Development of 170 GHz/500 kW gyrotron

A development of 170GHz/500kW level gyrotron was carried out as R&D work of ITER. The oscillation mode is TE_31,8. In a short pulse experiment, the maximum power of 750kW was achieved at 85kV/40A. The efficiency was 22%. In the depressed collector operation, 500kW/36%/50ms was obtained. The maximum efficiency of 40% was obtained at P_RF=470kW whereas the power decrease by the electron trapping was observed. Pulse extension was done up to 10s at P_RF=170kW with the depressed collector operation. The power was limited by the temperature increase of the output window.     

Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.     

Design optimization of tall tubular lead/acid cells based on an analysis of the reaction distribution

In order to estimate the discharge performance of tall lead/acid cells (with tubular positives), changes in current and potential distributions with discharge progress were calculated with a computer on the basis of plate resistance and the current—potential—time relationship between small facing parts of positive and negative plates. The taller the cell, the larger the voltage drop along the plates. Thus, the discharge time became shorter despite a large amount of available active mass remaining in the bottom part of the plates.Various current-collector designs were evaluated, e.g., one with varying resistance at each height; a side conductor placed along the plates and connected to them at the top, centre and bottom, etc. Results revealed an optimum collector design with which the maximum discharge capacity could be obtained. Furthermore, it was shown that the side conductor markedly improved the discharge performance because the active mass near the connecting parts was appreciably used.     

Development of a fast neutron radiography converter using wavelength-shifting fibers

A fluorescent converter for fast neutron radiography (FNR) comprising a scintillator and hydrogen-rich resin has been developed and applied to electronic imaging. The rate of the reaction between fast neutrons and the converter is increased by thickening the converter, but its opaqueness attenuates emitted light photons before they reach its surface. To improve the luminosity of a fluorescent converter for FNR, a novel type of converter was designed in which wavelength-shifting fibers were adopted to transport radiated light to the observation end face. The performance of the converter was compared with that of a polypropylene-based fluorescent converter in an experiment conducted at the fast-neutron-source reactor YAYOI in the University of Tokyo.     

Effects of cononsolvency on gelation of poly(vinyl alcohol) in mixed solvents of dimethyl sulfoxide and water

We studied the rates of gelation and phase separation of poly(vinyl alcohol) (PVA) solutions in mixtures of dimethyl sulfoxide (DMSO) and water at 25 °C and found that both the rates show a maximum at a volume fraction of DMSO φ_DMSO=0.60 while gelation was not observed either in pure DMSO or pure water, suggesting that water-DMSO is a cononsolvent system for PVA. On the basis of the data by Cowie [Can J Chem 36 (1961) 2240] we concluded that the 1:2 stable complex between one DMSO molecule and two water molecules is the main cause of this cononsolvency.     

Simultaneous measurement of the resistivity and permeability of afilm sample with a double coil

A method is proposed for a simultaneous measurement of the resistivity and permeability of a film inserted between two coils facing each other. Connecting in series, the total impedance of the coils was measured in two ways, i.e., 1) the current passes through the coils in the same direction, and 2) the current passes through each coil in opposite directions to each other. The resistivity and permeability of the film were simultaneously obtained from the difference in the impedance for the two cases. It was theoretically found that the optimum frequency for high accuracy in the measurement was proportional to the resistivity and inversely proportional to a thickness of a sample film. The results of the simultaneous measurements of the resistivity and permeability of nickel films of a thickness ranging from 0.01-0.08 mm at a frequency range of 1-100 kHz are shown in this paper. The measured values of the resistivity and permeability with this method agreed with the values obtained by conventional methods, i.e., the dc four-probe method for the resistivity measurement and the toroidal coil method for the permeability measurement     

X-ray Photoelectron Spectroscopy Investigation on the Low-Temperature Degradation of 2 mol% Y2O3-ZrO2 Ceramics

