Improved column-switching liquid chromatographic method for the determination of the enantiomers of mefloquine

A liquid chromatographic method for the determination of the enantiomers of mefloquine has been improved. The chromatography involved two columns: an achiral cyanopropyl stationary phase for the quantification of (+/-)-mefloquine and a chiral naphthyl-urea stationary phase for the determination of the enantiomeric ratio. Compared with the previous method, which needed two detectors, this one used one detector-integrator to which the two columns are connected alternately by an automated column-switching system. The method is suitable for the quantification (0.05 microgram/ml) of mefloquine and the determination of enantiomeric ratios from 500-microliters plasma samples with ultraviolet detection.     

Extending the power line LAN up to the neighborhood transformer

This article reports on the performance of audio, video, multimedia, and other high-data-rate in-home networking applications. The article starts by describing the problems encountered in power line communication channels in terms of frequency response and noise characteristics, and explains how in-home power line LANs can be extended to the neighborhood transformer. OFDM physical layers providing speeds of 45 Mb/s and 200 Mb/s as well as QoS and security are introduced. Finally, the results of large tests involving several thousands of nodes are described.     

Renal duplex scanning: correlation with angiography and isotopic renography

The purpose of this study was to assess the accuracy of Duplex scanning in detecting renovascular disease and to compare it with angiography, renal scintigraphy and captopril test for plasma renin activity and isotopic renography. A Duplex scan was performed in 92 renal arteries (46 patients) and compared to angiography. Three degrees of stenoses were established: 0-60%, 61-99% and occlusion. The peak systolic velocity (PSV) in the renal artery and its ratio to the peak velocity in the aorta (RAR) were used to discriminate stenoses > 60%. PSV in the interlobar arteries was used to assess the relative perfusion of both parenchyma. Angiography demonstrated a stenoses > 60% in 23 hypertensive patients. In all of the patients, plasma renin activity was measured and isotopic renograms (pre- and post-captopril) obtained in order to discriminate hypertension of vascular origin. A PSV in the renal artery > 210 cm/s and a RAR > 3.5 were found to be the diagnostic criteria with the best sensitivity and specificity in detecting stenoses > 60%. Based on these data, Duplex correctly identified 49/54 stenoses > 60%; 28/33 stenoses < 60%; and 5/5 occlusions (kappa 0.79). Sensitivity and specificity in detecting stenoses > 60% were 89.5 and 90.7%, respectively. The ratio between PSV in the interlobar arteries of both parenchyma accurately predicted the relative perfusion (ratio between DTPA uptake in both kidneys) in the isotopic test (n = 23, r = 0.91, p = 0.001). The captopril test (for plasma renin activity and isotopic renography) was positive in only five patients.(ABSTRACT TRUNCATED AT 250 WORDS)     

Analysis of the /spl Sigma/-/spl Delta/ pulsed digital oscillator for MEMS

The aim of this paper is the analysis, simulation, and experimental verification of the /spl Sigma/-/spl Delta/ pulsed digital oscillator (PDO) topology. As it has been shown in previous works, the oscillation frequency and output spectrum in the PDO depend on the sampling frequency, the natural frequency of the microelectromechanical systems (MEMS) resonator and its damping factor. Here, extensive discrete-time simulations have been carried out which show that the normalized oscillation frequency as a function of the normalized natural frequency of the resonator is very similar to a distorted Devil's Staircase fractal. This nonlinear behavior is a direct consequence of the damping losses of the MEMS resonator. Analytical conditions for a perfect oscillation at the natural frequency of the resonator are also calculated. For this set of what we call "perfect" frequencies, it is also shown that the energy transfer from the electrical to the mechanical domain is maximum. Then a more generalized structure of the oscillator is considered and the drawn conclusions are tested against experimental results obtained from an oscillator prototype which uses a MEMS resonator with thermoelectric actuation and piezoresistive position sensing.     

Applying black-box testing to UML/OCL database models

Most Unified Modeling Language (UML) computer-aided software engineering tools have been insufficient in the development process because they provide little support for conceptual model testing. Model testing aims to ensure the correctness of a UML/OCL class diagram, or, in other words, that a given class diagram can perfectly meet the user’s requirements. This study proposes the validation of class diagrams with black-box testing, a technique used to test software without focusing on the software’s implementation or structure. An approach is proposed for the automatic transformation of the constraints of a UML/OCL class diagram into test cases. Following the creation of the test cases, they are executed with JUnit and the results produced are shown to the tester. To demonstrate the applicability of this approach, an effectiveness evaluation and an efficiency evaluation are performed here. Evaluation studies show that all faults included in a class diagram have been detected within an efficient time.     

