Physical model experiments for sediment supply to the old Rhine through induced bank erosion

A mobile-bed, undistorted physical model （1：40） has been used to investigate different sediment supply strategies to the Old Rhine through bank protection removal and modifications of groyne dimensions and configuration, which cause bank erosion. This trained channel was previously the main bed of the upper Rhine downstream of Basel （Switzerland）, but it has an artificially low flow regime since the construction of the Grand Canal d＇Alsace, a navigation canal, and a flow control dam at Kembs （France）. Training works and subsequent channel incision have also greatly reduced sediment transport rates and created a heavily armoured bed. The modelled pilot site has a groyne field on the left bank. Results show that the currently existing groynes at the site are not effective in creating high bank-side velocities conducive to bank erosion, even for flow rates significantly higher than the mean annual flow rate. The river bank has also proved to be more resistant than previously thought, allowing long stretches of bank protection to be safely removed. The physical model testing process has produced a new configuration for the groyne field, where two higher, larger island groynes are placed further apart than the three existing attached groynes. This innovative approach has proved effective, causing bank erosion for flow rates below the mean annual flow rate, with consistent erosion being observed. It has also been found that such a configuration does not pose a hazard for the Grand Canal d＇Alsace, which is situated next to the Old Rhine, through excessive bank erosion during high flow events.     

Influence of Electrokinetic Process on Compressibility Behaviour of Salt Affected Soils

Geotechnical and Geological Engineering - The improvement of salt affected lands is a major environmental challenge in arid and semi arid regions all over the world. Electrokinetic treatment is one...     

Sequence hierarchy in a Mesoproterozoic interior sag basin: from basin fill to reservoir scale,the Tombador Formation,Chapada Diamantina Basin,Brazil

The Tombador Formation exhibits depositional sequence boundaries placed at the base of extensive amalgamated fluvial sand sheets or at the base of alluvial fan conglomeratic successions that indicate basinward shifts of facies. The hierarchy system that applies to the Tombador Formation includes sequences of different orders, which are defined as follows: sequences associated with a particular tectonic setting are designated as ‘first order’ and are separated by first‐order sequence boundaries where changes in the tectonic setting are recorded; second‐order sequences represent the major subdivisions of a first‐order sequence and reflect cycles of change in stratal stacking pattern observed at 10² m scales (i.e., 200–300 m); changes in stratal stacking pattern at 10¹ m scales indicate third‐order sequences (i.e., 40–70 m); and changes in stratal stacking pattern at 10⁰ m scales are assigned to the fourth order (i.e., 8–12 m). Changes in palaeogeography due to relative sea level changes are recorded at all hierarchical levels, with a magnitude that increases with the hierarchical rank. Thus, the Tombador Formation corresponds to one‐first‐order sequence, representing a distinct intracratonic sag basin fill in the polycyclic history of the Espinhaço Supergroup in Chapada Diamantina Basin. An angular unconformity separates fluvial‐estuarine to alluvial fan deposits and marks the second‐order boundary. Below the angular unconformity the third‐order sequences record fluvial to estuarine deposition. In contrast, above the angular unconformity these sequences exhibit continental alluvial successions composed conglomerates overlain by fluvial and eolian strata. Fourth‐order sequences are recognized within third‐order transgressive systems tract, and they exhibit distinct facies associations depending on their occurrence at estuarine or fluvial domains. At the estuarine domain, they are composed of tidal channel, tidal bar and overlying shoreface heterolithic strata. At the fluvial domain the sequences are formed of fluvial deposits bounded by fine‐grained or tidal influenced intervals. Fine grained intervals are the most reliable to map in fourth‐order sequences because of their broad laterally extensive sheet‐like external geometry. Therefore, they constitute fourth‐order sequence boundaries that, at the reservoir approach, constitute the most important horizontal heterogeneity and, hence, the preferable boundaries of production zones. The criteria applied to assign sequence hierarchies in the Tombador Formation are based on rock attributes, are easy to apply, and can be used as a baseline for the study of sequence stratigraphy in Precambrian and Phanerozoic basins placed in similar tectonic settings.     

Textural evidences for dissolution of silica-rich rocks of the Ypresian phosphatic series,Gafsa-Metlaoui basin,southwestern Tunisia: implication of biogenic silica supply on genesis of fibrous clays

The present work aimed to determine the mineralogical composition of Ypresian series and to clarify the influence of the dissolution of siliceous frustules on the genesis of fibrous clay minerals. The specimens sampled from CPG trench are mainly constituted of silica-rich rocks at Mides area located at the western part of Gafsa-Metlaoui basin. The samples were investigated using X-ray diffraction (XRD) and scanning electron microscopy (SEM) in order to determine texture of constituents. The data obtained indicate that the bulk rock samples are mainly made up of opal CT and clay minerals. The latter consists of palygorskite-sepiolite minerals associated with smectite and few amount of illite. The trend of mineralogical composition indicates that fibrous clay minerals are more concentrated at the upper part. SEM observations indicated that palygorskite mineral appears as thread-like facies, which surround foliated texture of smectite in the lower part of the Mides section, although with the low Mg activity confirmed by the absence of dolomite. But, at the upper part of the Mides section, SEM observations revealed the occurrence of siliceous frustules, which have numerous dissolved areas and replacement of carbonate tests by silica. The dissolution saturated the depositional environment with silica which is required for the formation of palygorskite and sepiolite minerals, in addition to high Mg activity confirmed by the presence of dolomite in the bulk rock, which is required basically for the formation of sepiolite. Although the genesis mode of palygorskite and sepiolite is similar with very little difference, the genesis of sepiolite needs a high alkalinity than the formation of palygorskite.     

