锐钛型TiO2对尿素热解过程的影响

通过实验的方法收集了不同温度下纯尿素和尿素/TiO₂混合物热解后的固体残留物，使用红外光谱（IR）及气相色谱质谱联机（GC-MS）方法对这些热解残留物进行成分分析；使用热重-红外联机（TG-FTIR）技术研究尿素及三聚氰酸在有无催化剂TiO₂的情况下的热解特性及气体产物的生成规律；根据Coats-Renfern方法对尿素热解第一阶段的非等温热失重率曲线的数据进行动力学研究，建立动力学方程。结果表明，100~250℃的尿素热解残留物中主要为尿素和缩二脲，300~400℃的尿素热解残留物中主要为三聚氰酸等含氮杂环有机化合物；锐钛型TiO₂能促进尿素和三聚氰酸的热解反应，缩短其反应进程，HNCO与水蒸气在TiO₂表面易发生反应；尿素第一阶段热解的反应级数为2，单独热解时活化能为113.25kJ/mol，指前因子A为2.01×10¹¹min^-1，在催化剂TiO₂的作用下，活化能E为77.42kJ/mol，指前因子A为4.82×10⁷min^-1。     

（NH2）2CO-NH4H2PO4-H2O三元系10 ℃相平衡研究

采用等温溶解平衡法研究了三元系（NH₂）₂CO-NH₄H₂PO₄-H₂O在10 ℃时的相平衡,并采用湿渣法与X射线衍射相结合的方法鉴定了平衡固相的组成与结构。结果表明,该体系为简单共饱和型,无复盐或固溶体生成,共饱点的质量组成（以质量分数计）：尿素,40.03%;磷酸一铵,13.92%;水,46.05%。相图中有2条单变量曲线,相图被划分为4个区域：不饱和区、（NH₂）₂CO结晶区、NH₄H₂PO₄结晶区和（NH₂）₂CO-NH₄H₂PO₄混合结晶区。用Wilson方程与NRTL方程对实验数据关联计算,实验值与计算值吻合度较高,2个热力学模型计算值与实验值的RAD分别为0.37%和0.71%,RMSD分别为0.20和0.29。     

新型包膜尿素的制备及其特性的研究

以桐油为主要成膜物质制备新型包膜尿素。研究结果表明，包膜后尿素颗粒的粒径分布更加均匀，有外密封层时可在包膜尿素表面形成连续致密的包膜，包膜尿素因之获得逐步释放特性。使用溶解率和无土柱淋溶率可以评价包膜尿素的养份释放特性。     

Ammonia volatilization from urea as affected by the addition of iron pyrites and method of application

Laboratory incubations were conducted to determine the ammonia (NH₃) loss from urea as affected by the addition of coarse and ground (fine) pyrites at 1:1, 1:2 and 1:5 urea: pyrite (w/w) ratios and methods of application (surfaceapplication, incorporation and placement). Coarse pyrites (>-2mm) were not effective in reducing NH₃ loss from urea when surface applied even at the highest ratio of pyrite (15.9% vs 18.7% without pyrite). Ground pyrites (0.1–0.25 mm), in 1:1 ratio, had about 5% less NH₃ loss than the urea alone treatment. Higher ratios of pyrites reduced NH₃ loss much more. Ammonia losses were the most with surface-applied urea (18.9%) and the least (13.5%) when placed (2.5 cm) below the soil surface. Addition of ground pyrite to surface-applied urea (1:1 ratio) decreased the loss to 13.2%. Urea+pyrite placed below the soil surface had the least loss (9.8%). Results indicate that combined application of urea and fine pyrite could reduce NH₃ loss.     

Eicosapentaenoic acid (20∶5n-3) from the marine microalgaPhaeodactylum tricornutum

