臭氧-生物活性炭深度处理亚热带地区原水中试试验

本研究针对南方亚热带地区常规给水处理工艺下的砂滤出水，应用臭氧一生物活性炭工艺进行深度处理中试试验，经过一个水文年（12个月）的运行，结果表明：在不同的后臭氧投加量（1．0～3．0mg／L）下，随着后臭氧投加量的增加，后臭氧接触塔及炭滤池对CODMn的去除率总体上呈逐步升高的趋势；后臭氧投加量和臭氧后水浊度、炭滤池对锰的去除率有明显的相关性；当后臭氧投加量为1．8～2．0mg／L时，各项水质指标取得较好的处理效果，已无需增大投药量；系统在冬季水温较低时运行对可以生物降解的CODMn与氨氮的去除率未出现下降趋势，表明本工艺在我国南方亚热带地区有广阔的应用前景。     

Capacitive and textural characteristics of hydrous manganese oxide prepared by anodic deposition

The amorphous hydrous manganese oxide (denoted as a-MnO_x·nH₂O) was anodically deposited from the MnSO₄ solutions of various pH values. The capacitive characteristics and stability of this oxide without and with annealing in air for 2 h up to 400 °C were systematically investigated in aqueous electrolytes through means of cyclic voltammetry (CV) and the constant-current charge-discharge method. The redox properties of a-MnO_x·nH₂O were strongly affected by the electrolytes employed and this oxide exhibited ideally capacitive behavior in 0.1 M Na₂SO₄ and 0.3 M KCl. The stability of this amorphous hydrous oxide was enhanced by the annealing treatment while its capacitance was gradually decreased with increasing the annealing temperature. The amorphous structure and surface morphologies of a-MnO_x·nH₂O with annealing at different temperatures were, respectively, examined in terms of the X-ray diffraction (XRD) patterns and scanning electron microscopic (SEM) photographs. The oxidation states of these a-MnO_x·nH₂O deposits were studied by X-ray photoelectron spectroscopy (XPS).     

Liquid phase hydrodechlorination of chlorophenols over Pd/C and Pd/Al2O3: a consideration of HCl/catalyst interactions and solution pH effects

The liquid phase hydrodechlorination (HDC) of 2-chlorophenol (2-CP) and 2,4-dichlorophenol (2,4-DCP) has been studied over 1% (w/w) Pd/C and Pd/Al₂O₃ under conditions of minimal mass transport constraints. The HDC of 2,4-DCP generated HCl and 2-CP as the only intermediate partially dechlorinated product which reacts further to yield phenol; cyclohexanone was formed over Pd/Al₂O₃, but not over Pd/C, prior to complete dechlorination. Pd/Al₂O₃ is characterized (on the basis of TEM analysis) by a narrow distribution of smaller Pd particles to give a surface area weighted mean particle DIAMETER = 2.4 nm that is appreciably lower than the value of 13.2 nm established for Pd/C, where the latter is characterized by a broader distribution of larger (spherical) particles. The addition of NaOH served to increase fractional dechlorination by suppressing HDC inhibition due to the HCl that is generated. Reuse of the catalysts revealed an appreciable deactivation of Pd/C and a limited loss of activity in the case of Pd/Al₂O₃. Deactivation of Pd/C can be linked to a decrease (up to ca. 60%) in the initial BET surface area allied to appreciable leaching (up to ca. 40%) of the starting Pd content through the corrosive action of HCl and, while the average Pd diameter is essentially unaffected, there is evidence of a preferred leaching of larger Pd particles. The stronger metal/support interactions prevalent in Pd/Al₂O₃ results in limited Pd leaching and comparable initial HDC activities during catalyst reuse with/without NaOH addition. Inclusion of HCl in the reaction mixture (pH 5–1.5) resulted in a marked decline in the initial HDC rate associated with Pd/Al₂O₃ and a lesser drop in HDC activity for Pd/C. The difference in response to bulk solution pH variations are discussed in terms of the nature of the reactive species in solution and the amphoteric behavior of the Pd supports.     

