Theoretical and experimental study of the biamperometry for irreversible redox couple in flow system

The biamperometry for the direct determination of irreversible redox analytes in flow system has been proposed based on coupling two independent and irreversible couples to form the biamperometric detection scheme. In this work, the method is studied both theoretically and experimentally. Equations describing the current–voltage characteristics and the current–concentration relationship are presented. The influence of the applied potential difference (ΔE) and the half-wave potential difference (ΔE_1/2) between two irreversible couples on the method are discussed. It shows that small ΔE_1/2 is favorable to construct the biamperometric detection system and to achieve high sensitivity and selectivity. Increasing ΔE leads to an increase in sensitivity. This is, however, accompanied by a decrease in selectivity and signal-to-noise ratio. To construct the biamperometric scheme for the irreversible systems with large ΔE_1/2, two approaches, adjusting acidity of supporting electroyte or adding new irreversible couple, are proposed by taking uric acid/platinum oxide and phenol/permanganate systems as examples. Uric acid and phenol are, respectively, detected in a flow injection system with a biamperometric detector.     

光固化环氧丙烯酸酯/SiO2杂化材料的研究

用FTIR、SEM、DSC和TGA表征了光固化环氧丙烯酸酯／SiO2杂化材料[(EA-TMSPM)／SiO2]，研究了盐酸、γ-甲基丙烯酰氧丙基三甲氧基硅烷(TMSPM)和无机物浓度对(EA-TMSPM)／SiO2结构与性能的影响。结果表明，无机物浓度高的(EA-TMSPM)／SiO2杂化体系中SiO2粒子尺寸略大于无机物浓度低的体系；盐酸和无机物浓度的增加，都可以增强杂化材料的耐磨性。     

两相催化体系中辛烯的氢甲酰化反应研究

考察了反应温度、膦／铑化、表面活性剂种类及浓度、CO／H2压力比等因素对水溶性铑－膦配合物RhCI(CO)(TPPTS)2催化剂催化1－辛烯、2－辛烯氢甲酰化反应活性的影响,并选择出了优化的反应条件。研究结果表明,在该体系中表面活性剂的结果是影响RhCI(CO)(TPPTS)2催化2－辛烯转化率和选择性的重要原因,并对在两相体系2－辛烯氢甲酰化反应中表面活性剂十四烷基二甲基苄基氯化铵（BDAC）明显优于十六烷基三甲基溴化铵（CTAB）的原因进行了探讨。     

注射用生物可降解胰岛素纳米微球的制备

共聚物;药剂释放体系;注射用生物可降解胰岛素纳米微球的制备     

The influence of the pore size, the foaming temperature and the viscosity of the continuous phase on the properties of foams produced by membrane foaming

Membrane foaming is a new method of foaming. To enlarge the knowledge about the influencing factors and to know how to vary the structure of the resulting foam, different factors were evaluated. A whey protein solution with 10% protein was foamed as a model solution by means of a tubular cross-flow filtration membrane. The pore size of the membrane was varied. The smaller the pore size, the smaller the bubbles produced. As a result, the foam firmness increases and less drainage was observed when smaller pore sizes were applied.

An important factor is that the added amount of gas must be stabilised as completely as possible in the foam. In order to achieve this, both the process and the product parameters were varied. Raising the foaming temperature increased the quantity of stabilised gas. The whey proteins then diffuse faster to the bubble surfaces and stabilise these by unfolding and networking reactions to prevent the coalescence of the bubbles.

The product parameter viscosity was found to influence the foaming result in such a way that up to a viscosity of 40 mPa s the incorporated gas bubbles are stabilised by the higher viscosity. At viscosities higher than 40 mPa s it is difficult to incorporate in the bubbles, and the foam structure becomes coarser due to increased coalescence at the pores of the membrane. The foam stability is enhanced with higher viscosities.     

