Seismic response predictions of multi‐span steel bridges through pushover analysis

In the new trend of seismic design methodology, the static pushover analysis is recommended for simple or regular structures whilst the time‐history analysis is recommended for complex structures. To this end, the applicable range of the pushover analysis has to be clarified. This study aims at investigating the applicability of pushover analysis to multi‐span continuous bridge systems with thin‐walled steel piers. The focus is concentrated on the response demand predictions in longitudinal or transverse directions. The pushover analysis procedure for such structures is firstly summarized and then parametric studies are carried out on bridges with different types of superstructure‐pier bearing connections. The considered parameters, such as piers' stiffness distribution and pier–0.5ptdeck stiffness ratio, are varied to cover both regular and irregular structures. Finally, the relation of the applicability of pushover analysis to different structural formats is demonstrated and a criterion based on the higher modal contribution is proposed to quantitatively specify the applicable range. Copyright © 2003 John Wiley & Sons, Ltd.     

Ecological and physiological features of the mesopelagic mysid,Meterythrops microphthalma,in the Japan Sea

The abundance and vertical distribution pattern of a mysidMeterythrops microphthalma were investigated in the Japan Sea. Results from vertical hauls from 602–982 m depth to the surface around Yamato Rise in April 1987 indicated that the dominance (by biomass) ofM. microphthalma was third to fifth of major zooplankton taxa. Vertical distribution investigated at a single station in Toyama Bay in June, September and December 1986 showed that the most part of population of this mysid inhabited consistently below 250 m depth. No marked diurnal vertical migration was evident. Data on body composition and oxygen consumption rate ofM. microphthalma are presented. Water content of the body was 75.6–83.8% of wet weight, and ash was 11.4–20.4% of dry weight. Carbon, hydrogen and nitrogen were 37.9–47.5%, 6.2–7.4% and 9.4–10.1%, respectively, of dry weight. Oxygen consumption rates were 2.2–11.0µl O₂ individual^–1 hr^–1 at 0.5°C, and were directly proportional to body mass. From the comparison with the published data on epipelagic and bathypelagic mysids it is revealed that both body nitrogen composition and oxygen consumption rate expressed as adjusted metabolic rate [AMR₀₂,µl O₂ (mg body N)^–0.85 hr^–1] ofM. microphthalma are intermediate between high epipelagic and low bathypelagic levels, indicating typical mesopelagic features.     

Distributions and upward fluxes of particulate matter near bottom in the southeastern Bering Sea Shelf

Time-series measurements of temperature, salinity, suspended matter and beam attenuation coefficient () were measured at four hour intervals for about two days in June/ July 1982 in the middle shelf region and the coastal region of the southeastern Bering Sea. Current meters were also moored at the same locations.Depth-time distributions of indicated that profiles of suspended matter resulted from a combined process of resuspension of underlying sediments and sinking of suspended particles. Average-values for all measurements for particles revealed that the upward transport of particles due to resuspension formed a boundary layer, with a thickness apparently related to scalar speed. The average-profiles of the particle volume concentration were assumed to result from a balance between the sinking and diffusive flux of particles under a steady state, and the upward fluxes were calculated. Within the boundary layer, values of the upward fluxes of particulate organic matter linearly decreased with the logarithm of distance from the bottom. Fluxes of organic carbon at the upper edge of the boundary layer were 0.375 gC·m^–2·day^–1 in the middle shelf region (18 m above the bottom, bottom depth=78m) and 0.484gC·m^–2·day^–1 in the coastal region (25 m above the bottom, bottom depth=33m), and fluxes of nitrogen in both regions were 0.067 gN·m^–2·day^–1. The flux of organic carbon obtained in the middle shelf region (18 m above the bottom) agreed approximately with the flux (0.416 gC·m^–2·day^–1) calculated by substituting primary production data into the empirical equation of Suess (1980).     