电位滴定法测定重过磷酸钙中游离P2O5含量

介绍用电位滴定法测定重过磷酸钙中游离P2O5含量的方法。采用设定终点滴定,终点pH值为4.5,开始条件设置滴定前搅拌60s,最大滴定速度0.01mL/min,最小滴定速度0.005mL/min,终点前动态范围pH1.000,终点停止漂移0.02mL/min,测量点时间间隔2.0s,滴定方向选择pH值升高的方向,停止体积为成品重钙10.00mL、鲜钙20.00mL。该方法简便,快速,准确度、精密度高。     

I型运动裂纹面受双重及冲击载荷作用下的位错分布函数

通过复变函数论的方法,对I型运动裂纹面受双重载荷、瞬时冲击载荷作用下的位错分布函数问题分别进行研究．采用自相似函数的方法可以获得运动裂纹的应力、位移、应力强度因子及位错分布函数的解析解,应用该法可以迅速地将所论问题转化为Riemann-Hilbert问题,并可以相当简单地得到问题的闭合解．     

KNb3O8的制备及其光催化活性探讨

探讨了固相反应法制备类钙钛矿层状化合物KNb3O8的工艺。对该方法的合成温度、时间等工艺条件进行了详尽的研究。使用X射线衍射（XRD）、扫描电境（SEM）等测试手段对样品进行了表征，并用所制得的样品对酸性红G进行了光催化降解实验。结果表明，在900℃煅烧2h可以合成纯度较高的KNb3O8，且其具有较好的催化性能。     

微乳法制备Fe3O4磁性纳米粒子的研究

首先对油包水（W／O）型微乳液进行了制备研究，利用拟三元相图探明了一定条件下的W／O型微乳液中的最佳体系。进而利用此W／O型微乳液作为“微反应器”制备Fe3O4纳米粒子。采用TEM、XRD和IR对所制备的Fe3O4纳米粒子进行了分析表征。     

PEO／V2O5纳米复合薄膜的变色特性研究

为改善V2O5薄膜的电致变色性能，采用溶胶-凝胶法将具有高离子电导率并具有水溶性的聚环氧乙烷（PEO）直接嵌入V2O5层间，制备了PEO／V2O5纳米复合薄膜。采用标准三电极法从0．5mol／L LiClO4的PC电解质溶液向PEO／V2O5纳米复合薄膜注入锂离子，测量了纳米复合薄膜在注入不同数量锂离子时的可见光透射光谱以及对应的颜色变化，并运用循环伏安法测试其电化学性能。实验结果表明，PEO／V2O5纳米复合薄膜的循环伏安图出现了2对氧化还原峰，并且具有稳定的循环可逆性。随着应用电压的不同，薄膜呈现黄色、绿色和蓝色的多色可逆变化。PEO／V2O5纳米复合薄膜的电化学稳定性和机械性能都优于V2O5干凝胶薄膜，可以作为电致变色材料得到应用。X射线光电子能谱（XPS）成分分析表明PEO／V2O5纳米复合薄膜的电致变色效应与V、O的化合价和化学环境密切相关。     

Sensitivity enhancement for H2 gas detection using a SnO2–Ag2O–PdOx nanocrystalline system

Thick film H₂ sensors were fabricated using SnO₂ loaded with Ag₂O and PdO_x. The composition that gave highest sensitivity for H₂ was in the wt.% ratio of SnO₂:Ag₂O:PdO_x as 93:5:2. The nano-crystalline powders of SnO₂–Ag₂O–PdO_x composites synthesized by sol–gel method were screen printed on alumina substrates. Fabricated sensors were tested against gases like H₂, CH₄, C₃H₈, C₂H₅OH and SO₂. The composite material was found sensitive against H₂ at the working temperature 125 °C, with minor interference of other gases. H₂ gas as low as 100 ppm can be detected by the present fabricated sensors. It was found that the sensors based on SnO₂–Ag₂O–PdO_x nanocrystalline system exhibited high performance, high selectivity and very short response time to H₂ at ppm level. These characteristics make the sensor to be a promising candidate for detecting low concentrations of H₂.     

纳米In2O3／TiO2介孔复合体的制备及其光致发光性能研究

本论文利用尿素水解均匀沉淀法制备锐钛矿型纳米TiO2介孔粉体，然后在硫酸铟溶液中浸泡一周，并在650℃下退火处理5h，制得纳米In2O3／TiO2介孔复合体。采用X射线衍射（XRD）和光致发光（PL）谱表征In2O3／TiO2介孔复合体的组成结构和发光性能，并对相同温度退火处理下的介孔TiO2粉体进行比较，结果表明：经过650℃退火后，在激发波长380nm，发射波长570nm附近，纳米In2O3／TiO2介孔复合体产生荧光增强效应。