Binary Adsorption Isotherms of Water and Ethyl Acetate Vapor for Materials Contained in a Box of a Tobacco Product

An experimental study has been carried out on the characteristics of binary adsorption isotherms of water and volatile flavor for typical materials used in a box of a tobacco product or cigarettes. Ethyl acetate chosen as a model for water-soluble volatile flavor. Binary adsorption isotherms for the tobacco, papers, filters, and activated carbons were measured with a flow-type multi-component adsorption system under the canstant conditions of temperature a t 303 K and vapor pressure of water a t 2.5 kPain the vapor pressure range of ethyl acetate from 0 to 4.2 kPa. A linear equation was applied to express the binary adsorption isotherms for the tobacco, papers and filters, while a Dubinin-Astakhov equation was applied for the activated carbons. The binary adsorption was characterized into three groups, depending on the selectivity as well as the mechanism of adsorption; i.e.(l) for tobacco and papers, water was adsorbed much greater rather than ethyl acetate, (2) for filters, ethyl acetate was adsorbed on the surface as great as water, (3) for activated carbons, ethyl acetate was adsorbed much greater onto their micropores rather than water. The results showed that ethyl     

Prevention of neutrophil apoptosis by monosodium urate crystals

The effects of monosodium urate (MSU) crystals on apoptosis of cultured peripheral blood neutrophils were investigated. MSU crystals at low concentrations decreased the rate of spontaneous apoptosis of neutrophils in a dose- and time-dependent manner. The culture supernatant of MSU crystal stimulated neutrophils also promoted a delay in neutrophil apoptosis. MSU crystals at higher concentrations rapidly caused cell lysis. These findings indicated that MSU crystals are capable of amplifying the inflammatory responses of gouty arthritis by decreasing the rates of neutrophil apoptosis at lower concentrations and inducing cell lysis at higher concentrations.     

Ru-catalyzed anode materials for direct hydrocarbon SOFCs

A solid oxide fuel cell using a thin ceria-based electrolyte film with a Ru-catalyzed anode was directly operated on hydrocarbons, including methane, ethane, and propane, at 600 °C. The role of the Ru catalyst in the anode reaction was to promote the reforming reaction of the unreacted hydrocarbons by the produced steam and CO₂, which avoided interference from steam and CO₂ in the gas-phase diffusion of the fuels. The resulting peak power density reached 750 mW cm⁻² with dry methane, which was comparable to the peak power density of 769 mW cm⁻² with wet (2.9 vol.% H₂O) hydrogen. More important was the fact that the cell performance was maintained at a high level regardless of the change in the methane utilization from 12 to 46% but was significantly reduced by increasing the hydrogen utilization from 13 to 42%. While the anodic reaction of hydrogen was controlled by the slow gas diffusion, the anodic reaction of methane was not subject to the onset of such a gas-diffusion process.     

Intracoronary infusion of E6010 has more potent thrombolytic activity than tissue plasminogen activator (t-PA) in dogs: a higher plasma level of E6010 than t-PA causes potent thrombolytic activity

We examined the thrombolytic properties of a novel modified human tissue plasminogen activator (PA) (E6010), in which cysteine 84 is replaced by serine, and which has a prolonged biologic half-life (t1/2). We compared the thrombolytic efficacy of continuous intracoronary (i.c.) infusion of E6010 with that of recombinant human tissue PA (rt-PA) in a canine model with copper coil-induced 1-h-old coronary artery thrombi and also compared the relation between thrombolytic efficacy and plasma clearance represented by pharmacokinetic parameters of i.c.-infused E6010 and rt-PA. Sixty-minute E6010 and rt-PA i.c. infusions were compared. The thrombolytic effects of i.c.-infused E6010 and rt-PA, represented by time to reperfusion (TR), reperfusion rate at 60 min (RR), and reocclusion rates at 60 min after reperfusion (OR) were as follows. E6010: Dose 0.06, 0.15, 0.3 (mg/kg/h); TR 25 +/- 10, 15 +/- 10, 13 +/- 5 (min); RR 100, 100, 100 (%); and OR 0, 0, 17 (%), respectively. Recombinant t-PA: Dose 0.06, 0.15, 0.3 (mg/kg/h); TR 47 +/- 12, 18 +/- 17, 14 +/- 4 (min); RR 50, 75, 100 (%); and OR 100, 33, 33 (%), respectively. These findings indicate that E6010 has more potent thrombolytic activity than rt-PA.(ABSTRACT TRUNCATED AT 250 WORDS)     