Importance of intracellular Fe pools on growth of marine diatoms by using unialgal cultures and on the Oyashio region phytoplankton community during spring

We report on the ability for luxury Fe uptake and the potential for growth utilizing intracellular Fe pools for 4 coastal centric diatom isolates and in situ phytoplankton assemblages, mainly composed of diatoms. Iron uptake of the diatom isolates and natural phytoplankton assemblages in the Oyashio region during spring blooms were prevented by adding hydroxamate siderophore desferrioxamine B (DFB). After the addition of DFB, intracellular Fe in the diatom isolates supported 2.4–4.2 cell divisions with 1.2–2.6 Chl a doublings. The intracellular Fe was primarily used for cell generation rather than Chl a production, leading to a reduction in the Chl a cell quota in the Fe-starved cells with time. The metabolic properties of the Fe-starved cells with their cell morphologies were different among species or genera. An on-deck incubation experiment also exhibited 1.9 cell divisions and 0.81 Chl a doublings of phytoplankton after the addition of DFB, also indicating the preference of cell generation over Chl a production. A decrease in the level of cellular Chl a, a main light-harvesting pigment in Fe-starved diatoms, may become a superior survival strategy to protect the cells from high irradiance that can cause photo-oxidative damages through photosynthesis. Such relatively low-Fe with high-light conditions could often occur in surface waters of the Oyashio region from spring to summer.     

A growth model for a hyperiid amphipodThemisto japonica (bovallius) in the Japan Sea,based on its intermoult period and moult increment

Themisto japonica was reared at 1, 5, 8, and 12°C in the laboratory to estimate its intermoult period (IP) and increase in body length (BL) at each moulting (BL).IP was found to be a function of temperature andBL of the specimens, longerIPs being associated with lower temperature and larger specimens.BL was not affected by temperature but increased with growth of the specimens. Observations on consecutive moults indicated that one new segment was added to pleopod rami at each moulting.BLs obtained from the measurement of the segment number of pleopod rami andBL of wild specimens were slightly larger than values obtained from laboratory-raised specimens.IP data obtained from laboratory-reared specimens are combined withBL data from wild specimens to establish a growth model forT. japonica from its release from the marsupium (1.31 mmBL) to the maximum size (17 mmBL) as a function of temperature. This growth model predicts that a total of of 18 moultings is needed forT. japonica to reach the maximum size regardless of temperature, although the time needed to reach the maximum size is highly dependent on temperature. The life cycle, from the newly released larvae (1.31 mmBL) to the spent females (10–17 mmBL), was estimated as 333–593 days at 1°C, 195–347 days at 5°C, 118–210 days at 10°C and 82–146 days at 15°C; the last may be the upper temperature limit forT. japonica. Growth rates ofT. japonica expressed on the basis of body mass are comparable to the rates of euphausiids of equivalent size when the effect of temperature is accounted for. Feeding conditions ofT. japonica in the field are also discussed.     

第三部分海陆对比300000年以来的海平面变化

对于海岸演化,海平面变化是最重要的控制因素之一。300000年以来海平面历史的建立,对于理解中、晚第四纪年代学,海岸演化对现代海岸特征的影响和测量沿海地区第四纪新构造运动都是特别重要的。这个专题讨论会的目的就是根据新发展的测年手段和具有不同构造特征的各种沿海地带地貌和地质的调查,建立海平面波动的年代和幅度以     

Seismic vertical array analysis for phase decomposition

We propose a vertical array analysis method that decomposes complex seismograms into body and surface wave time histories by using a velocity structure at the vertical array site. We assume that the vertical array records are the sum of vertically incident plane P and S waves, and laterally incident Love and Rayleigh waves. Each phase at the surface is related to that at a certain depth by the transfer function in the frequency domain; the transfer function is obtained by Haskell's matrix method, assuming a 1-D velocity structure. Decomposed P , S and surface waves at the surface are estimated from the vertical array records and the transfer functions by using a least-squares method in the frequency domain; their time histories are obtained by the inverse Fourier transform. We carried out numerical tests of this method based on synthetic vertical array records consisting of vertically incident plane P and S waves and laterally incident plane Love and Rayleigh waves. Perfect results of the decomposed P , S , Love and Rayleigh waves were obtained for synthetic records without noise. A test of the synthetic records in which a small amount of white noise was added yielded a reasonable result for the decomposed P , S and surface waves. We applied this method to real vertical array records from the Ashigara valley, a moderate-sized sedimentary valley. The array records from two earthquakes occurring at depths of 123 and 148 km near the array (epicentral distance of about 31 km) exhibited long-duration later phases. The analysis showed that duration of the decomposed S waves was a few seconds and that the decomposed surface waves appeared a few seconds after the direct S -wave arrival and had very long duration. This result indicated that the long-duration later phases were generated not by multireflected S waves, but by basin-induced surface waves.