Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

The C-N Stretching Vibronic Bands of the MgNC ÃΠ-X?Σ Transition

We have generated MgNC in supersonic free jet expansions and measured the laser-induced fluorescence excitation spectra of the C-N stretching vibronic bands of the òΠ-X?²Σ⁺ transition. Rotational analysis yields the molecular constants of the vibronic levels, (1,0,0) and (1,0,1), in the Ã²Π state. We cannot find any anomalies in the constants of these vibronic levels, while they are predicted to lie above the barrier of the isomerization reaction pathway, MgNC↔MgCN, on the Ã²Π state. On the basis of the molecular constants obtained, we discuss the fine structures of both the ground X?²Σ⁺ and excited Ã²Π states.     

Bis(pentafluorophenyl) disulfide as a hydrogen abstractor and an electron acceptor from the resulting radical intermediate

The pentafluorobenzenethiyl radical is an efficient hydrogen abstractor from an activated methylene or methine group and bis(pentafluorophenyl) disulfide is an efficient electron acceptor from the resulting radical intermediate. Thus benzyl-OTBS ether was easily converted into the corresponding pinacol, and 2-phenyl-1,3-dioxanes are converted into the monobenzoates of diols.     

Preparation and certification of the new reference materials; plastics (disk form, JSAC 0621-0625) for determination of mercury using x-ray fluorescent analysis.

The Japan Society for Analytical Chemistry has developed some new plastic certified reference materials (CRMs) for the analysis of mercury in polyester disks using XRF analysis. These CRMs (named as JSAC 0621-0625) were prepared by casting polyesters including a toluene solution of organometallic compounds as a standard. Concentrations of the five levels of mercury ranged from 0 to 250 mg/kg. Homogeneity tests of prepared disks had shown excellent results. Interlaboratory comparison study for the certification was performed by 15 laboratory participants. The z-scores in robust statistical method was applied for the evaluation of outliers. The certified values were assigned after discarding outliers. The uncertainties of certified values were determined as the confidence levels of 95%.     

Simplification and evaluation of a gold-deposited SPR optical fiber sensor.

The structure of the sensing element of a gold-deposited optical fiber sensor was simplified and quantitative analyses of various alcohols with the sensor showed improvement of the performance. The sensor uses surface plasmon resonance (SPR) at the interface of a sample solution and a thin (10 - 70 nm) gold film deposited on half of the exposed core of the optical fiber. The sensor with a film thickness of 45 nm can detect a small change of 5.6 x 10(-5) refractive index (RI) units in the refractivity. The response time is less than 0.5 min and the relative standard deviation for measurements is less than or equal to 1%. A straight line with a correlation coefficient of 0.9995 was obtained below 10%, v/v in the calibration curve for methanol solutions of benzyl alcohol. The minimum of the response curve due to the maximum excitation of SPR in the refractivity range from 1.33 to 1.44 RI units shifts to a lower refractivity as the film becomes thicker. The response curves of the sensors were calculated from SPR theoretical equations while considering of the distribution in the thickness of the deposited gold films. The improvement in the performance of the sensor is discussed.     

Thermodynamic Insight into the Origin of a Calix[n]arene-[60]fullerene Interaction and its Application to a Porphyrin-[60]fullerene Energy Transfer System

The calixarene-fullerene interaction,which causes only a slight change in the absorptionspectra, has been substantiated by calorimetricmeasurements: the H° values arecomparable with those obtained from the associationconstants estimated by a spectroscopic method. Furthermore, we determined the association constantbetween homooxacalix[3]arene and [60]fullerenederivatives with a porphyrin moiety by fluorescencespectra.     

Amino acid end-group in commercial heparin. III. Determination of the number of amino groups of amino acid and hexosamine residues per heparin molecule

The reactions of heparin with 2,4,6-trinitrobenzenesulfonic acid (TNBS) were studied spectrometrically. Seven different commercial heparins were used in this study. The amino groups react with TNBS to form equimolar amounts of trinitrophenylated (TNP) amino groups and bisulfite ions. The TNP-amino groups further react with bisulfite ions to form the monosubstituted anionic sigma complex. The absorption spectrum with two maxima at approximately 350 nm and approximately 420 nm, characteristic of either the TNP-amino groups or the complex, was analyzed for the reaction of TNBS with heparin. It was shown that the reactivities of TNBS with amino groups from α-amino acid and hexosamine residues are greatly different. By combining the results of the reaction kinetics and the reaction of heparin with Sanger's reagent, the number of the α-amino groups and the free amino groups in hexosamine residues were determined. These data have been performed with a range of heparins from different commercial sources, of different activities and physical characteristics. No correlation was found between the free amino contents of these heparins and biological potency. © 1993 John Wiley & Sons, Inc.     

Ruthenium-catalyzed anti-Markovnikov hydroamination of vinylarenes

A ruthenium-catalyzed intermolecular, anti-Markovnikov hydroamination of vinylarenes with secondary aliphatic and benzylic amines is reported. The combination of Ru(cod)(2-methylallyl)2, 1,5-bis(diphenylphosphino)pentane, and triflic acid was the most effective catalyst of those tested. Control reactions conducted without ligand or acid did not form the amine. The reaction of morpholine, piperidine, 4-phenylpiperazine, 4-BOC-piperazine, 4-piperidone ethylene ketal, and tetrahydroisoquinoline with styrene in the presence of 5 mol % of this catalyst formed the corresponding beta-phenethylamine products in 64-96% yield, with 99% regioselectivity, and without enamine side products. Acyclic amines such as n-hexylmethylamine and N-benzylmethylamine reacted with styrene in 63 and 50% yields, respectively. Alkyl-, methoxy-, and trifluoromethyl-substituted styrenes reacted with morpholine in the presence of this catalyst or a related one containing 1,1'-bis(diisopropylphosphino)ferrocene as ligand to give the products in 51-91%. Further, the hydroamination of alpha-methyl styrene was observed for the first time with a homogeneous transition metal catalyst. Preliminary mechanistic studies showed that the reaction occurred by direct, irreversible, anti-Markovnikov hydroamination and that the mechanism of the ruthenium-catalyzed hydroamination is likely to be distinct from that of the recently reported rhodium-catalyzed reaction.     

Cyclopolycondensations

Fully aromatic polyquinazolinediones of high molecular weight were prepared by the cyclopolycondensation reaction of 4,4′-diamino-3,3′-biphenyldicarboxylic acid with aromatic diisocyanates. The poly(phosphoric acid) solution polymerization techniques yielded tractable poly(urea acid), which was converted to polyquinazolinediones by thermal cyclodehydration at 300–400°C. under reduced pressure. The polyquinazolinediones thus obtained have excellent thermal stability both in nitrogen and in air. The poly(urea acid) is soluble in dimethyl sulfoxide, and films can be cast from the polymer solution of poly(urea acid) (η_inh = 0.8 to 1.8). The films are made tough by being heated in nitrogen or under reduced pressure at 300–400°C. The polymerization mechanism of the cyclopolycondensation reaction was studied, and it was established that the polymerization proceeded through the formation of tractable poly(urea acid), Structure (I), of high molecular weight, followed by cyclodehydration, yielding poly(1,2-dihydro-2-imino-4H-3,1-benzoxazin-4-one), Structure (II). On subsequently being heated this undergoes intramolecular rearrangement along the polymer chain, giving the thermodynamically stable polyquinazolinedione, Structure (III).