Solid-liquid phase equilibria of benzene + 2-methyl-2-propanol system under high pressures

Solid-liquid phase equilibria of the benzene + 2-methyl-2-propanol system have been investigated at temperatures from 278 to 323 K and pressures up to 300 MPa using a high-pressure optical vessel. The uncertainties of the measurements of temperature, pressure and composition are within ±0.1 K, ±0.5 MPa, and ±0.001 mole fraction, respectively. The freezing pressure at a constant composition increases monotonously with pressure. The eutectic point shifts to a higher temperature and benzene-rich composition with increasing pressure. In order to describe the pressure-temperature-composition relation of high-pressure solid-liquid phase equilibria, a new simple equation has been proposed as follows:

A new correlation for the viscosity of gaseous fluorocarbon refrigerants

A new generalized correlation is presented for the low-pressure gaseous viscosity of fluorocarbon refrigerants. The following empirical equation is obtained based on the most reliable experimental data for 16 fluorocarbons: $$\eta \xi = \left( {0.5124T_r - 0.0517} \right)^{0.82} Z_c ^{ - 0.81}$$ where η is the viscosity in μPa·s and ξ is the viscosity parameter defined using the critical temperature T _c in K, the critical pressure P _c in MPa, and the molar mass M in g·mol^?1 as follows: $$\xi = T_c ^{1/6} M^{ - 1/2} P_c ^{ - 2/3}$$ The applicable ranges are 0.6<T _r<1.8 and 0.253<Z _c<0.282. The availability of the correlating equation for both pure fluorocarbons and their mixtures has been investigated based on the experimental data of these authors and those in the literature. It is found that the present correlation is useful for the prediction of the viscosity of pure fluorocarbons and their binary mixtures at atmospheric pressure with mean deviations less than 1.6%.     

Screening of Inhibitors Targeting Heat Shock Protein 47 Involved in the Development of Idiopathic Pulmonary Fibrosis

Heat shock protein 47 (HSP47), a collagen-specific molecular chaperone, is causally related to fibrotic diseases, including idiopathic pulmonary fibrosis. The identification of Compounds that interfere with the HSP47-collagen interaction is essential for the development of relevant therapeutics. Herein, we prepared human HSP47 as a soluble fusion protein expressed in E. coli and established an assay system for HSP47 inhibitor screening. We screened a natural and synthetic Compound library established at Nagasaki University. Among 1023 Compounds, 13 exhibited inhibitory activity against human HSP47, of which three inhibited its function in a dose-dependent manner. Epigallocatechin-3-O-gallate, one of these three Compounds, is a typical polyphenol Compound derived from tea leaves. Structurally related Compounds were synthesized and examined for their activity, revealing a hydroxyl group at A-ring position 5 as important for its activity. The present findings provide valuable insight for the development of natural product-derived therapeutics for fibrotic diseases, including idiopathic pulmonary fibrosis.     

Production of Ceramic Green Bodies Using a Microwave-Reactive Organic Binder

Because the pyrolysis of organic substances can result in the emission of harmful pollutant gases, a reduction in the use of organic binders is one aim of today's ceramics industry. A novel ceramic-forming process was developed that requires considerably less organic binder than conventional techniques. The process involves immobilizing reactive molecules on the surfaces of the particles, which on subsequent irradiation with microwaves, form bridges that bind the entire particle assembly together. The chemical forces involved produce strong bonds, resulting in a significant reduction in the amount of organic binder that is required to maintain the shape of the ceramic green body. This method will help to decrease emissions of harmful gases produced from pyrolysis of the binder.     

Technique for anisotropic extension of organic crystals: application to temperature dependence of electrical resistance

We have developed a technique for the anisotropic extension of fragile molecular crystals. The pressure medium and the instrument, which extends the pressure medium, are both made from epoxy resin. Since the thermal contraction of our instrument is identical to that of the pressure medium, the strain applied to the pressure medium has no temperature dependence down to 2 K. Therefore, the degree of extension applied to the single crystal at low temperatures is uniquely determined from the degree of extension in the pressure medium and thermal contractions of the epoxy resin and the single crystal at ambient pressure. Using this novel instrument, we have measured the temperature dependence of the electrical resistance of metallic, superconducting, and insulating materials. The experimental results are discussed from the viewpoint of the extension (compression) of the lattice constants along the parallel (perpendicular) direction.