2 mol% Y₂O₃-ZrO₂ polycrystals were annealed in water and under vacuum to highlight the effect of the presence of H₂O on the low-temperature degradation transformation. The specimen surfaces with monoclinic phases transformed during annealing in the different environments were analyzed by X-ray photoelectron spectroscopy with special interest on the electron binding energy change of the constituent ions of the 2 mol% Y₂O₃-ZrO₂ ceramics after the degradation transformation. It was found that no change occurred for the electron-bonding energies of core levels of zirconium ions after the transformation, whereas Y-OH bonds were formed during annealing in water. This result suggested a possibility that the preferred hydration of yttrium took place at the surface of Y₂O₃-partially-stabilized ZrO₂, which is likely to be the reason for the low-temperature degradation accelerated by the presence of H₂O.     

UTP induces vascular responses in the isolated and perfused canine epicardial coronary artery via UTP-preferring P2Y receptors

1. Vasoconstrictor responses of the isolated and perfused canine epicardial coronary artery to uridine 5'-triphosphate (UTP) were analysed pharmacologically. 2. At basal perfusion pressure, UTP induced vasoconstriction in a dose-related manner and the vasoconstriction was sometimes followed by a slight vasodilatation at large doses (more than 10 nmol). The rank order of potency for vasoconstriction was UTP = UDP > ATP > TTP > or = ITP > UMP. At raised perfusion pressure by 20 mM KCl, the vasoconstriction was not changed and a small vasodilatation was induced at large doses. The rank order of potency for vasodilatation was induced at large doses. The rank order of potency for vasodilatation was ATP > ITP > or = UDP > UTP > or = TTP. The maximal vasodilator response to UTP was much less than that to ATP. UMP did not induce vasodilatation. 3. The P2X receptor agonist and desensitizing agent alpha, beta-methylene ATP (1 microM) and the P2 receptor antagonist suramin (100 microM) inhibited the vasoconstrictor responses to ATP but not those to UTP and UDP. The P2 receptor antagonist reactive blue 2 (30 microM) did not inhibit the vascular responses to UTP. 4. UTP (200 microM) desensitized the vasoconstrictor responses to UTP, but not either the vasodilator responses to UTP or the vasoconstrictor responses to ATP and UDP. UDP (200 microM) did not desensitize the vascular responses to UTP. 5. Preincubating the UDP stock solution and arterial preparation with hexokinase (10 and 1 uml-1, respectively) did not change the vasoconstrictor responses to UDP. 6. The Ca channel blocker diltiazem (1 microM) inhibited the vasoconstrictor responses to UTP but not those to ATP and UDP. Incubation in a Ca(2+)-free solution containing 1 mM EGTA inhibited the vascular responses to ATP, UTP and UDP. 7. Removal of the endothelium by an intraluminal injection of saponin (1 mg) inhibited the vasodilator responses to UTP. Indomethacin, a cyclo-oxygenase inhibitor (1 microM), inhibited the vasodilator responses to UTP, but NG-nitro-L-arginine, a nitric oxide synthase inhibitor (300 microM), did not have an inhibitory effect. 8. The results suggest that (1) UTP induces vasoconstriction via UTP-preferring P2Y receptors on the smooth muscle and vasodilatation via receptors different from those mediating the vasoconstriction induced by UTP and mediating the vasodilatation by ATP on the endothelium, through mainly the release of prostacyclin in the canine epicardial coronary artery; (2) UDP induces vasoconstriction via UDP-preferring P2Y receptors; and (3) L-type Ca ion channels are involved in the vasoconstriction induced by UTP, but not in that induced by UDP.     

Discharge behaviour of electrodeposited PbO2 and Pb electrodes

The discharge behaviour of electrodeposited lead dioxide and lead electrodes was investigated under various conditions; the surfaces of the discharged electrodes were observed with a scanning electron microscope. Both the positive and negative electrodes were passivated by a covering of deposited lead sulphate crystals. The amount of lead sulphate required for passivation depended on the size of the crystals.