Power swing analysis in a future metropolitan electric power system on a contingent trip of cryogenic high-power cables

A cryogenic power cable is expected to be capable of carrying bulk power as a main transmission line in a future metropolitan electric power system. It is important to establish a strategy of how to sustain power supply when such a highly densified power supply route trips from the network due to contingency. It is proposed here that the bulk power transmitted by the cryogenic cable could be distributed into the parallel conventional transmission lines by suitable circuit breaker operations in the system. In this process, power-flow routes are forced to be changed with a remarkable modification in the system configuration. In this paper, the power swings associated with the large power-flow change following contingent faults are analyzed by means of a transient network analyzer. It is found that the proposed system modification could be realized without any harmful power swing if the parameters in generators as well as in control devices have conventional magnitudes. It is shown also by simulations that the margin to occurrence in an unstable power swing is left sufficient even if the parameters deviate somewhat from the present magnitudes.     

Observation of cold-rolling texture and partially recrystallized texture in polycrystalline 3 pct Si-Fe by high-resolution electron backscattered diffraction

Cold-rolling texture and partially recrystallized texture of polycrystalline 3 pct Si-Fe were investigated using high-resolution electron backscattered diffraction (EBSD) method. From the measurement on a deformed grain with {211}〈011〉∼{111}〈011〉 orientations, deformation bands with {12 4 1}〈014〉 orientation were found. It turned out that the orientation rotation relationship between deformation bands and surrounding deformed grain can be explained by the activation of the slip system, which has a common slip plane with an adjacent grain. Oriented nucleation of recrystallized grains with {12 4 1}〈014〉 orientation was observed in a deformed grain with {211}〈011〉∼{111}〈011〉 orientation. Exactly the same orientation relationship that was observed between deformed grain and the deformation bands was also observed between the deformed grain and the recrystallized grain. A hypothesis that recrystallization nuclei are generated directly from the deformation bands formed by an activation of the slip system that has a common slip plane of neighboring deformed grains was proposed from the present experimental results.     

Fine structure of the supramammillary nucleus of the rat: analysis of the ultrastructural character of dopaminergic neurons

The islets of Langerhans are richly innervated, and an inhibitory effect on insulin secretion, mediated through alpha 2-adrenergic receptors, appears to be an important physiological neural modulator of beta-cell function. An alpha 2-receptor was cloned from isolated newborn rat islets using a polymerase chain reaction (PCR) approach. This receptor was shown by sequencing to be a new rat alpha 2-receptor very similar to the human alpha 2-C2 receptor. No other alpha 2-receptor subtype was identified in normal islets by the PCR using alpha 2-receptor primers. This was also the only alpha 2-receptor subtype present in the exocrine pancreas and liver. In contrast, in the beta-cell line, beta TC3, the alpha 2-C2 receptor was not detected, but the alpha 2-C4 and alpha 2-C10 receptor subtypes were detected. It is suggested that the alpha 2-C2 subtype may be the principal alpha 2-receptor mediating inhibitory autonomic nervous system activity in the gastrointestinal tract. A comparison of the rat islet, pancreas, and liver alpha 2-receptor sequences reported here with previously reported alpha 2-receptor sequences indicates that the rat islet alpha 2-receptor is not the rat alpha 2-C2 homologue previously denoted as RNG alpha 2, but is a new, fourth rat subtype with an even higher similarity to the human alpha 2-C2 receptor.     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

A novel technique for a DC brushless motor without position sensors

A dc brushless motor is a kind of synchronous motor driven by an inverter and requires sensors to detect the rotor position. As one of the methods, the induced voltages of a brushless motor have been utilized in practice. However, there are some problems in this method, e.g., the motor can obtain insufficient torque due to the low induced voltages in a low-speed range. This paper proposes a new method which controls the inverter angular frequency ω₁ by using inherent characteristics wherein the torque current i_r is almost proportional to the internal phase angle φ where the primary flux of a synchronous motor is controlled to be constant. If the parameters of a motor are given exactly, the speed regulation is quite small and the transient characteristics with high response and high starting torque are obtained. Furthermore, it is possible to operate a synchronous motor in the field-weakening range. Here, the principle of the control method and the performance characteristics of a dc brushless motor having no position sensors are discussed. The simulation and the experimental results of the tested machine show that the proposed method is very useful for practical applications.     

Autonomic nervous function of the patients with neurally mediated syncope

Although diagnosis of neurally mediated syncope (NMS) using head-up tilt (HUT) test has been established, the exact mechanism of NMS has not yet been elucidated. We evaluated beta and alpha-adrenergic function in NMS patients by pharmacological autonomic function test. The alpha-adrenergic sensitivity of NMS patients was significantly lower than that of control subjects. The patients who need low dose isoproterenol for provocation of syncope showed higher beta-adrenergic sensitivity than patients who developed syncope without isoproterenol. Thus, pharmacological autonomic function test was useful for evaluation of NMS patients.     

Effects of vitamin B6 deficiency on cytokine levels and lymphocytes in mice

The effects of vitamin B6 (B6) deficiency on cytokine levels and proportions of lymphocyte subsets in BALB/c mice were investigated. The proportion of lymphocytes from the thymus and spleen of mice given no B6, that were CD4+ CD8- T cells, was larger than in mice given B6, and the ratio of CD8+ to CD4+ T cells in the thymus of mice given no B6 was lower. The concentrations of interleukin-5 and -10 in spleen cells stimulated in vitro with concanavalin A were significantly higher in the mice with B6 deficiency, as was their plasma corticosterone concentrations. These results suggested that B6 is necessary to maintain cytokine levels and lymphoid function in the thymus and spleen of mice.     

Fast computation of computer-generated hologram using Xeon Phi coprocessor

We report fast computation of computer-generated holograms (CGHs) using Xeon Phi coprocessors, which have massively x86-based processors on one chip, recently released by Intel. CGHs can generate arbitrary light wavefronts, and therefore, are promising technology for many applications: for example, three-dimensional displays, diffractive optical elements, and the generation of arbitrary beams. CGHs incur enormous computational cost. In this paper, we describe the implementations of several CGH generating algorithms on the Xeon Phi, and the comparisons in terms of the performance and the ease of programming between the Xeon Phi, a CPU and graphics processing unit (GPU).     

Observation of 3‐D Structure of Bubbles in a Fluidized Catalyst Bed

The interface area between the bubble and emulsion phases in a fluidized catalyst bed is one of the important parameters used to analyze and design the fluidized bed reactor. We used a fast‐scanning X‐ray CT system to observe the bubble shape and structure. We then obtained the transient 2‐dimensional cross sectional gas‐phase distribution in a fluidized catalyst bed. Using image‐processing techniques, pseudo 3‐dimensional images of the bubbles were reconstructed. The bubble structure was studied based on the 3‐dimensional images and the previously obtained results in a 2‐dimensional fluidized bed. It was found that the bubble shape was not spherical but complicated, and that the bubbles ascending in a fluidized catalyst bed consisted of some smaller bubbles.