Generation of komatiite magma and gravitational differentiation in the deep upper mantle

The densities of silicate liquids with basic, picritic, and ultrabasic compositions have been estimated from the melting curves of minerals at high pressures. Silicate liquids generated by partial melting of the upper mantle are denser than olivine and pyroxenes at pressures higher than 70 kbar, and garnet is the only phase which is denser than the liquid at pressures from 70 kbar to at least 170 kbar. In this pressure range, garnet and some fraction of liquid separate from ascending partially molten diapirs. It is therefore suggested that aluminium-depleted komatiite with a high Ca/OAl₂O₃ ratio may be derived from diapirs which originated in the deep upper mantle at pressures from 70 kbar to at least 140 kbar (200–400 km in depth), where selective separation of pyropic garnet occurs effectively. On the other hand, aluminium-undepleted komatiite is probably derived from diapirs originating at shallower depths (< 200 km). Enrichment of pyropic garnet is expected at depths greater than 200 km by selective separation of garnet from ascending diapirs. The 200-km discontinuity in the seismic wave velocity profile may be explained by a relatively high concentration of pyropic garnet at depths greater than 200 km.     

Periodic Intrusion of Cold Water from the Pacific Ocean into the Bottom Layer of the Bungo Channel in Japan

A cold-water intrusion, called a “bottom intrusion”, occurs in the lower layer of the Bungo Channel in Japan. It is an intrusion from the shelf slope region of the Pacific Ocean margin in the south of the channel. In order to reveal the fundamental characteristics of the bottom intrusion, we conducted long-term observations of water temperature at the surface and bottom layers of the channel and 15-day current observations at the bottom of the shelf-break region. The long-term water temperature data indicated that the bottom intrusion occurs repeatedly between early summer and late autumn, and its reiteration between early and mid-summer causes a local minimum of water temperature in the lower layer in mid-summer. Moreover, the data revealed that most of the bottom intrusions occurred in neap tidal periods. The current meter recorded a bottom intrusion with a speed of approximately 15 cm⋅s⁻¹. The current meter also revealed that the intruded cold water slowly retreated back to the shelf slope region after the intrusion. This revised version was published online in July 2006 with corrections to the Cover Date.     

Response of hybrid isolation system during a shake table experiment of a full‐scale isolated building

A full‐scale 5‐story steel moment frame building was subjected to a series of earthquake excitations using the E‐Defense shake table in August, 2011. For one of the test configurations, the building was seismically isolated by a hybrid system of lead‐rubber bearings and low friction roller bearings known as cross‐linear bearings, and was designed for a very rare 100 000‐year return period earthquake at a Central and Eastern US soil site. The building was subject to 15 trials including sinusoidal input, recorded motions and simulated earthquakes, 2D and 3D input, and a range of intensities including some beyond the design basis level. The experimental program was one of the first system‐level full‐scale validations of seismic isolation and the first known full‐scale experiment of a hybrid isolation system incorporating lead‐rubber and low friction bearings. Stable response of the hybrid isolation system was demonstrated at displacement demands up to 550 mm and shear strain in excess of 200%. Torsional amplifications were within the new factor stipulated by the code provisions. Axial force was observed to transfer from the lead‐rubber bearings to the cross‐linear bearings at large displacements, and the force transfer at large displacements exceeded that predicted by basic calculations. The force transfer occurred primarily because of the flexural rigidity of the base diaphragm and the larger vertical stiffness of the cross‐linear bearings relative to the lead‐rubber bearings.     

Improved Method for Calculating Anthropogenic CO2 in the Upper Layer of the North Pacific Subtropical Gyre along 175°E

Seawater samples were collected in the North Pacific along 175°E during a cruise of the Northwest Pacific Carbon Cycle Study (NOPACCS) program in 1994. Many properties related to the carbonate system were analyzed. By using well-known ratios to correct for chemical changes in seawater, the CO₂ concentration at a given depth was back calculated to its initial concentration at the time when the water left the surface in winter. We estimated sea-surface CO₂ and titration alkalinity (TA) in present-day winter, from which we evaluated the degree of air-sea CO₂ disequilibrium in winter was. Using a correction factor for air-sea CO₂ disequilibrium in winter, we reconstructed sea-surface CO₂ in pre-industrial times. The difference between the back-calculated initial CO₂ and sea-surface CO₂ in pre-industrial times should correspond to anthropgenic CO₂ input. Although the mixing of different water masses may cause systematic error in the calculation, we found that the nonlinear effect induced by the mixing of different water masses was negligible in the upper layer of the North Pacific subtropical gyre along 175°E. The results of our improved method of assessing the distribution of anthropogenic CO₂ in that region show marked differences from those obtained using the previous back-calculation method.     

