Area- and time-specific marginal capacity costs of electricity distribution

Marginal costs of electricity vary by time and location. In the past, researchers attributed the variations to factors related to electricity generation and transmission. These authors, however, have not analyzed possible variations in marginal distribution capacity costs (MDCC). The objectives of this paper are:

1. (i) to show that large MDCC variations are due to the dispersion in distribution capital expenditures by time and space,

2. (ii) to propose a method for quantifying the area- and time-specific MDCC in the presence of lumpy investments, and

3. (iii) to compare our MDCC estimates to those commonly used in the electric utility industry.

Our proposed method and its results were adopted by the California Public Utilities Commission (CPUC) in 1992 for Pacific Gas and Electric Company (PG&E), the largest privately owned electric utility in the U.S.     

台北101层国际金融中心之结构施工技术与其设计考量概述

本文旨在简要说明目前正在施工中之超高层大楼—台北国际金融中心之结构系统、钢结构工程、钢筋混凝土工程基础与深开挖工程等特殊施工技术,并佐以相关之设计考量与施工规划概要,以供工程界做参考。     

Effect of Wall Surface Properties at Different Drying Kinetics on the Deposition Problem in Spray Drying

Current methods in alleviating the wall deposition problem in spray drying emphasize mainly controlling the stickiness of the drying particles and less attention is placed on the properties of the dryer wall. In this experimental study, the effect of wall surface properties on the deposition mechanism has been investigated. Properties considered in classifying different wall materials were surface energy, roughness, and dielectric properties. The model solution contained sucrose, representing low-molecular-weight sugars commonly encountered in spray drying of fruit and vegetable juices. The effect of wall properties on deposition was explored at different drying rates producing particles of different surface rigidity. Larger surface roughness produced higher deposition fluxes for particles with high impact velocity and moisture. Surface energy and surface roughness were found to have no significant effect for dry rigid particles at the middle and bottom elevation of the drying chamber. However, material with lower surface energy (Teflon) exhibited less deposition for rubbery particles at such elevations. Analysis shows that dielectric wall material (Teflon) tends to enhance deposition of dry particles because of attrition at the surface. Higher wall temperature was found to produce slightly more deposition. The results of this work give a general indication of the effect of wall material on the deposition problem and provide the fundamental understanding for further studies along this line. Proper selection of dryer wall material will provide potential alternatives for reducing the deposition problem.     

Study on the c-axis preferred orientation of ZnO film on various metal electrodes

ZnO thin film was deposited on various metal electrodes by reactive sputtering, and c-axis preferred orientation of the film has been studied. ZnO, which has high piezoelectricity, is promising for oscillators or filter devices such as surface acoustic wave (SAW) device, gas sensor, and film bulk acoustic resonator (FBAR). But, for the application of ZnO film for these devices, the film should be grown with c-axis normal to the electrode. In this study, Pt, Al, and Au were deposited on Si wafer, and the surface roughness and crystal structure of the ZnO film on the electrode were investigated using AFM, scanning electron microscopy (SEM), and X-ray diffraction (XRD). Columnar structures of ZnO films were grown with c-axis normal to all electrodes, and among them Pt electrode showed the highest preferred orientation of ZnO film.     

Major internal nuclear matrix proteins are common to different human cell types

Cancer invasion and metastasis are associated with matrix degradation. We describe a novel in vivo model of invasion by squamous epithelial neoplastic cells derived from transgenic mice grown on acellular human dermis. Human dermis was subjected to multiple freeze-thaw cycles to render it acellular, maintaining the basement membrane of the former dermal-epidermal junction. Cells representing discrete stages of a multistep transgenic mouse model of epidermal carcinogenesis (neonatal transgenic keratinocytes, moderately/poorly differentiated squamous cell carcinoma, and lymph node metastasis) were seeded onto the basement membrane surface, grown in culture for 4 days, grafted in a subpannicular pocket of athymic mice, and harvested after 3 weeks. Histological analysis demonstrated that neonatal transgenic keratinocytes did not degrade the basement membrane or invade the underlying dermis. In contrast, malignant cells derived from both a moderately differentiated squamous carcinoma and a lymph node metastasis were highly invasive. Immunohistochemical analysis revealed collagenase only in nests of invading malignant cells in contact with the dermal matrix, but not in the tumor mass remaining above the basement membrane, suggesting that this proteinase may be required for stromal invasion. This novel model recapitulates the events seen in malignant invasion: transgenic keratinocytes are unable to penetrate the dermis while cells from a moderately differentiated carcinoma and from lymph node metastasis consistently invade.     

Enhanced direct stiffness method for finite element analysis of textile composites

Traditional homogenization techniques are not useful when the microstructural scale of a material is of the same order of magnitude as the structural scale of a component. Such is the case for many textile composites. Since discrete modeling of the microstructure throughout a component is prohibitively expensive, continuum finite elements are needed which account for the microstructure within a single element. This paper describes a simple substructuring technique for formulating these special elements.     

Serum amyloid P component scintigraphy and turnover studies for diagnosis and quantitative monitoring of AA amyloidosis in juvenile rheumatoid arthritis

OBJECTIVE: To evaluate aspects of the natural history of AA amyloidosis complicating juvenile rheumatoid arthritis (JRA), and its response to therapy with chlorambucil. METHODS: Scintigraphy and 7-day turnover studies were performed in JRA patients with histologically proven (n = 35) or clinically suspected (n = 30) AA amyloidosis, following intravenous injection of 123I and 125I-labeled serum amyloid P component (SAP). Prospective monitoring studies were performed over 2-3 years in 20 patients with amyloidosis. All but 2 amyloidosis patients were treated with chlorambucil. RESULTS: Positive scanning results were obtained in all patients in whom imaging was performed within 12 years of positive biopsy findings of amyloid and in 5 patients with clinically suspected amyloidosis. Negative scanning results with normal SAP metabolism, indicating regression of amyloid, were obtained in 4 patients whose amyloidosis had been in full clinical remission for more than 12 years. Prospective monitoring studies in patients whose JRA-associated inflammatory activity was in remission demonstrated regression of amyloid in 8 patients and no substantial changes in 8 others; however, in 4 further patients with active inflammation, there was accumulation of amyloid. There was a very poor correlation between the amount of amyloid present at a particular site and the resultant organ dysfunction. CONCLUSION: Radiolabeled SAP scintigraphy and turnover studies are useful complementary tools in the diagnosis, screening, and quantitative monitoring of type AA amyloidosis in JRA. The amyloid deposits may progress and/or regress at different rates in different anatomic sites over short periods.     

Flows in rectangular microchannels driven by capillary force and gravity

Capillary phenomena was studied and discussed by the scholars about 200 years ago, but the progress was slow due to the limited equipment and manufacture precision of the microchannel. In recent years, because of the rapid development of MEMS and micromachining, many applications of the capillary flow is widely developing in some modern processes, such as underfilling of flip chip, flow in microfluidic chip or biochip, and a variety of other fields.     

Compact Dipole Antenna for Terrestrial Digital Multimedia Broadcasting Service

A compact dipole antenna for the terrestrial digital multimedia broadcasting (TDMB) application is presented. The length of the antenna is about 0.06λ at the TDMB resonance frequency of 190 MHz. Miniaturization of the antenna is achieved by using meander structures and lumped elements. The proposed antenna has two resonance frequencies and covers the TDMB band from 174 MHz to 216 MHz in Korea. The antenna has good impedance bandwidth and radiation characteristics for the TDMB. The experimental results of the designed dipole antenna are presented and analyzed.