xylitol crystals with up to 95.9% purity. The crystallization yield (43.5%) was close to that observed when using commercial xylitol solution (51.4%). CONCLUSION: The experimental data demonstrate the feasibility of using ion‐exchange resins followed by cooling in the presence of ethanol as a strategy to promote the fast recovery and purification of xylitol from hemicellulose‐derived fermentation media. Copyright © 2008 Society of Chemical Industry     

Model study of the crosslinking of polydimethylsiloxanes by peroxides

The decompositions of di-t-butyl peroxide (TBP) and diaroyl peroxides in permethylated silicone oil (47V20) have been studied by differential scanning calorimetry (DSC). Results show the importance of the solubility of the peroxide in the silicone on their rate of disappearance. For the diaroyl peroxides, according to the nature of the substituents on the phenyl ring and the concentration of the peroxide, the decomposition occurs in solution and/or in the solid phase. Decomposition in solution began at a lower temperature than in the solid phase, which took place immediately after melting and was quite instantaneous. Decomposition of these peroxides was also performed in octamethylcyclotetrasiloxane (D₄) and decamethyltetrasiloxane (DMTS). According to DSC results, D₄ seems to be a better model of the silicone than the linear one. Analyses of the products of the decomposition of TBP and dibenzoyl peroxide (BP) in this model showed that the dehydrodimer of D₄ was produced in low yield relative to peroxide. The main compounds obtained were high molecular weight compounds, which were apparently different for the two peroxides. The free radical origin of these products has been proven in the case of TBP by the addition of TEMPO in the reaction medium.     

In-Situ and Real-Time Investigation of Columnar-to-Equiaxed Transition in Metallic Alloy

In this article, we present a review of observations during Al-3.5 wt pct Ni alloy solidi.cation experiments performed at the European Synchrotron Radiation Facility (ESRF) in Grenoble. These experiments provide direct access to dynamical phenomena during columnar growth (initial transient and breakdown of a planar solid-liquid interface), and for the first time to the transition from columnar-to-equiaxed microstructure (nucleation ahead of a columnar front and blocking of a columnar front by an equiaxed microstructure) and fully equiaxed growth (propagation of an effective front). Based on these experimental observations, critical parameters such as columnar growth velocity variation during the transition or equiaxed-grain diameter are measured and discussed. This article is based on a presentation made in the symposium entitled “Solidi.cation Modeling and Microstructure Formation: In Honor of Prof. John Hunt,” which occurred March 13–15, 2006, during the TMS Spring Meeting in San Antonio, Texas, under the auspices of the TMS Materials Processing and Manufacturing Division, Solidification Committee.     

Enhancement mode InP MISFET's with sulfide passivation andphoto-CVD grown P3N5 gate insulators

High performance enhancement mode InP MISFET's have been successfully fabricated by using the sulfide passivation for lower interface states and with photo-CVD grown P₃N₅ film used as gate insulator. The MISFET's thus fabricated exhibited exhibited pinch-off behavior with essentially no hysteresis. Furthermore the device showed a superior stability of drain current. Specifically under the gate bias of 2 V for 10⁴ seconds the room temperature drain current was shown to reduce from the initial value merely by 2.9% at the drain voltage of 4 V. The effective electron mobility and extrinsic transconductance are found to be about 2300 cm ²/V·s and 2.7 mS/mm, respectively. The capacitance-voltage characteristics of the sulfide passivated InP MIS diodes show little hysteresis and the minimum density of interface trap states as low as 2.6×10¹⁴/cm² eV has been attained     

Pressure effects on flow and fracture of Be-Al alloys

The flow and fracture behavior of Be-Al alloys were determined in tension with different levels of superimposed pressure. The Be-Al alloys were prepared by Brush Wellman, Inc. (Cleveland, OH) from prealloyed powders processed to either a hot isostatically pressed (“hipped”) or cold isostatically pressed and extruded condition. Significant effects of pressure on both the flow and ductility have been observed at room temperature, with implications on the formability of these materials. The effects of changes in processing conditions and stress state on the flow and fracture behavior are summarized in addition to both optical and scanning electron microscopy (SEM) examination of the fracture surfaces. Separate other studies on the alloy constituents (e.g., Al and Be) are also reported. The results are also compared to previous works on monolithic materials and composites tested with high pressure.     

Spatial learning deficits in mice with a targeted glucocorticoid receptor gene disruption

Previous studies in rats using the Morris water maze suggested that the processing of spatial information is modulated by corticosteroid hormones through mineralocorticoid and glucocorticoid receptors in the hippocampus. Mineralocorticoid receptors appear to be involved in the modulation of explorative behaviour, while additional activation of glucocorticoid receptors facilitates the storage of information. In the present study we used the water maze task to examine spatial learning and memory in mice homozygous and heterozygous for a targeted disruption of the glucocorticoid receptor gene. Compared with wild-type controls, homozygous and heterozygous mice were impaired in the processing of spatial but not visual information. Homozygous mutants performed variably during training, without specific platform-directed search strategies. The spatial learning disability was partly compensated for by increased motor activity. The deficits were indicative of a dysfunction of glucocorticoid receptors as well as of mineralocorticoid receptors. Although the heterozygous mice performed similarly to wild-type mice with respect to latency to find the platform, their strategy was more similar to that of the homozygous mice. Glucocorticoid receptor-related long-term spatial memory was impaired. The increased behavioural reactivity of the heterozygous mice in the open field points to a more prominent mineralocorticoid receptor-mediated function. The findings indicate that (i) the glucocorticoid receptor is of critical importance for the control of spatial behavioural functions, and (ii) mineralocorticoid receptor-mediated effects on this behaviour require interaction with functional glucocorticoid receptors. Until the development of site-specific, inducible glucocorticoid receptor mutants, glucocorticoid receptor-knockout mice present the only animal model for the study of corticosteroid-mediated effects in the complete absence of a functional receptor.     

L'impact des sympt?mes somatiques dans l'évaluation de la dépression chez une population gériatrique.

Studied the relationship among age, physical health status, and psychic and somatic symptoms of depression among elderly adults. Human Ss: 318 male and female Canadian older adults (aged 65–102 yrs). Information on sociodemographic factors and health status was obtained using the Older American Research Scale, French version, by R. Lefran?ois et al (1988). A French version by P. Bourque and D. Beaudette (1982) of the Beck Depression Inventory was also used. The results were evaluated according to each S's sex, age, institutionalized residence status, and health status. Statistical tests were used. (English abstract) (PsycINFO Database Record (c) 2010 APA, all rights reserved)