桥联茂金属催化剂用于双功能催化体系制备LLDPE的研究

以四种取代基不同的桥联茂金属作为乙烯共聚催化剂 ,以Ti(OR) 4为二聚催化剂组成双功能原位聚合催化剂体系 ,在同一反应釜中 ,乙烯为唯一聚合单体 ,以阳离子助剂B(C6 F5 ) 3为唯一助催化剂 ,原位制备LLDPE .该聚合体系催化剂活性高、单体插入率高、得到的聚合物为熔点低、分子量可调的超低密聚乙烯     

新型膦配体PDBPDS在氢甲酰化反应中催化剂配体性能的研究

用量子化学 AMI方法优化了 1 -苯基二苯并膦二磺化产物 ( PDBPDS)和三磺化三苯基膦 ( TPPTS)的几何构型 .比较两种化合物的空间结构和电子结构发现 ,在氢甲酰化铑膦催化反应体系中 ,PDBPDS的配体性能优于 TPPTS.首次研究了以 PDBPDS为配体的铑膦催化剂对丙烯氢甲酰化反应的催化性能 ,考察了反应温度、压力、膦铑物质的量比和搅拌速度对催化活性和选择性的影响 .结果表明 ,在 2 .0 MPa,1 0 0℃ ,膦铑物质的量比为 35 ,搅拌速度为 5 0 0 r/min及 V( H2 ) /V( CO) =1 /1的条件下 ,催化活性可达到 2 80 0 g(丁醛 ) /[g(铑 )·h],正异构产物物质的量比为 1 2 .3,在相同条件下与传统的三磺化三苯基膦 ( TPPTS)为配体的铑膦催化剂相比 ,催化活性和选择性提高了 2倍 .反应结束后 ,有机相和水相分离简单 ,有机相铑浓度仅为3.6× 1 0 - 8mol/L,有效地解决了铑流失问题 ,表明 PDBPDS是极具开发前景的新型水溶性配体     

纳米CoSe修饰氮掺杂多孔碳的可控制备及其锂硫电池多硫化物的催化转化效应

锂硫电池中较差的循环稳定性和倍率性能是实现锂硫电池商业化的技术障碍,其主要原因之一是多硫化物在硫电极内的电化学转化速率较为缓慢。为此,我们以ZIF-9为前驱体,采用先碳化,再酸化刻蚀,最后硒化的方法合成了含少量催化剂的CoSe修饰氮掺杂多孔碳(CoSe/NC)电极材料,以期提高硫电极内多硫化物的电化学转化动力学性能,并通过流动液相三电极体系对该材料进行电化学动力学表征。结果显示,相较于对比材料,CoSe/NC能够加快多硫化物的氧化还原反应速率,在0.2mA·cm-2电流密度下,多硫化物氧化还原反应在CoSe/NC电极上有最小的反应过电位;同时,在0.1 V过电位下,各氧化还原反应也有最大的响应电流。因此,将CoSe/NC作为硫宿主材料组装电池展现了优异的电化学性能：在1C(1C=1 675 mA·g^-1)下初始放电比容量为1 068 mAh·g^-1,经过500次循环后,可逆容量仍保持在693 mAh·g^-1。另外,在3C的高电流密度下,放电比容量可高达819 mAh·g-1。     

聚谷氨酸接枝聚乙二醇@碳酸钙遮蔽体系用于提高聚乙烯亚胺基因转染效率

设计并合成了聚谷氨酸-聚乙二醇@碳酸钙(PPG@CaCO₃)纳米遮蔽体系, 用于遮蔽聚乙烯亚胺(PEI). 一方面, 聚谷氨酸-聚乙二醇(PPG)可以降低PEI引起的细胞毒性, 更有利于体内应用; 另一方面, CaCO₃可有效改善PPG导致的转染效率下降, 并在一定程度上提高PEI的细胞转染效率. 对比遮蔽体系PPG@CaCO₃和聚谷氨酸-聚乙二醇@磷酸钙[PPG@Ca₃(PO₄)₂]发现, PPG@CaCO₃在微酸性环境中释放二氧化碳气体是提高细胞转染效率的关键因素. 小鼠体内循环实验表明, PPG@CaCO₃遮蔽体系可以增加载体在血液中的循环时间. 因此, PPG@CaCO₃遮蔽体系对于改善阳离子类基因载体的体内应用起到重要作用.     

化学专业本硕博一体化培养的课程建设探索*

化学专业本硕博一体化培养的课程建设以博士教育综合改革为契机,借鉴一流高校的先进理念,梳理原来本硕博三级培养过程中存在的课程内容重叠、缺乏衔接、知识广度不足等问题,结合化学专业特点和本校学科优势,兼顾理论课程、实验课程及实践训练环节,优化教学资源,力求建成横向学科交叉、纵向层次递进的本硕博一体化系列课程,为贯通式人才培养提供有益探索。