Microscale Patterning of Mesoscopic PZN-PT Single Crystal Films by Crystal ion Slicing and Laser-Induced Etching

Advances in the fabrication of solid-solution single crystal relaxor ferroelectrics have made it possible to produce highly efficient piezoelectric crystals, and have attracted renewed interest in the use of these crystals for a new generation of piezoelectric transducers, actuators and sensors. Of particular interest is their incorporation into micro-electromechanical systems (MEMS). In this paper we report on the laser-induced wet chemical etching of lead zinc niobate-lead titanate (PZN-PT) in hydrochloric acid (HCl). Argon-ion laser radiation at power levels up to 4 W is focused to a spot diameter of about 15μm and results in the chemical etching of grooves at patterning speeds up to 5μm/sec. Crystal ion slicing, an ion-implant-based film separation technique, is used in combination with laser etching to form 5 to 10μm-thick patterned and freestanding films for incorporation into micro-electromechanical devices.     

A 0.9 V 92 dB Double-Sampled Switched-RC Delta-Sigma Audio ADC

A 0.9 V third-order double-sampled delta-sigma audio ADC is presented. A new method using a combination of a switched-RC technique and a floating switched-capacitor double-sampling configuration enabled low-voltage operation without clock boosting or bootstrapping. A three-level quantizer with simple dynamic element matching was used to improve linearity. The prototype IC implemented in a 0.13 CMOS process achieves 92 dB DR, 91 dB SNR and 89 dB SNDR in a 24 kHz audio signal bandwidth, while consuming 1.5 mW from a 0.9 V supply. The prototype operates from 0.65 V to 1.5 V supply with minimal performance degradation.     

A simple handling technique for mammalian oocytes and embryos during preparation for transmission electron microscopy

Due to their small size, mammalian oocytes and embryos pose unique problems during preparation for transmission electron microscopy. This paper outlines a method which combines protein embedding with centrifugation to locate the specimens on the face of a Beem capsule mould. This method facilitates both the processing of oocytes with minimal loss and rapid location of the specimens within the block for simultaneous sectioning, staining and examination.     

LP-BM5 virus causes changes in lactic dehydrogenase and oxygen radical production in splenocytes of C57BL/6J mice

The LP-BM5 murine leukemia virus causes acquired immunodeficiency syndrome in C57BL/6J mice (MAIDS), similar to that of AIDS in humans. The objective of this study was to determine the effect of LP-BM5 viral infection on cellular activation and membrane integrity of splenocytes. Oxidative burst in splenocytes in response to exposure to PMA (20 microg/ml) was significantly higher (p<.02) in infected than in control mice at two weeks post-infection using luminol-enhanced chemiluminescence. By 13 weeks post-infection superoxide anion production in infected mice was significantly lower when compared to controls coinciding with decreased proliferative response to mitogens. The extent of cell membrane damage as indicated by lactic dehydrogenase (LDH) activity in serum was significantly higher in infected than in control mice (p<.001). The results from this study suggests that LP-BM5 virus causes an initial stimulation of cellular activity followed by a decreased cell activation characterized by decreased proliferation of splenocytes and decreased oxygen radical production. Decreased cell membrane integrity indicated by increased LDH activity may partly be responsible for these changes.     

A PMLRARalpha transgene initiates murine acute promyelocytic leukemia

The malignant cells of acute promyelocytic leukemia (APL) contain a reciprocal chromosomal translocation that fuses the promyelocytic leukemia gene (PML) with the retinoic acid receptor alpha gene (RAR alpha). To test the hypothesis that the chimera PMLRAR alpha plays a role in leukemogenesis, we expressed a PMLRAR alpha cDNA in myeloid cells of transgenic mice. PMLRAR alpha transgenic mice exhibited impaired neutrophil maturation early in life, which progressed at a low frequency over the course of several months to overt APL. Both the preleukemic state and the leukemia could be transplanted to nontransgenic mice, and the transplanted preleukemia could progress to APL. The APL recapitulated features of the human disease, including a response to retinoic acid. Retinoic acid caused the leukemic cells to differentiate in vitro and in vivo, eliciting remissions of both the preleukemic state and APL in mice. Our results demonstrate that PMLRAR alpha impairs neutrophil differentiation and initiates the development of APL. The transgenic mice described here provide an apparently accurate model for human APL that includes clear evidence of tumor progression. The model should be useful for exploring the molecular pathogenesis of APL and the mechanisms of the therapeutic response to retinoic acid, as well as for preclinical studies of therapeutic regimens.     

