Convergence in [2+2+2] synthesis of β-phenylnaphthalene motif in polyaromatic natural products

Two optional routes to β-phenylnaphthalene structure are developed by introducing α- and β-styryl groups onto different positions in the benzocyclobutene ring followed by ring enlargement.     

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Structural characterization of polypyrrole in the solid state by high resolution 15N NMR spectroscopy [II]

The solid-state ¹⁵N CP/MAS NMR spectra and ¹⁵N spin-lattice relaxation times (T₁) of doped and dedoped ¹⁵N-labeled polypyrroles prepared by electrochemical polymerization, have been measured by means of high-resolution solid-state ¹⁵N NMR. The ¹⁵N signal of polypyrrole consists of four peaks decomposed by line shape analysis. The four peaks obtained have been assigned to the various structures of polypyrrole. Further, the half-width of the ¹⁵N NMR spectra of polypyrroles is discussed as related to the electrical conductivity. © 1995 John Wiley & Sons, Inc.     

Hückel and Möbius cyclic conjugated molecules

Generalized graphs represent Hückel-type and Möbius-type polycyclic conjugated systems. We show that the number of generalized graphs with different spectra for a given parent graph is not larger than 2 ^N(R) and is equal to 2 ^N(R) if no two rings are equivalent,N(R) being the number of rings (fundamental circuits) in the parent graph. We demonstrate that the rule for the stability of generalized graphs, proved in a previuos paper, and the information on the relative magnitudes of the effects of individual circuits enable one to predict the stabilities of generalized graphs without performing numerical calculations.     

Argon sorption and partial molar volume in poly(ethyl methacrylate) above and below the glass transition temperature

Sorption and dilation isotherms for argon in poly(ethyl methacrylate) (PEMA) are reported for pressures up to 50 atm over the temperature range 5–85°C. At temperatures below the glass transition (T_g=61°C), sorption isotherms are well described by the dual-mode sorption model; and isotherms above T_g follow Henry's law. However, isotherms for dilation due to sorption are linear in pressure at all temperatures over the range investigated. Partial molar volumes of Ar in PEMA are obtained from these isotherms. The volumes are approximately constant above T_g (about 40 cm³/mol), whereas the volumes below T_g are smaller and dependent on both temperature and concentration (19–26 cm³/mol). By analyzing the experimental data according to the dual-mode sorption and dilation model, the volume occupied by a dissolved Ar molecule and the mean size of microvoid in the glass are estimated to be 67 129 ų, respectively. The cohesive energy density of the polymer is also estimated as 61 cal/cm³ from the temperature dependence of the dual-mode parameters.     

Development and features of hydro-membrane gas chromatography.

Hydro-membrane gas chromatography (HMGC) is achieved by the annular condensation of water in a capillary column at less than 70 degrees C. The annular membrane of water is formed as a result of the wettability of the stationary phase, which is induced at a water contact angle ranging from 75 degrees to 79 degrees, as derived from a solubility parameter (delta) range of 15.7 +/- 0.3 MPa(1/2) of the coated resin. The range of the liquid to gas volume ratio (beta) required to support the annular membrane should be kept between 0.00005 and 0.0003. In the case of a 0.25-mm i.d. column, the ratio can be set by the combination of a 0.1 to 0.2 microl min(-1) water supply rate and helium gas flow rate. Separation by HMGC develops not only a gas-solid partition but also a focusing effect on the water membrane. One feature of HMGC is that it gives a non-adsorption chromatogram based on the blocking effect of pre-adsorbed water; furthermore, despite the presence of a relatively large quantity of water, the electron impact ionization efficiency is kept the same as in the usual GC/MS condition. The detection limit with the injection of 1 microl of aquatic solution was estimated to be less than 0.1 ppb of low-molecular-weight fatty acids with s/n = 5 on a mass chromatogram at m/z 45. The HMGC/EI-MS system can be applied to the trace analysis of C1 to C3 volatile acids, volatile inorganic acids, and halogenated organic acids in water.     

A convergent approach to the formal total synthesis of hemibrevetoxin B

A convergent synthesis of the key synthetic intermediate of hemibrevetoxin B was achieved via the intramolecular allylation of an α-chloroacetoxy ether and subsequent ring-closing metathesis.     

A compact optical heterodyne interferometer by optical integration and its application

A compact high-resolution optical heterodyne interferometer combining a two-frequency light module and a minute optical system is described. The light module, which generates two independent frequencies of light, is fabricated by proton exchange method on LiNbO₃ substrate. We report an experiment evaluating measurement accuracy using a micro-displacement measurement system which incorporates this interferometer. Results of the experiment with a standard thickness sample show high thermal stability with maximum measurement error of 1.8 nm at a temperature from 19°C to 33°C. The system was used to measure the hysteresis of a piezoelectric element for displacements of several nm, thereby making it possible to analyze the system quantitatively in practice.     

Compact,wide aperture X-ray preionized XeCl laser with high specific optical power

An X-ray preionized, discharge-pumped XeCl laser with a variable beam cross-section of up to 6×6 cm² is described. It uses flat electrodes and the beam width is determined by X-ray collimation. Its operation characteristics concerning reduced electric field strength (E/p) and X-ray dose are discussed in detail. The inductance of the discharge loop is minimized using a water capacitor arrangement. A very high specific optical power (90 MW/l) is achieved in an active volume of 1.2 l. The pulse energy exceeds 5 J in a 45 ns pulse (FWHM). Komatsu Ltd., Manda 1200, Hiratsuka-shi, Kanagawa 254, Japan Institute of Optics and Fine Mechanics, Department of Plasma Physics, Academia Sinica, Shanghai, P.R. China