FSE–Ag complex NS: preparation and evaluation of antibacterial activity

Silver (Ag) complexes of drugs and their nanosystems have great potential as antibacterials. Recently, an Ag complex of furosemide (Ag–FSE) has shown to be a promising antimicrobial. However, poor solubility of Ag–FSE could hamper its introduction into clinics. Therefore, the authors developed a nanosuspension of Ag–FSE (Ag–FSE_NS) for its solubility and antibacterial activity enhancement. The aim of this study was to introduce a novel nanoantibiotic with enhanced antibacterial efficacy. Ag–FSE_NS was prepared by precipitation–ultrasonication technique. Size, polydispersity index (PI) and zeta potential (ZP) of prepared Ag–FSE_NS were measured by dynamic light scattering, whereas surface morphology was determined using scanning electron microscopy (SEM). In vitro antibacterial activity was evaluated against Staphylococcus aureus, Escherichia coli and Pseudomonas aeruginosa using broth microdilution method. Size, PI and ZP of optimised Ag–FSE_NS1 were 191.2 ± 19.34 nm, 0.465 ± 0.059 and −55.7 ± 8.18 mV, respectively. SEM revealed that Ag–FSE_NS1 particles were rod or needle‐like with smooth surfaces. Saturation solubility of Ag–FSE in NS increased eight‐fold than pure Ag–FSE. Ag–FSE_NS1 exhibited two‐fold and eight‐fold enhancements in activity against E. coli and S. aureus, respectively. The results obtained showed that developed Ag–FSE_NS1 holds a promise as a topical antibacterial.Inspec keywords: nanomedicine, nanofabrication, light scattering, surface morphology, silver, particle size, solubility, suspensions, scanning electron microscopy, electrokinetic effects, drugs, biomedical materials, antibacterial activity, microorganisms, nanoparticles, drug delivery systems, transmission electron microscopyOther keywords: saturation solubility, topical antibacterial, size 171.86 nm to 210.54 nm, voltage ‐47.52 mV to ‐63.88 mV, Ag, broth microdilution method, Pseudomonas aeruginosa, Escherichia coli, Staphylococcus aureus, SEM, scanning electron microscopy, surface morphology, dynamic light scattering, particle size, polydispersity index, precipitation–ultrasonication technique, nanoantibiotic, nanosuspension, furosemide, nanosystems, drugs, Ag–FSE_NS preparation, in vitro antibacterial activity, pure Ag–FSE, Ag–FSE_NS1 particles, optimised Ag–FSE_NS1, zeta potential, enhanced antibacterial efficacy, antibacterials     

Development of an automated platform for high-throughput P1-phage transduction of Escherichia coli

Synthetic biology depends on the ability to rapidly produce strains with improved phenotypes but is limited by the ability to rapidly produce strain collections with directed mutations. Here, we present a system capable of overcoming this limitation through automated P1-phage transductions of Escherichia coli. By combining the Keio collection of single-gene deletion E. coli mutants with P1-phage, it is possible to generate an engineered host-strain collection consisting of every possible gene deletion mutant. This strategy was tested by transducing 355 genetic markers from the Keio collection into five different host strains, and it achieved a 98% success rate. This method offers an improved mechanism for rapidly engineering collections of microbes and provides one method for rapidly deploying a broader synthetic biology effort.     

Indoor robot gardening: design and implementation

This paper describes the architecture and implementation of a distributed autonomous gardening system with applications in urban/indoor precision agriculture. The garden is a mesh network of robots and plants. The gardening robots are mobile manipulators with an eye-in-hand camera. They are capable of locating plants in the garden, watering them, and locating and grasping fruit. The plants are potted cherry tomatoes enhanced with sensors and computation to monitor their well-being (e.g. soil humidity, state of fruits) and with networking to communicate servicing requests to the robots. By embedding sensing, computation, and communication into the pots, task allocation in the system is de-centrally coordinated, which makes the system scalable and robust against the failure of a centralized agent. We describe the architecture of this system and present experimental results for navigation, object recognition, and manipulation as well as challenges that lie ahead toward autonomous precision agriculture with multi-robot teams.     

MOE prediction in Abies pinsapo Boiss. timber: Application of an artificial neural network using non-destructive testing

Determining the modulus of elasticity of wood by applying an artificial neural network using the physical properties and non-destructive testing can be a useful method in assessments of the timber structure in old constructions. The modulus of elasticity of Abies pinsapo Boiss. timber was predicted in this study through the parameters of density, width, thickness, moisture content, ultrasonic wave propagation velocity and visual grading of the test pieces. A feedforward multilayer perceptron network was designed for this purpose, achieving 75.0% success in the testing or unknown group.