Positive photosensitive polyimides with cyclobutane structure

A new family of positive photosensitive polyimide (PPI) systems composed of solvent soluble polyimides (Pls) with cyclobutane (CBDA) structures and diazonaphthoquinone compounds (DNQ) has been prepared. Heat and catalytic imidizations were carried out to obtain CBDA Pls; the former was better than the latter in controlling the molecular weight of the Pl. The ? OH groups in the Pls were easily acetylated during catalytic imidization, so ? COOH groups were selected as weak acidic groups in the Pls. The ? COOH groups were also effective in giving the Pls an alkaline solubility. Therefore, Pls having ? COOH groups were superior to those having ? OH groups for PPI systems. The photosensitive properties of various PPl systems containing ? COOH were found to vary with the fraction of ? COOH groups in the Pls, the content of DNQ in the systems, and the molecular weight of the Pls.     

Temperature dependence of the exafs spectrum in YBa2Cu3O7−δ compounds

The temperature dependence of the extended X-ray absorption fine structure (EXAFS) is studied in the high T_c superconductors, YBa₂Cu₃O_7−δ. The measurements were done at the Cu K-edge for samples of two orthorhombic phases (T_c≈90 K and ≈58 K, respectively) and a nonsuperconducting tetragonal phase. Interatomic distances and mean square relative displacements σ² for Cu-O bonds are determined by the least squares refinement. The results indicate that values of σ² increase near T_c for both the orthorhombic samples. It is concluded that this anomalous behavior related to T_c is caused by an anomalous vibration of oxygen atoms in the Ba-O layer. Changes in the Cu-O distances from 300 to 20 K are not found.     

双奇核188Au的准粒子带结构研究

利用在束γ谱学实验技术, 通过¹⁷³Yb(¹⁹F,4nγ)反应 布居了¹⁸⁸Au的高自旋态, 并对其准粒子带结构进行了研究. 基于实验测量结果, 对原有的双奇核¹⁸⁸Au能级纲图做了较大的修改. 通过系统性比较, 对15⁺以上的能级结构进行了讨论.     

Charge density study under high pressure

The experimental and analytical method of the high-pressure powder experiment at BL10XU, SPring-8, is described. There is no doubt that BL10XU must be one of the most appropriate beam lines for high pressure X-ray diffraction experiment taking advantage of third generation synchrotron source. As an example of the advanced charge density study under high pressure, the structural change of Cs₂Au₂Br₆ by applying pressure is studied by Rietveld/MEM analysis. It reveals that the structural change of Cs₂Au₂Br₆ by applying pressure occurs basically at electron level, such as valence state change and chemical bonding, which may be called the electronic phase transition.     

Two-mass models of the vocal cords for natural sounding voice synthesis

Three new two-mass models of the vocal cords are treated. First, the features, structure, and differential equations of motion are described for each of the new models and compared with those of previous models. Second, performances of the models are discussed in terms of glottal volume flow, glottal area, radiated sound pressure, trajectories of mass movement, running spectra of the output sound pressure, and perceptual naturalness of the output sound. Finally, the major effects of glottal source-vocal tract interaction including skewing, truncation, and superposition are investigated, using one of the simplest types of two-mass models and two types of load representing the vocal tract.     

Copolymers containing a spiro orthoester moiety that undergo no shrinkage during cationic crosslinking

A spiro orthoester with an exomethylene group (exoSOE) was radically copolymerized with acrylonitrile or vinyl acetate at several feed ratios to obtain the corresponding copolymers having spiro orthoester moieties in the side chain. The obtained copolymers could be crosslinked via the double ring‐opening polymerization of the spiro orthoester moieties in their side chain by a treatment with BF₃OEt₂. The volume changes upon the crosslinking of the copolymers were evaluated by density measurements with a micromeritics gas pycnometer. The copolymers experienced less than 1% volume expansion instead of volume shrinkage during typical cationic crosslinking, regardless of the copolymer compositions. Negligible shrinkage was observed during the thermal cationic crosslinking of a film cast from a nitrobenzene solution of the copolymers containing a benzylthiophenium salt as a thermally latent cationic initiator. The constantly low volume changes during the crosslinking of the copolymers from exoSOE probably depended on the almost zero volume change during the cationic polymerizations of spiro orthoester derivatives. This indicates that exoSOE is an effective monomer for crosslinkable polymers without volume changes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3666–3673, 2006     

Preparation and properties of isobutylene–isoprene rubber–clay nanocomposites

Isobutylene isoprene rubber (IIR)‐clay nanocomposites have been prepared successfully by melt intercalation with maleic anhydride‐grafted IIR (Ma‐g‐IIR) and organophilic clay. In IIR‐clay nanocomposites, the silicate layers of the clay were exfoliated and dispersed into the monolayer. The nanocomposites exhibited greater gas barrier properties compared with those of Ma‐g‐IIR. When 15 phr clay was added, gas barrier properties were 2.5 times greater than those of Ma‐g‐IIR. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1182–1188, 2006     

Synthesis of copolymers containing a spiro orthocarbonate moiety and evaluation of the volume change during their cationic crosslinking

Spiro orthocarbonate (SOC) monomers having either an exomethylene group {3,3‐dimethyl‐9‐methylene‐1,5,7,11‐tetraoxaspiro[5.5]undecane (ExoSOC)} or an allyl group {9‐allyl‐3,3‐dimethyl‐1,5,7,11‐tetraoxaspiro[5.5]undecane (AllylSOC)} were radically copolymerized with vinyl monomers at several feed ratios to obtain the corresponding copolymers having SOC moieties in the side chain. The obtained copolymers were crosslinked via the double ring‐opening polymerization of the SOC moieties by a treatment with boron trifluoride etherate. The volume changes during the crosslinking of the copolymers were evaluated by density measurements with a gas pycnometer. As the SOC moiety composition increased, the volume shrinkage during the crosslinking was suppressed, and that finally changed into volume expansion. The volume changes during the crosslinking of the copolymers from AllylSOC were slightly larger than those of the copolymers from ExoSOC. The higher volume expansions in the crosslinking of AllylSOC‐based copolymers were ascribable to the lower steric hindrance around the SOC moieties. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 7040–7053, 2006     

Preparation and certification of the new reference materials; plastics (disk form, JSAC 0621-0625) for determination of mercury using x-ray fluorescent analysis.

The Japan Society for Analytical Chemistry has developed some new plastic certified reference materials (CRMs) for the analysis of mercury in polyester disks using XRF analysis. These CRMs (named as JSAC 0621-0625) were prepared by casting polyesters including a toluene solution of organometallic compounds as a standard. Concentrations of the five levels of mercury ranged from 0 to 250 mg/kg. Homogeneity tests of prepared disks had shown excellent results. Interlaboratory comparison study for the certification was performed by 15 laboratory participants. The z-scores in robust statistical method was applied for the evaluation of outliers. The certified values were assigned after discarding outliers. The uncertainties of certified values were determined as the confidence levels of 95%.