Electrical and optical properties of fluorine-doped CdO films deposited by ultrasonic spray pyrolysis

The CdO:F samples have been deposited onto microscope glass substrates at 250 °C by ultrasonic spray pyrolysis method. With the incorporation of fluorine into CdO, the direct optical transition has shifted towards the shorter wavelengths, and the transparency of the material has increased at a given wavelength above the fundamental absorption edge. The shift in the absorption edge is explained by means of the Moss–Burstein effect, which is also supported with the results of the current–voltage characteristics. Here, a correlation has been established between the band broadening and the increase in conductivity due to the increase in carrier density.     

Cardiovascular effects produced by R-(+)-8-hydroxy-2-(di-n-propylamino) tetralin in the preoptic area of conscious rats

The effect of ancrod-induced defibrinogenation on thrombosis and bleeding time was determined in anesthetized rats. Functional plasma fibrinogen levels were reduced 42, 71, 94 and 93% by ancrod doses of 5, 10, 20 and 30 U/kg, respectively, while a 2.5 U/kg dose was without significant effect. Ancrod inhibited vena cava thrombosis induced by partial stasis of blood flow combined with mild vascular injury. Thrombus weight was decreased 85 and 93% by the 10 and 20 U/kg doses, but was unaffected at lower doses. In contrast, ancrod doses of up to 30 U/kg did not significantly decrease carotid artery thrombi formed in response to oxidative transmural vessel injury. Ancrod caused a dose-dependent increase in bleeding time measured by puncturing small mesenteric arteries with a hypodermic needle. The bleeding time increase was approximately 38% in response to the 2.5 and 5 U/kg doses, and 182% in response to the 10 U/kg dose. These studies demonstrate that ancrod-induced reductions in plasma fibrinogen more effectively inhibit venous compared to arterial thrombosis, although these activities require doses that also increase bleeding time in small arteries.     

Removal of power line interference in signal-averagedelectrocardiography systems

A method for line interference reduction to be used in signal-averaged electrocardiography (SAECG) systems is proposed and its performance is analyzed. This new method is an adaptation of a previously reported technique for removal of line interference from conventional electrocardiograms. It involves the recording of a line reference signal simultaneous with the lead signals, so that a shifted and sealed version of it can be used to subtract line interference from the leads. It is shown that this line interference subtraction method can reduce line interference effectively and without introducing any additional noise into the ECG signal. It is also shown that Late Potential diagnostic decisions are not altered when this filter is applied. It is recommended that this technique be used in SAECG when line interference is unavoidable     

Thermodynamic analysis of solar photovoltaic cell systems

The thermodynamic characteristics of solar photovoltaic (PV) cells are investigated from a perspective based on exergy. A new efficiency is developed that is useful in studying PV performance and possible improvements. Exergy analysis is applied to a PV system and its components, and exergy flows, losses and efficiencies are evaluated. Energy efficiency is seen to vary between 7% and 12% during the day. In contrast, exergy efficiencies, which incorporate the second law of thermodynamics and account for solar irradiation exergy values, are lower for electricity generation using the considered PV system, ranging from 2% to 8%. Values of “fill factors” are determined for the system and observed to be similar to values of exergy efficiency.     

THE RELATION BETWEEN WETTING EFFICIENCY AND LIQUID HOLDUP IN PACKED COLUMNS

Liquid holdup and wetting efficiency in packed columns were determined using a tracer method. A new model was developed considering axial dispersion, and analysis was made using the moment technique. The saturated solution of KG was used as an inert tracer and total liquid holdups were determined in the first part of experiments. As an adsorbable tracer, dioxane was utilized in the second part of the work and wetting efficiencies were obtained. Adsorption equilibrium constant was determined by the experiments conducted in a liquid full bed. A model proposed between liquid holdup and wetting efficiency gave good agreement with the experimental results. Axial dispersion effects were also taken into account during the work. It was also shown that axial dispersion of liquid phase should be considered especially in the small scale trickle bed reactors. @KEYWORDS:Packed beds,Wetting efficiency,Liquid holdup,Tracer method,Moment technique,Trickle bed reactors.     

Dissolution kinetics of ulexite in acetic acid solutions

Ulexite is an important boron mineral used for the production of boron compounds. The aims of this study are to examine the dissolution kinetics of ulexite in acetic acid solutions, and to present an alternative process to produce boric acid. In order to investigate the dissolution kinetics of ulexite in acetic acid solutions, the concentration of solution, reaction temperature, solid-to-liquid ratio, and particle size were selected as experimental parameters. It was determined that the dissolution rate of ulexite increased with increasing solution concentration and temperature and decreasing particle size and solid-to-liquid ratio. The activation energy of the process was found to be 55.8 kJ/mol.     

Synthesis of C60-Furfural Adduct

Diels-Alder cycloaddition of furfural to C₆₀ in toluene has been realised. UV-VIS, FTIR and ¹H-NMR investigations suggest that the conjugated structure of furfural was changed into a non-conjugated structure in the product.     

Requirements and Services for Metadata Management

Knowledge-intensive applications pose new challenges to metadata management, including distribution, access control, uniformity of access, and evolution in time. This paper identifies general requirements for metadata management and describes a simple model and service that focuses on RDF metadata to address these requirements.