Eicosapentaenoic acid (EPA, 20∶5n-3) was obtained from the marine microalgaePhaeodactylum tricornutum by a three-step process: fatty acid extraction by direct saponification of biomass, polyunsaturated fatty acid (PUFA) concentration by formation of urea inclusion compounds, and EPA isolation by semipreparative high-performance liquid chromatography (HPLC). Alternatively, EPA was obtained by a similar two-step process without the PUFA concentration step by the urea method. Direct saponification of biomass was carried out with two solvents that contained KOH for lipid saponification. An increase in yield was obtained because the problems associated with emulsion formation were avoided by separating the biomass from the soap solution before adding hexane for extraction of insaponifiables. The most efficient solvent, ethanol (96%) at 60°C for 1 h, extracted 98.3% of EPA. PUFA were concentrated by the urea method with a urea/fatty acid ratio of 4∶1 at a crystallization temperature of 28°C and by using methanol and ethanol as urea solvents. An EPA concentration ratio of 1.73 (55.2∶31.9) and a recover yield of 78.6% were obtained with methanol as the urea solvent. This PUFA concentrate was used to obtain 93.4% pure EPA by semipreparative HPLC with a reverse-phase, C₁₈, 10 mm i.d.×25-cm column and methanol/water (1% acetic acid), 80∶20 w/w, as the mobile phase. Eighty-five percent of EPA loaded was recovered, and 65.7% of EPA present inP. tricornutum biomass was recovered in highly pure form by this three-step downstream process. Alternatively, 93.6% pure EPA was isolated from the fatty acid extract (without the PUFA concentration step) with 100% EPA recovery yield. This two-step process increases the overall EPA yield to 98.3%, but it is only possible to obtain 20% as much EPA as that obtained by three-step downstream processing.     

尿素生产中尿液的不稳定流动对尿素一分塔的影响

介绍了水溶液全循环法尿素生产系统中,一分塔的精馏段由泡罩塔盘改为规整填料后出现的一系列问题,针对尿液的不稳定流动造成一分塔规整填料严重腐蚀的原因,进行分析并提出整改和预防措施。     

Relationships between ammonia volatilization and nitrogen fertilizer application rate,intake and excretion of herbage nitrogen by cattle on grazed swards

Grazed pastures emit ammonia (NH₃) into the atmosphere; the size of the NH₃ loss appears to be related to nitrogen (N) application rate.The micrometeorological mass balance method was used to measure NH₃ volatilization from rotationally grazed swards on three plots in the autumn of 1989 and throughout the 1990 growing season. The aim of the research was to derive a mathematical relationship between NH₃ volatilization and N application rate, which would vary between soil type and weather conditions. In both years the plots received a total of 250, 400 or 550 kg N ha^–1 as calcium ammonium nitrate (CAN) split over 6 to 8 dressings. The number of grazing cycles ranged from 7 to 9 for the three N plots.In the last two grazing cycles of 1989, NH₃ losses were 3.8, 12.0 and 14.7 kg N ha^–1 for the 250N, 400N and 550N plots, which was equivalent to 5.3%, 13.9% and 14.4% of the amount of N excreted on the sward, respectively. In 1990, NH₃ losses were 9.1, 27.0 and 32.8 kg N ha^–1 for the 250N, 400N and 550N plots, which was equivalent to 3.3%, 6.9% and 6.9% of the N excreted, respectively. Differences in urine composition between the plots were relatively small. Rainfall and sward management affected the size of the NH₃ volatilization rate. Volatilization of NH₃ was related to N excretion and N application rate.A calculation procedure is given to enable the estimation of NH₃ volatilization from N application rate. Adjustments can be made for grazing efficiency, grazing selectivity, N retention in milk and liveweight gain, concentrate N intake and milking duration. Losses of NH₃ increase progressively with an increase in N application rate until herbage yield reaches a maximum at an application rate of about 500 kg N ha^–1 yr^–1.     

尿素嵌入法制备纤维素氨基甲酸酯的研究

探讨了尿素嵌入法制备纤维素氨基甲酸酯(CC)的生产工艺。指出:选用聚合度为450~625、α-纤维素含量大于90/的纤维素浆粕,用14/~16/的氢氧化钠溶液,于40~50℃条件下活化处理30~40min后,与尿素以1∶2~3的比例混合,在137℃的二甲苯体系中反应2~3h,便可得到含氮量为2.4/~3.5/的纤维素氨基甲酸酯产物。该产物在氢氧化钠溶液中可形成良好的稳定溶液,过滤性好,可直接用于纺丝。     

三聚氰胺的绿色生产技术

由尿素合成三聚氰胺的反应有副反应存在 ,能生成缩二脲、三聚氰酸一酰胺、三聚氰酸二酰胺和蜜勒胺等副产物。利用水溶液中的三聚氰胺在高温高压下可以完全分解的性质 ,采用国外最新开发的OAT专利技术 ,将废水中夹带的少量工艺产品和聚合物废料转化回收 ,可提高原料的利用率 ,消除水污染     

尿素合成塔腐蚀在线监测

简要介绍了尿素合成塔腐蚀在线监测技术、监测仪及其安装、使用情况。