Effect of film thickness on hydrogen content in a-Si : H

The hydrogen content, its depth distribution, and its bonding configuration have been studied in hydrogenated amorphous silicon prepared by plasma-enhanced chemical vapor deposition with hydrogen-diluted silane. Nuclear reaction analysis and infrared spectroscopy were used to determine the total amount of hydrogen and its bonded component, respectively. It has been established that the total concentration of hydrogen does not depend on the film thickness, and has a uniform depth profile. The concentration of bonded hydrogen changes with the film thickness within the measurement accuracy. The data obtained suggest the presence of molecular (non-bonded) hydrogen, uniformly distributed in concentration across the film thickness.     

Continuous measurement of cardiac output by the Fick principle in infants and children: comparison with the thermodilution method

OBJECTIVE: To compare a system that continuously monitors cardiac output by the Fick principle with measurements by the thermodilution technique in pediatric patients. DESIGN: Prospective direct comparison of the above two techniques. SETTING: Pediatric intensive care unit of a university hospital. PATIENTS: 25 infants and children, aged 1 week to 17 years (median 10 months), who had undergone open heart surgery were studied. Only patients without an endotracheal tube leak and without a residual shunt were included. METHODS: The system based on the Fick principle uses measurements of oxygen consumption taken by a metabolic monitor and of arterial and mixed venous oxygen saturation taken by pulse- and fiberoptic oximetry to calculate cardiac output every 20s. INTERVENTIONS: In every patient one pair of measurements was taken. Continuous Fick and thermodilution cardiac output measurements were performed simultaneously, with the examiners remaining ignorant of the results of the other method. RESULTS: Cardiac output measurements ranged from 0.21 to 4.55 l/min. A good correlation coefficient was found: r2 = 0.98; P < 0.001; SEE = 0.41 l/min. The bias is absolute values and in percent of average cardiac output was - 0.05 l/min or - 4.4% with a precision of 0.32 l/min or 21.3% at 2 SD, respectively. The difference was most marked in a neonate with low cardiac output. CONCLUSION: Continuous measurement of cardiac output by the Fick principle offers a convenient method for the hemodynamic monitoring of unstable infants and children.     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Thermal decoloration kinetics of spirooxazines in Ormocer coatings prepared via sol-gel processing

Two free and one silylated (silane-substituted) photochromic spirooxazines are doped into organically modified ceramics (Ormocer) coatings by sol-gel processing and the thermal decoloration kinetics of these coatings are investigated and compared with the corresponding ethanol solutions and PMMA coatings. The decoloration behaviour of the two free dyes (SO-1 and SO-2) in the Ormocer coatings is similar to that in ethanol solutions, obeying a first-order mechanism and possessing almost the same decoloration rates as in ethanol. This suggests that the dye molecules encapsulated within the pores of the solid matrix are as free as those in ethanol solutions. The silylated dye (SO-3) in the Ormocer coatings, however, exhibits a considerably lower decoloration rate than the corresponding free dye (SO-1) and evident deviation from the first-order mechanism. This indicates apparently that the degree of freedom of the dye molecules is reduced by the silylation. These results are discussed on the basis of solvent polarity, porous structure of the Ormocer coating, and the dye-to-matrix connectivity.     

Synaptic-like microvesicles of neuroendocrine cells originate from a novel compartment that is continuous with the plasma membrane and devoid of transferrin receptor

We have characterized the compartment from which synaptic-like microvesicles (SLMVs), the neuroendocrine counterpart of neuronal synaptic vesicles, originate. For this purpose we have exploited the previous observation that newly synthesized synaptophysin, a membrane marker of synaptic vesicles and SLMVs, is delivered to the latter organelles via the plasma membrane and an internal compartment. Specifically, synaptophysin was labeled by cell surface biotinylation of unstimulated PC12 cells at 18 degrees C, a condition which blocked the appearance of biotinylated synaptophysin in SLMVs and in which there appeared to be no significant exocytosis of SLMVs. The majority of synaptophysin labeled at 18 degrees C with the membrane-impermeant, cleavable sulfo-NHS-SS-biotin was still accessible to extracellularly added MesNa, a 150-D membrane-impermeant thiol-reducing agent, but not to the 68,000-D protein avidin. The SLMVs generated upon reversal of the temperature to 37 degrees C originated exclusively from the membranes containing the MesNa-accessible rather than the MesNa-protected population of synaptophysin molecules. Biogenesis of SLMVs from MesNa-accessible membranes was also observed after a short (2 min) biotinylation of synaptophysin at 37 degrees C followed by chase. In contrast to synaptophysin, transferrin receptor biotinylated at 18 degrees or 37 degrees C became rapidly inaccessible to MesNa. Immunofluorescence and immunogold electron microscopy of PC12 cells revealed, in addition to the previously described perinuclear endosome in which synaptophysin and transferrin receptor are colocalized, a sub-plasmalemmal tubulocisternal membrane system distinct from caveolin-positive caveolae that contained synaptophysin but little, if any, transferrin receptor. The latter synaptophysin was selectively visualized upon digitonin permeabilization and quantitatively extracted, despite paraformaldehyde fixation, by Triton X-100. Synaptophysin biotinylated at 18 degrees C was present in these subplasmalemmal membranes. We conclude that SLMVs originate from a novel compartment that is connected to the plasma membrane via a narrow membrane continuity and lacks transferrin receptor.     