Storm deposits and storm-generated coarse carbonate breccias on a pelagic outer shelf (South-East Basin, France)

Uppermost Jurassic limestones of the South‐East Basin (France) are organized into four facies associations that were deposited in four distinct zones: (1) peritidal lagoonal limestones; (2) bioclastic and reefal limestones; (3) pelagic lime mudstones; (4) lime mudstones/calcarenites/coarse breccias. Calcarenite deposits of zone 4 exhibit sedimentary structures that are diagnostic of deposition under wave‐induced combined flow. In subzone 4a, both vertical and lateral transitions from lime mudstone/calcarenite to breccia indicate in situ brecciation under wave‐cyclic loading. Breccias were produced by heterogeneous liquefaction of material previously deposited on the sea floor. Deposits in subzone 4a record relatively long periods (>400 kyr) of sedimentation below wave base, alternating with periods of deposition under wave‐induced currents and periods of in situ deformation. In this zone, storm waves were attenuated by wave–sediment interaction, and wave energy was absorbed by the deformation of soft sediment. With reference to present‐day wave attenuation, water depths in this zone ranged between 50 and 80 m. Landwards of the attenuation zone, in zone 3, storm waves were reduced to fair‐weather wave heights. Storm wave base was not horizontal and became shallower landwards. As a consequence, water depth and wave energy were not linearly related. On a small area of the seaward edge of subzone 4a, cobbles were removed by traction currents and redeposited in subzone 4b. There, they formed a 100‐m‐thick wedge, which prograded over 3 km and was built up by the stacking of 5‐ to 20‐m‐thick cross‐stratified sets of coarse breccia. This wedge records the transport and redeposition of cobbles by a high‐velocity unidirectional component of a combined flow. The increase in flow velocity in a restricted area is proposed to result from flow concentration in a channel‐like structure of the downwelling in the gulf formed by the basin. In more distal subzone 4c, the hydrodynamic effect of wave‐induced currents was quasi‐permanent, and brecciation by wave–sediment interaction occurred only episodically. This indicates that, seawards of the attenuation zone, hydrodynamic storm wave base was deeper than mechanical storm wave base. Uppermost Jurassic carbonates were deposited and soft‐sediment deformed on a hurricane‐dominated ramp of very gentle slope and characterized by a zone of storm wave degeneration, located seawards of a zone of sedimentation below wave base.     

On the magnetic memory phenomenon in rocks and its bearing on palaeomagnetic measurements

Summary The results of recent extensive studies on the low field hysteresis in basalts from India and East Africa and the memory phenomenon observed in some of the rocks have been found to have a direct bearing on the various parameters such asQ _n,Q _tn, stability by the A.C. field technique etc. which are of great importance in rock-magnetism. It has been found that rocks having low Curie temperature (it _c ) and not exhibiting memory phenomenon are ideally suited for palaeomagnetic studies. Also, rocks having relatively higher it _c often exhibit memory phenomenon, given inconsistent NRM directions and show an irregular behaviour on A.C. field cleaning. In using the latter rock types for palaeomagnetic work one has to take a number of precautions which are clearly brought out by the studies described in this paper.     

Franck-condon factors and -centroids for certain band systems of astrophysical molecular ions CN+ and N+2

The Franck-Condon factors and r-centroids, which are very closelyrelated to relative vibrational transition probabilities, have beenevaluated by the more reliable numerical integration procedure forthe bands of c ¹ - a ¹ and f ¹ - a ¹ systems of CN ⁺ and C ^{2 +} _u- X ^{2 +} _g and D ² _g- A ² _u systems of N ⁺ ₂ molecular ions of astrophysical interest,using a suitable potential.     

Determination of the origin of mineralization and groundwater salinity in the Adrar region in the southwest of Algeria

To some extent, the sedimentary sequence with the largest groundwater reserves in northern Sahara is marked by a certain water table level, regionally known as the "Continental Intercalaire"(CI). "Continental Intercalaire"(CI) refers to "Continental Intercalary" widely distributed among three countries. Algeria, Tunisia and Libya, which have significant potential of water resources. As it is the only water resource relatively easily accessible to the inhabitants of the Sahara, it is widely developed. The physico-chemical characteristics of statistical processing in principal component analysis(PCA) and the chemical phase measurement of groundwater in the unconfined aquifer captured by "Foggaras"(traditional system irrigation composed of well system linked by a horizontal channel from their bases) and the deep drillings located in the study area were accessible. Therefore, there were some favorable conditions for comparing the chemistry of these waters with the standards of potability established by the World Health Organization. Then, the study detected the origin of excessive mineralization and the excessive content of Na, Cl, K, Mg and Ca that originated from the leaching of the clay and carbonate layers of the "Continental Intercalaire". In addition, the enrichment in NO_2~-, NO_3~- and SO_4~(2-) was due to the excessive use of fertilizer in the whole region for shallower Foggaras waters, and this study also showed the dominant chemical facies of groundwater related to the significant abundance of these mineral salts in this thick aquifer horizon.