Controlled tracking in urban terrain: Closing the loop

We investigate the challenging problem of integrating detection, signal processing, target tracking, and adaptive waveform scheduling with lookahead in urban terrain. We propose a closed‐loop active sensing system to address this problem by exploiting three distinct levels of diversity: (1) spatial diversity through the use of coordinated multistatic radars; (2) waveform diversity by adaptively scheduling the transmitted waveform; and (3) motion model diversity by using a bank of parallel filters matched to different motion models. Specifically, at every radar scan, the waveform that yields the minimum trace of the one‐step‐ahead error covariance matrix is transmitted; the received signal goes through a matched‐filter, and curve fitting is used to extract range and range‐rate measurements that feed the LMIPDA‐VSIMM algorithm for data association and filtering. Monte Carlo simulations demonstrate the effectiveness of the proposed system in an urban scenario contaminated by dense and uneven clutter, strong multipath, and limited line‐of‐sight.     

Enhanced optoelectronic properties of Ti-doped ZnO nanorods for photodetector applications

We report the effect of Ti-doping on structural, morphological, photoluminescence, optical and photoconductive properties of ZnO thin films. Pure and Ti(1, 3 and 5%)-doped ZnO thin films are deposited by the successive ionic layer adsorption and reaction (SILAR) method. The X-ray diffraction analysis revealed the single-phase hexagonal wurtzite ZnO structure of all the films. Scanning electron microscope images suggest the formation of rod shaped particles in Ti-doped ZnO thin films. Photoluminescence spectra of all the films show emission peaks centered at 398 nm, 413 nm, 438 nm, 477 nm and 522 nm wavelengths. Optical properties support the semiconducting nature of all the films. The optical bandgap values are estimated to be 3.29 eV, 3.26 eV, 3.19 eV and 3.23 eV for ZnO, ZnO:Ti(1%), ZnO:Ti(3%) and ZnO:Ti(5%) thin films, respectively. Photoconductivity study indicates that ZnO:Ti(3%) thin film exhibits high responsivity, external quantum efficiency and detectivity of 0.30 AW^-1, 97% and 5.49 × 10¹⁰ Jones, respectively, among all the films. The enhanced photoconductivity of Ti-doped ZnO thin films make them useful for optoelectronic applications.     

Effect of a single hemodialysis session on inflammatory markers

Inflammation is a common feature of end-stage renal disease. Although there is evidence for hemodialysis (HD)-induced inflammatory process, the effect of a dialysis session on changes in inflammatory markers is still unclear. Seventeen patients of end-stage renal disease on maintenance HD along with 20 age-matched and sex-matched healthy controls were recruited after informed consent. C-reactive protein (CRP) and lipoprotein-associated phospholipase A2 (LpPLA2) activity were measured in the study and control groups. Intradialytic in CRP and LpPLA2 were studied. Comparison of pre-HD vs. the control group and predialytic and postdialytic values was performed using the Mann-Whitney U test and Wilcoxon's test, respectively. Statistical evaluation of intradialytic changes in inflammatory markers was performed using Friedman's test. Hemodialysis patients had higher CRP levels compared with controls (P=0.001). Post-HD LpPLA2 activity (n=17) was higher (P=0.039) compared with the pre-HD activity. Intradialytic changes in inflammatory markers showed a significant increase (P=0.012) in LpPLA2 activity (n=7), while no change (P=0.133) was observed in CRP levels (n=17). Evidence on the pro-inflammatory state being initiated by dialysis is provided by increased LpPLA2 activity. This may add to the atherogenic mileu and cause endothelial dysfunction in this high-risk group. Drugs that inhibit the LpPLA2 pathway have been developed and may be effective in these patients.     

Pure shear horizontal SAW biosensor on langasite

The undetected introduction of pathogens into food or water supplies can produce grave consequences in terms of economic loss and human suffering. Sensitive and selective sensors capable of quickly detecting microbial pathogens are urgently needed to limit the effects of bioterrorist incidents, accidents, or pollution. Shear horizontal surface acoustic wave (SH SAW) devices provide an attractive platform for the design of microbial biosensors that function in liquid media, where Rayleigh-type modes are rapidly attenuated. This paper reports on an exploratory SH SAW delay line designed and fabricated on langasite, La3Ga5SiO14 (LGS), along the novel Euler propagation direction (0 degrees, 22 degrees, 90 degrees). A liquid chamber was fabricated and attached to the top surface, and the device was submitted to liquid and biochemical tests. Moderate (6 dB) additional attenuation of the transmission coefficient, /S21/, was consistently observed when the SH SAW delay line was assembled in the test fixture and submitted to the liquid tests, indicating that LGS is an attractive candidate for liquid sensing. Sensor selectivity can be achieved by integrating the LGS SH SAW delay line with a biochemical recognition layer. A test setup was implemented for the characterization of LGS SH SAW-based biosensors. The delay line response to biomolecule binding was shown by detection of sequential binding of proteins to the SH SAW device delay path. The biotinylated sensor was exposed sequentially to biotin-binding deglycosylated avidin, biotin-modified rabbit IgG, and goat anti-rabbit IgG antibody. As each protein was bound to the sensing surface, marked changes in the delay-line phase were recorded. The reported results demonstrate the capability of these devices to act as biochemical detectors in aqueous solutions, and this work represents the first effort using the novel material LGS in SAW-based biosensor technology.     

Experimental study of the wake interaction between two vertical axis wind turbines

Wakes and wake interactions in wind turbine arrays diminish energy output and raise the risk of structural fatigue; hence, comprehending the features of rotor–wake interactions is of practical relevance. Previous studies suggest that vertical axis wind turbines (VAWTs) can facilitate a quicker wake recovery. This study experimentally investigates the rotor–wake and wake–wake interaction of VAWTs; different pitch angles of the blades of the upwind VAWT are considered to assess the interactions for different wake deflections. With stereoscopic particle image velocimetry, the wake interactions of two VAWTs are analysed in nine distinct wake deflection and rotor location configurations. The time-average velocity fields at several planes upwind and downwind from the rotors are measured. Additionally, time-average loads on the VAWTs are measured via force balances. The results validate the rapid wake recovery and the efficacy of wake deflection, which increases the available power in the second rotor.     

Preparation and characterization of core‐shell nanoparticles containing poly(chlorotrifluoroethylene‐co‐ethylvinylether) as core

Core shell latex particles with a glassy core and a low T_g polymeric shell are usually preferred. More so, the glassy core happens to be a fluoropolymer with a shell polymer that helps in processability. We describe here the preparation and characterization of core shell nanoparticles consisting of poly(chlorotrifluoroethylene‐co‐ethylvinylether) as core encapsulated in poly(styrene‐acrylate) copolymer shell using seeded emulsion polymerization method under kinetically controlled monomer starved conditions. Properties of the emulsion using surfactants (fluoro/conventional) and surfactant free conditions were investigated. Average size (100 nm), spherical shape and core–shell morphology of the latex particles was confirmed by dynamic light scattering and transmission electron microscopy. Absence of C? F and C? Cl peaks in X‐ray photoelectron spectroscopy proves that cores are completely covered. Polymerization in the presence of fluorocarbon surfactant was found to give optimum features like narrow size distribution, good shell deposition and no traces of agglomeration. Films of core shell latex particles exhibited improved transparency and enhanced water contact angles thus making them suitable for applications in various fields including coatings. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2011