DNA analysis in hepatoblastoma by flow and image cytometry

BACKGROUND: In several types of tumors, including hepatocellular carcinoma, prognosis could be correlated with DNA ploidy. Few studies have been performed on hepatoblastoma with contradictory results. METHODS: Twenty-nine cases of nonpretreated hepatoblastoma were studied with flow cytometry and image cytometry for DNA index and proliferation index using paraffin-embedded tissue. RESULTS: Twenty-three (79.9%) tumors were diploid, and 6 (20.7%) were aneuploid (hyperdiploid). Patients with diploid tumors were younger than those with aneuploid tumors. With regard to stage, diploid tumors were almost equally distributed among stages (tumor, lymph node metastases, distant metastases), whereas aneuploid tumors tended to occur in higher stages (tumor, lymph node metastases, distant metastases). Diploid tumors had clearly a better prognosis than aneuploid tumors, although the difference was not statistically significant (flow cytometry, P = 0.06; image cytometry, P = 0.16). A more favorable prognosis was also noted for hepatoblastomas with low-proliferation index (< or = 7%), but the difference from tumors with high-proliferation index (> 7%) again was not statistically significant (P = 0.16). CONCLUSIONS: Although no statistically significant differences in prognosis between hepatoblastomas with diploid and aneuploid DNA content, respectively, were found, there is a clear tendency that diploid hepatoblastomas behave more favorably. The same is true for hepatoblastomas with low-proliferation index.     

The MiniWiD-Coater. III. Effect of Application Temperature on the Dissolution Profile of Sustained-Release Theophylline Pellets Coated with Eudragit Rs 30 D

Theophylline pellets were coated with Eudragit RS 30 D in a miniature fluid-bed pan coater called MiniWiD developed recently. The dispersions were plasticized with varying amounts of triethyl citrate (TEC), dibutyl phthalate (DBP), and polyethylene glycol 6000 (PEG) and applied at different temperatures ranging from 25 to 45 °C. Theophylline release was tested by dissolution using the USP Apparatus 2 (paddle) in 0.1 N hydrochloric acid under sink conditions over 6 hours.

At a coating level of 4 % (0.7 mg/cm²) sustained-release profiles were obtained from dispersions plasticized with TEC or DBP. By reducing the amount of plasticizer from 20 to 10%, films with higher permeabilities were obtained. This effect was compensated by tempering the pellets at 50 deg;C for 24 hours. The coating temperature had little effect on the dissolution profiles of TEC-plasticized films and no effect on films with DBP.

Coatings plasticized with 20% PEG were applied at temperatures ranging from 25 to 45 °C. These films required a coating level of about 18 % (3.3 mg/cm²) to provide comparable sustained-release properties. In contrast to DBP and TEC, a strong influence of the coating temperature on the release rates was observed in which higher temperatures led to slower release rates. This behavior can be explained by the minimum film-forming temperature (MFT). Since PEG does not lower the MFT of Eudragit RS 30 D, the application of these films below the MFT of 45 °C is associated with a lower degree of film formation.     

Refinements in validity generalization methods: Implications for the situational specificity hypothesis.

Using a large database, this study examined 3 refinements of validity generalization procedures: (1) a more accurate procedure for correcting the residual standard deviation (SD) for range restriction to estimate SDp, (2) use of r? instead of study-observed rs in the formula for sampling error variance, and (3) removal of non-Pearson rs. The 1st procedure does not affect the amount of variance accounted for by artifacts. The addition of the 2nd and 3rd procedures increased the mean percentage of validity variance accounted for by artifacts from 70 to 82%, a 17% increase. The cumulative addition of all 3 procedures decreased the mean SDp estimate from .150 to .106, a 29% decrease. Six additional variance-producing artifacts were identified that could not be corrected for. In light of these it was concluded that the obtained estimates of mean SDp and mean validity variance accounted for were consistent with the hypothesis that the true mean SDp value is close to zero. These findings provide further evidence against the situational specificity hypothesis. (PsycINFO Database Record (c) 2010 APA, all rights reserved)