Phase behavior in liquid crystallization for diblock copolymers consisting of rubbery amorphous and side-chain liquid crystalline components

Phase behavior in liquid crystallization was studied for a series of liquid crystalline (LC) diblock copolymers consisting of rubbery amorphous and side-chain liquid crystalline components, poly(n-butyl acrylate) (PBA) and poly[11-(4′-cyanophenyl-4″-phenoxy)undecyl acrylate] (PLC), respectively, using a time-resolved small-angle X-ray scattering (SAXS) techniques, DSC and polarized optical microscopy (POM). The block copolymers used had three kinds of copolymer compositions, 44, 20 and 15 wt% of PLC compositions (BLC44, BLC20 and BLC15, respectively). BLC44 showed a smectic liquid crystalline structure. In the process of liquid crystallization for BLC44, the SAXS peak due to the microphase separation structure existing before liquid crystallization was changed continuously to be at a smaller angular side, and at almost the same time, a new peak appeared at a further smaller angular side and developed. The former peak disappeared with the development of liquid crystallization. The behavior of these SAXS peaks suggests that the microphase separation structure was changed discretely at the transition from isotropic to smectic and that two phases coexist in the early stage of the liquid crystallization. The coexistence of two peaks in the early stage of the liquid crystallization corresponded to the POM observation. In the isotropization process, coexistence of two phases was not observed. For BLC20 exhibiting a cylindrical structure in both isotropic and liquid crystalline states, the liquid crystalline structure was not smectic but probably nematic, and the spacing was changed continuously in liquid crystallization. No liquid crystallization was observed in SAXS, POM and DSC for BLC15. The orientation of smectic layers within lamellar domains was investigated using 2D-SAXS images. The smectic layer was aligned perpendicularly to the lamellar interface.     

DNA sequence dependent binding modes of bis(vinylpyridinium)benzene derivatives

The DNA binding selectivity of new dicationic ligands based on the bis(vinylpyridinium)benzene unit has been investigated by means of UV-Vis absorption spectroscopy. From the experimental results it is concluded that these extended pi-electron bridged viologens have relatively high affinity to AT base pair sequences whereas the binding to GC pairs is about 10 times lower, and binding affinity depends on minor variation in the ligand structure. Linear type ligand exhibits two binding mode interaction, intercalation at high dye concentration which undergoes switching to groove binding at low ligand concentration.     

Construction of the plasmid PMEX8-HAK1 and random site-directed mutagenesis of human cytosolic adenylate kinase

The pMEX8-hAK1 vector was devised from the pAK plasmid (Kim J. H. et al., 1989, Protein Engineering 5, 379-386), which could directly express human adenylate kinase proteins without recombination and its single strand DNA could be withdrawn with helper phage for random site-directed mutagenesis. The conserved key residues at Lys21, Lys27, and Thr39 were engineered to obtain mutants for kinetic analysis. Three mutants were obtained as K21P, K27R, and T39S, their specific activities were strikingly reduced compared to those of wild type adenylate kinase. This pMEX8-hAK1 will be a powerful tool for site-directed mutagenesis to detect the substrate-enzyme interaction for human adenylate kinase including various other enzymes.     

Cytomegalovirus disease accompanied by severe hypoproteinemia in a patient with adult T-cell leukemia-lymphoma

A 62-year-old Japanese man complained of fever, general fatigue, anorexia and watery diarrhea during remission of adult T-cell leukemia-lymphoma. Laboratory examinations showed severe hypoproteinemia (2.9 g/dl). However, neither intestinal lesions associated with ATL nor findings suggesting protein losing gastroenteropathy were observed. Cytomegalovirus (CMV) antigen detection assay using peripheral blood leukocytes revealed that he had an active CMV infection with hemophagocytic syndrome. Treatment with ganciclovir and methylprednisolone led to an improvement of hypoproteinemia. CMV disease and associated hemophagocytic syndrome should be considered as a cause of hypoproteinemia in an immunocompromised host.     

Construction of a control system for disturbance rejection using a dual observer

A well‐known control system which can reduce the adverse effects of disturbances is a disturbance observer. However, in many cases of mechanical systems, system disturbances which do not satisfy the matching condition may be imposed. Therefore, it may be difficult to reduce the adverse effects of the disturbances by the traditional disturbance observer. In this paper, a method of control system synthesis for disturbance rejection using a dual observer is proposed. This method is based on the zeroing induced by the disturbance localization problem. This problem may be solved by dividing the state space into observable subspace and unobservable subspace. As compared with an H_∞ controller based on perfect observation, the usefulness of the proposed control system for disturbance rejection is demonstrated by numerical simulations for a two‐mass spring system. © 2002 Scripta Technica, Electr Eng Jpn, 138(4): 50–60, 2002; DOI 10.1002/eej.1138     

Intelligent manipulator system with nonsymmetric and redundant master-slave

Some work is so complicated and unsteady that it is not possible to use automatic robots, such as FA robots. In such a case, a teleoperated manipulation system is applied. In this research, the authors aim at a reduction in the operator's physical and mental burdens. An artificially intelligent manipulator system has been developed with nonsymmetric and redundant master-slave. This system has five features: (1) a polar coordinates master arm; (2) a highly operational articulated slave arm with 7 degrees of freedom; (3) a nonsymmetric configuration and different degrees of freedom master-slave control; (4) an expert system; and (5) a new master-slave control motion, which makes the operator's task easier with automatic force/position control. The system was experimentally produced and its performance tested and evaluated. A qualitative evaluation was carried out by conducting a comparative test on the conventional master-slave control and the new master-slave control. It was found to be effective in reducing operating time, as well as work-induced fatigue.     

Theory of rough surface effects on the anisotropic BCS states

We present a Green's function theory of the rough surface effects on the anisotropic BCS states using the formulation developed in the randomly rippled wall model. It is shown that the randomly rippled wall formulation is general enough to treat rough surface effects from the specular limit to the diffusive limit. We propose a statistical wall configuration such that gives the diffusive limit in the normal state. Within the weak coupling theory, we give a formal solution of the quasi-classical Green's function in a slab geometry and in a semi-infinite geometry with arbitrarily rough surfaces. The formal solution already satisfies the boundary condition. In the diffusive limit, the present theory correctly recovers the linearized gap equation obtained by Kjäldman et al. for the p-wave state in a slab geometry.     

X-ray Photoelectron Spectroscopy Investigation on the Low-Temperature Degradation of 2 mol% Y2O3-ZrO2 Ceramics

2 mol% Y₂O₃-ZrO₂ polycrystals were annealed in water and under vacuum to highlight the effect of the presence of H₂O on the low-temperature degradation transformation. The specimen surfaces with monoclinic phases transformed during annealing in the different environments were analyzed by X-ray photoelectron spectroscopy with special interest on the electron binding energy change of the constituent ions of the 2 mol% Y₂O₃-ZrO₂ ceramics after the degradation transformation. It was found that no change occurred for the electron-bonding energies of core levels of zirconium ions after the transformation, whereas Y-OH bonds were formed during annealing in water. This result suggested a possibility that the preferred hydration of yttrium took place at the surface of Y₂O₃-partially-stabilized ZrO₂, which is likely to be the reason for the low-temperature degradation accelerated by the presence of H₂O.