LEADAT: a MATLAB-based program for lead-210 data analysis of sediment cores

1Introduction Tracking the history of man s impact on the en-vironment, it is clear that in many places the periodof greatest impact and most dramatic transformationlies within the last 150 a (Oldfield and Appleby,1984). Many aspects of this impact can be…     

Timing of Fracture Formation and Duration of Mineralization at the Hishikari Deposit, Southern Kyushu, Japan

Abstract. The Hishikari epithermal gold deposit consists of the Honko-Sanjin zone and Yamada zone. On the basis of observed crosscutting relationships of veins, vein system in the Hishikari deposit was classified into the early and late veins. They differ from orientation, width, control by unconformity, the amount of displacement and structural features, but have similarity in gold grade and Au/Ag ratios. K-Ar ages are presented for the classified veins to clarify timing of fracturing and duration of mineralization.
Age determination revealed that the early veins in the Honko-Sanjin zone range from 0.86 to 1.11 Ma and that the late veins range from 0.73 to 0. 84 Ma. The economically most important mineralization in the Hishikari deposit occurred around 0.90 Ma in a very short period (about 0.05 million years).
The distribution of mineralization age in the whole Hishikari deposit, occurrences of slickensides and ground water temperatures imply that mineralization lasted longer in the southern part of the deposit. As compared the early veins with late veins, structural changes including width, strike, dip and vein characteristics occurred at around 0.85 Ma.     

Thermal equation of state of magnesite to 32 GPa and 2073 K

Pressure–volume–temperature relations have been measured to 32 GPa and 2073 K for natural magnesite (Mg_0.975Fe_0.015Mn_0.006Ca_0.004CO₃) using synchrotron X-ray diffraction with a multianvil apparatus at the SPring-8 facility. A least-squares fit of the room-temperature compression data to a third-order Birch–Murnaghan equation of state (EOS) yielded K₀ = 97.1 ± 0.5 GPa and K′ = 5.44 ± 0.07, with fixed V₀ = 279.55 ± 0.02 Å³. Further analysis of the high-temperature compression data yielded the temperature derivative of the bulk modulus (∂K_T/∂T)_P = −0.013 ± 0.001 GPa/K and zero-pressure thermal expansion α = a₀ + a₁T with a₀ = 4.03 (7) × 10⁻⁵ K⁻¹ and a₁ = 0.49 (10) × 10⁻⁸ K⁻². The Anderson–Grüneisen parameter is estimated to be δ_T = 3.3. The analysis of axial compressibility and thermal expansivity indicates that the c-axis is over three times more compressible (K_Tc = 47 ± 1 GPa) than the a-axis (K_Tc = 157 ± 1 GPa), whereas the thermal expansion of the c-axis (a₀ = 6.8 (2) × 10⁻⁵ K⁻¹ and a₁ = 2.2 (4) × 10⁻⁸ K⁻²) is greater than that of the a-axis (a₀ = 2.7 (4) × 10⁻⁵ K⁻¹ and a₁ = −0.2 (2) × 10⁻⁸ K⁻²). The present thermal EOS enables us to accurately calculate the density of magnesite to the deep mantle conditions. Decarbonation of a subducting oceanic crust containing 2 wt.% magnesite would result in a 0.6% density reduction at 30 GPa and 1273 K. Using the new EOS parameters we performed thermodynamic calculations for magnesite decarbonation reactions at pressures to 20 GPa. We also estimated stability of magnesite-bearing assemblages in the lower mantle.     

