Ku波段10W功率PHEMT

报告了研制的 9.6mm栅宽双δ-掺杂功率 PHEMT,在 fo=1 1 .2 GHz、Vds=8.5 V时该器件输出功率3 7.2 8d Bm,功率增益 9.5 d B,功率附加效率 44.7% ,在 Vds=5～ 9V的范围内 ,该器件的功率附加效率均大于42 % ,两芯片合成 ,在 1 0 .5～ 1 1 .3 GHz范围内 ,输出功率大于 3 9.92 d Bm,最大功率达到 40 .3 7d Bm,功率增益大于 9.9d B,典型的功率附加效率 40 %。     

自适应RBF神经网络在CDMA移动通信上行链路功率控制中的应用研究

提出了一种自适应RBF神经网络功率控制方案。详细研究了该网络在DS-CDMA通信中，进行上行链路闭环功率控制(基于信扰比(SIR))的应用理论，给出了该网络参数的计算方法。最后用计算机仿真法模拟出该控制器的运行性能。结果表明基于SIR的自适应RBF神经网络功率控制器能自适应地调整移动台的发射功率，使基站接收信号的信扰比始终非常接近于一个常数，且有比定步长功率控制更小的SIR跟踪误差，从而可以降低接收信号的中断概率、提高信道容量。     

转动玻璃圆筒激光器

本文介绍了转动玻璃圆筒激光器的设计及实验结果,得到了脉冲能量为13J,重复频率为15Hz的激光输出。电光转换效率为2.2％,斜效率为3.4％。     

DLL23XA双侧向测井仪的研制

以往双侧向测井仪动态范围小，测量精度低，为此开发了DLL23XA双侧向测井仪。该仪器主要单元采用厚膜电路，稳定性、一致性好；深、浅屏流源采用可变功率控制，提高了仪器的动态范围。仪器采用3506P例进行数据传输，可方便地配接各种地面系统。     

多种采暖方式的特点及其选择

介绍了多种采暖方式．并对各种采暖的适用性、一次性投资、运行费用和对环境的影响作了对比，提出了选择的优先顺序，为房地产开发商和用户对于采暖方式的选择提供了参考。     

高峰值功率重频脉冲固体激光器

综述了高峰值功率重频脉冲固体激光器的发展现状，对其中的Ｑ开关、腔倒空、锁模等窄脉冲技术和放大技术进行了分析，展示了高峰值功率重频脉冲固体激光器的发展前景。     

燃煤MHD发电Cr25Al5电极材料的腐蚀行为研究

采用Ｃｒ＿（２５）Ａｌ＿５合金进行煤渣／种子条件下静态腐蚀试验（温度１３７３－１５７３ｋ，时间５０－１５０ｈｒ），试验后得出三种温度下腐蚀重量变化与腐蚀时间的关系，并借助金相显微镜、扫描电镜和俄歇分析进行有关形貌及成份分析，试验表明，温度是材料腐蚀的主要因素，在１４７３ｋ条件下材料的抗蚀性最好，Ａｌ、Ｓｉ元素在腐蚀过渡层中富集，Ｃｒ元素变化不大，但有从基体向外扩散的趋势。由此，这一材料若能进一步改进，可望在控制壁面温度的半热壁型通道中进行试验研究。     

Transient analysis of an advanced static var compensator using quad-series voltage-source PAM inverters

This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains.     

Onset of gas self-induction and power consumption after gas induction in an agitated tank

The behavior of inducted gas from liquid surface and the; power requirements in an agitated tank using a mechanical agitator are studied in order to increase the amount of gas self-induction and the gas retention time for gas absorption. A 45° six-blade downward impeller turbine was utilized in this study. Air and water, air and 40 wt% 60 wt%, and 80 wt% of glycerin water, and air and 106 cP silicon oil were employed as gas and liquid phases. Variables which were studied included geometrical factors (immersed depth of impeller, baffle with and diameter of impeller) and the physical properties of the liquid (viscosity, density, and surface tension). The correlations for the onset speed of impeller and power consumption after gas induction in the agitated tank are established from our experimental results. The amount of gas self-induction from the liquid surface in the agitated tank increases with increasing impeller diameter and speed and decreases with increasing baffle width, depth of impeller and viscosity of liquid.