Application of HUMF13A01 (AAAG)n STR polymorphism to the genetic diagnosis of coagulation factor XIII deficiency

Deficiency of the A subunit of coagulation factor XIII causes a severe bleeding disorder requiring life long replacement therapy. The mutations causing A subunit deficiency appear to be very heterogeneous, and it is impractical to identify each mutation before genetic counselling or prenatal diagnosis can be attempted. In this study we have shown that a highly polymorphic short tandem repeat element, HUMF13A01 (AAAG)n that occurs in the 5' flanking sequence of the factor XIII A subunit gene, can be used to follow the segregation of deficiency causing mutations. We studied 6 families with factor XIII A subunit deficiency from 5 different ethnic groups. All parents were heterozygous for the repetitive element and therefore all the families were informative. The linked polymorphism was used to carry out the first prenatal diagnosis of factor XIII A subunit deficiency. The analysis of this polymorphism by the polymerase chain reaction is rapid, reliable, requires little DNA and is ideal for the genetic analysis of factor XIII A subunit deficiency.     

Preparative isoelectric focusing in multicompartment electrolyzers: novel, hydrolytically stable and hydrophilic isoelectric membranes

Preparative isoelectric focusing in multicompartment electrolyzers is based on the production of isoelectric membranes of precise isoelectric point, able to buffer at their pI value and to titrate proteins tangent to or crossing the membranes. Up to the present, such membranes have been based on polyacrylamide chemistry; acrylamide, however, is neither stable in acidic nor basic environments. We describe here novel membranes, produced with a unique monomer, N-acryloylaminoethoxyethanol (AAEE). Poly(AAEE) membranes are extremely stable to alkaline hydrolysis (500 times more stable than polyacrylamide) and even more hydrophilic than the latter matrix. This allows production of highly reproducible membranes (these do not change their pI with time, since no acrylic acid is produced by hydrolysis upon storage) which do not adsorb proteins by hydrophobic interaction.     

Preliminary studies using hybrid mediated electrochemical oxidation (HMEO) for the removal of persistent organic pollutants (POPs).

This study investigates the hybrid mediated electrochemical oxidation (HMEO) technology, which is a newly developed non thermal electrochemical oxidation process for organic destruction. A combination of ozone and ultrasonication processes to the mediated electrochemical oxidation (MEO) process is termed as hybrid mediated electrochemical oxidation. The electrochemical cell was developed in this laboratory. In the present study, several organic compounds, such as phenol, benzoquinone and ethylenediaminetetraacetic acid (EDTA), were chosen as the model organic pollutants to be destructed by the hybrid process. The organic destruction was monitored based on the CO2 generation and total organic carbon (TOC) reduction. The HMEO process was found to be extremely effective in the destruction of all the target organics chosen in this study. The information obtained from this study will provide an insight in adopting this technique for dealing with more recalcitrant organics (POPs).     

Axisymmetric extrusion through adaptable dies—Part 1: Flexible velocity fields and power terms

An adaptable die is one that not only produces the correct geometrical shape, but also is designed through an adaptable method to impart other desirable properties to the product or process. In this first part of a series of papers, six kinematically admissible velocity fields are developed for use in upper bound models for axisymmetric extrusion through various dies, including extrusion through adaptable dies. Three base velocity fields are presented:

(1) assuming proportional angles in the deformation zone,

(2) assuming proportional areas in the deformation zone, or

(3) assuming proportional distances from the centerline in the deformation zone.

The base velocity is modified by an additional term comprised of two functions. One function allows extra flexibility in the radial direction, and the second function allows extra flexibility in the angular direction. There are two forms of the second function, which meet the required boundary conditions. The flexibility function in the radial direction is represented by a series of Legendre polynomials, which are orthogonal over the deformation region. The power terms derived for these velocity fields for use in upper bound models are also presented.Part 2 of this series compares the results obtained in upper bound models for the six velocity fields for a spherical extrusion die. In Part 3, the use of the best velocity field for extrusion through streamlined dies is developed to determine the adaptable die shape, which minimizes the required extrusion pressure. Additionally, the adaptable die shape is compared with results from Yang and Han for arbitrarily curved and streamlined dies.