Usefulness of classification and index properties of clay-rich sediments in evaluating sea-bed environmental conditions

A comprehensive study of undisturbed, mostly silty clay samples, taken from large-diameter surface cores collected in the North Atlantic and its bordering seas, shows that measurement of the Atterberg limits, water content, specific gravity of grains and grain-size distribution can provide the basis for predicting many seabed geotechnical and geophysical properties which can lead to a quick assessment of environmental conditions. Thus, the sediment compression curve can be reconstructed, acoustic properties assessed, electrical and thermal resistivities deduced and an indication of the shearing forces, which have affected the sediment, inferred.     

Deep-Sea Sediment Compression Curves: Some Controlling Factors, Spurious Overconsolidation, Predictions, and Geophysical Reproduction

Oedometer tests have been carried out on 70 undisturbed surficial clays (at approximately 250 mm below the mudline), mostly collected by free-fall corers from sites widely scattered throughout the deep-sea North Atlantic. Acoustic measurements were also made, initially on contiguous samples and ultimately on the same sample using a geophysically instrumented oedometer which also collected electrical resistivity data. Apart from those quiescent areas below the carbonate compensation depth, such as north of the West Indies where very fine clays exist, most of the samples are silty clays whose geotechnical-geophysical properties are dependent on the type of clay minerals present (and their ability to take in moisture), the sand-size fraction, and the quantity of carbonate present. Thus the pure clays have high compressibilities which decrease on the addition of coarse particles, while the converse is true for the acoustic parameters, these increasing with the sand fraction. Using the notion of the intrinsic compression line for all samples, and comparison to it of the measured compression curves, it is clear that, contrary to some previously held ideas, most deep-sea clays are normally consolidated; the addition of carbonate has the effect of creating an open, stronger sediment skeleton. Interestingly, where information is available, the variation with depth of a sample's acoustic velocity follows the void ratio pressure relationship of the compression curve. This allows the construction of an in-situ sediment compression curve using the in-situ geophysical observations.     

The cosmic ray energy spectrum between 10 and 10 eV

The energy spectrum of cosmic rays with primary energies between 10¹⁴ eV and 10¹⁶ eV has been studied with the CASA-MIA air shower array. The measured differential energy spectrum is a power law (dj/dE ∝ E^−y) with spectral indices γ of 2.66±0.02 below approximately 10¹⁵ eV and 3.00±0.05 above. A new method is used for measuring primary energy derived from ground-based data in a compositionally insensitive way. In contrast with some previous reports, the “knee” of the energy spectrum does not appear sharp, but rather a smooth transition over energies from 10¹⁵ eV to 3.0 × 10¹⁵ eV.     

The morphology and behaviour of larvae of some intertidal sponges

The morphology, swimming behaviour, settlement preferences and behaviour of five species of Demospongiae are described. The sponges, Haliclona sp., Microciona coccinea, Ophlitaspongia seriata, Mycale macilenta, and Halichondria moorei, are all common in the intertidal region in the north of New Zealand. The view is put forward that larval behaviour must be interpreted in terms of the known ecological situation of the adult sponge.     

Evaluating regional climate model estimates against site-specific observed data in the UK

This paper compares precipitation, maximum and minimum air temperature and solar radiation estimates from the Hadley Centre’s HadRM3 regional climate model (RCM), (50 × 50 km grid cells), with observed data from 15 meteorological station in the UK, for the period 1960–90. The aim was to investigate how well the HadRM3 is able to represent weather characteristics for a historical period (hindcast) for which validation data exist. The rationale was to determine if the HadRM3 data contain systematic errors and to investigate how suitable the data are for use in climate change impact studies at particular locations. Comparing modelled and observed data helps assess and quantify the uncertainty introduced to climate impact studies. The results show that the model performs very well for some locations and weather variable combinations, but poorly for others. Maximum temperature estimations are generally good, but minimum temperature is overestimated and extreme cold events are not represented well. For precipitation, the model produces too many small events leading to a serious under estimation of the number of dry days (zero precipitation), whilst also over- or underestimating the mean annual total. Estimates represent well the temporal distribution of precipitation events. The model systematically over-estimates solar radiation, but does produce good quality estimates at some locations. It is concluded that the HadRM3 data are unsuitable for detailed (i.e. daily time step simulation model based) site-specific impacts studies in their current form. However, the close similarity between modelled and observed data for the historical case raises the potential for using simple adjustment methods and applying these to future projection data.     

The inception and early evolution of the North Alpine Foreland Basin, Switzerland

The stratigraphy of the Eocene-Miocene peripheral foreland basin in Switzerland consists of basal deposits of Nummulitic Limestones and Globigerina Marls representing a phase of deepening, followed by two shallowing-up megacycles culminating in fully continental sedimentation. The onset of sedimentation was diachronous and took place on an unconformity surface with increasing stratigraphic gap to the north and west. In the Ultrahelvetic units, which were derived from the south and have a provenance between the Helvetic shelf and the Penninic ocean, the stratigraphic gap is minimal. This restricts the initiation of erosion of the southern European margin due to emersion to post-Maastrichtian and pre-late Palaeocene. This coincides with the final closing of the Valais trough and may therefore be interpreted as the point at which continental flexure s. s. started. In the autochthon, the subcrop map of the unconformity surface shows that the regional pattern of subcropping units is oblique to both neo-Alpine tectonic structures and Helvetic (Mesozoic) passive margin structures. There are local zones of disruption to the broad regional pattern suggesting that the basal unconformity was corrugated. Both the paliaspastic restoration of the autochthon relative to the thrust front during the Palaeocene, and the regional pattern of erosion indicate that the basal unconformity may be due to erosion of a flexural forebulge. Following deposition of the shallow water Nummulitic Limestones and the deeper water Globigerina Marls, clastic sediments were shed from the orogenic wedge in the south. These turbidites, the Taveyannaz Sandstones, filled both ponded basins at the contemporaneous thrust front and the frontal trench or foredeep. Evidently, early thrusts drove at a shallow level into the embryonic basin as ‘front-runners’, whereas most shortening and uplift continued to take place within the main part of the orogenic wedge further to the south. Eventually, the frontal palaeohighs, together with the turbidite basins, were buried by the northward emplacement of surface mud-slides, and sediment depocentres were translated northwards onto the foreland. The most likely cause of the underfilled ‘Flysch’ stage is the rapid advance of a submarine thrust wedge over the flexed European plate which resulted in (i) low sediment fluxes and (ii) high subsidence rates associated with the rapid migration of the load and depocentre. Later, as the rate of advance slowed and the wedge became subaerially exposed, the basin rapidly filled with coarse-grained detritus representing the ‘Molasse’ stage.     

Re-evaluation of lead isotopic data,southern Massif Central,France

Three independent Pb isotope homogenizing processes operating on large volumes of rock material during limited intervals in the Phanerozoic have been used to define a unique evolutionary curve for rock and ore lead isotopic compositions of the southern Massif Central, France. The model is