Transition enthalpies and entropies of high pressure zinc metasilicates and zinc metagermanates

The enthalpies of transition at T= 298 K between zinc metasilicate assemblages, measured by molten oxide solution calorimetry, are:

The partitioning of Pt-Re-Os between solid and liquid metal in the Fe-Ni-S system at high pressure: Implications for inner core fractionation

Coupled ¹⁸⁶Os/¹⁸⁸Os and ¹⁸⁷Os/¹⁸⁸Os enrichments of plume-derived lavas have been suggested to reflect contributions of materials from the outer core (Brandon et al., 1998). This hypothesis is based on the assumption that the Earth’s liquid outer core has high Pt/Os and slightly high Re/Os ratios as a result of the crystallization of the solid inner core, and shows coupled enrichments in the ¹⁸⁶Os/¹⁸⁸Os and ¹⁸⁷Os/¹⁸⁸Os ratios, reflecting the decay of ¹⁹⁰Pt and ¹⁸⁷Re to ¹⁸⁶Os and ¹⁸⁷Os, respectively. Partitioning experiments of Pt-Re-Os between solid and liquid metal were performed at 5-20 GPa and 1250-1400 °C, to examine the effects of pressure in the Fe-Ni-S system. The ratios (D_Os/D_Pt, D_Os/D_Re) of measured partition coefficients of Pt, Re and Os are almost constant with increasing pressure. D_Os/D_Pt increases significantly, whereas D_Os/D_Re decreases, with increasing sulphur content in the liquid metal. On the basis of the present experimental results, it is unlikely that the required Pt-Re-Os fractionation is generated during inner core crystallization, assuming that the light element in the Earth’s core is sulphur.     

Gold Mineralization and Occurrence of Sinter in the Hoshino Area, Fukuoka Prefecture, Japan

Abstract. Several epithermal gold deposits occur in the Hoshino area, which is located in the western end of the late Cenozoic Hohi volcanic zone, north‐central Kyushu, Japan. The area is characterized by intermediate to felsic extrusive rocks of Pliocene age. In the Hoshino area, the shallow manifestation of the hydrothermal activity is exposed on the surface. Several outcrops of sinter are still preserved on the top of hydro thermally altered volcanic rocks, and high‐grade gold‐bearing quartz veins occur on the surface at lower levels. The hydrothermal alteration resulted into well‐developed alteration zones. The zonal alteration pattern, primarily of near‐neutral pH type, is characterized by the outer smectite zone of a lower temperature, and the inner mixed layer minerals zone of a higher temperature. Quartz vein‐related or fracture‐controlled alteration, is represented by the occurrence of interstratified illite/smectite and K‐feldspar, suggesting a potassium‐enriched alteration. The mineralization in the Hoshino area is recognized on the surface by the occurrence of gold‐bearing quartz veins distributed mainly in the mixed layer minerals zone. The fracture system related to the gold mineralization is mainly characterized by NW‐SE trend. The alteration pattern and the mineralogical composition of the veins suggest that the mineralizing fluids had near‐neutral pH and the mineralization is of low‐sulfidation‐type. Fluid inclusion data and textures observed in quartz veins indicate that gold precipitated during boiling. The chemical composition of quartz veins shows that high‐grade gold‐bearing quartz veins are characterized by higher content of Al₂O₃, K₂O and Rb. Several outcrops of silica‐sinters are distributed on the top of the mixed layer minerals zone. Although their structures are not very well preserved, because of later silicification, the Hoshino sinters still show characteristic textures identical to those observed in modern sinters, such as the presence of plant fossil incorporated into the sinters, the strongly developed depositional laminations and the columnar structures perpendicular to the depositional surfaces. Quartz is the only silica mineral constituting the Hoshino sinters presently. The conversion of amorphous silica into quartz was probably governed by higher temperatures resulting from later hydrothermal activity. This later hydrothermal activity is reflected by the intense silicification affecting mainly the lower parts of the sinters and also by the presence of quartz veins cutting the sinters. The distribution of sinters in the Hoshino area is very significant. The presence beneath the sinters of concealed high‐grade gold‐bearing quartz veins should be highly considered and exploration work is strongly suggested.