Argon I Lines Produced in a Hollow Cathode Source, 332 nm to 5865 nm

We report precision measurements by Fourier transform spectroscopy of the vacuum wavenumber, line width, and relative signal strength of 928 lines in the Ar I spectrum. Wavelength in air and classification of the transition are supplied for each line. A comparison of our results with other precision measurements illustrates the sensitivity of Ar I wavelengths to conditions in the light source.     

Dual reaction capacity of hydrogenated nanodiamond

High temperature hydrogen stream treatment of nanodiamond was shown to produce nanodiamond with bifunctional surface. OH- and different CH-groups were shown to be the main functional groups on the surface. In this article we proposed two main strategies for further chemical modification of hydrogenated nanodiamond. OH-groups were shown to react with different types of acylating agents: anhydrides and chloranhydrides. Chlorination of hydrogenated nanodiamond with molecular chlorine and its subsequent treatment with alkyllithium reagents resulted in formation of alkyl-nanodiamonds. Chlorination was shown to reduce the size of nanodiamonds aggregates. We have also applied suspension-state NMR-H1 spectroscopy to study suspensions of alkyl-nanodiamonds for the first time.     

Display modulation by Fourier transform: A preferred method

Abstract— A preferred method for determining the grating modulation of a rear‐projection display using a grating image and Fourier analysis is prescribed. This method is insensitive to spatial image noise and is in better correspondence with the response of the human visual system than is the standard technique. This method is not limited to rear‐projection displays and can be applied to any display technology.     

动态信号分析系统的进展及应用

本文综述了动态信号分析仪器与系统的发展,并综合介绍了双通道动态信号分析仪的构成、性能与指标,以及由动态测量、数据采集、信号处理等硬件与相应软件组成的多通道动态信号分析系统的进展.     

工业配料中的自控

本文介绍了微机在工业配料过程中的应用情况，对上料-计量-下料的全过程即“动态运行-静态计量-动态运行”进行控制．     

一个用于VHSIC连接线瞬态分析的电路模拟器

本文介绍了一个可对含连接线的电路进行瞬态分析的电路模拟器,该模拟器是在SPICE基础上经修改扩充而成的,连接线的处理采用了文献[1]的方法.文中介绍了方法的基本原理,讨论了数值Laplace反变换时参数的选择与误差的控制.实际VHSIC电路的试算结果表明,该模拟器是相当有效的.     

一种基于双正交重叠变换的嵌入式编码算法研究

双正交变换为基于块的低复杂度变换,而且与传统的离散余弦变换相比,一定程度上减小了变换后图像的块效应,因而被采纳入联合图像专家组织JPEG（Joint Photographic Expert Group）最新制定的静态图像编码标准JPEG XR中。为了能够改善其无法实现码流长度控制的缺陷,文章深入研究了JPEG XR的编码技术,提出了一种针对固定压缩比的编码算法。主要思路是通过对双正交变换后的系数进行嵌入式位平面编码,取代了原先的量化步骤,使得压缩码流长度可以精确控制。     

分数阶Fourier域多分量LFM信号间的分辨研究

在分数阶Fourier域内,当多分量线性调频(LFM)信号的初始频率和调频率相近时,信号的尖峰会出现无法分辨的现象,导致目标信号漏检.文中分析了LFM信号在分数阶Fourier域的频谱分布特征,以及离散分数阶Fourier变换计算条件下LFM信号的频谱分布特征.推导了两个LFM信号在分数阶Fourier域的临界分辨距离,以及两个LFM信号尖峰之间的距离与量纲归一化因子的变化关系,发现选择合理的量纲归一化因子可以增大两个信号尖峰之间的距离.文中提出一种量纲归一化因子优化选择的方法,该方法可以提高分数阶Fourier变换对多分量LFM信号的分辨能力.最后,仿真结果验证了该方法的有效性.     

Research on resolution between multi-component LFM signals in the fractional Fourier domain

When the initial frequencies and chirp rates of multi-component linear frequency modulation (LFM or chirp) signals are close,the signals may not be distinguished in the fractional Fourier domain (FRFD).Consequently,some signals cannot be detected.In this paper,first,the spectral distribution characteristics of a continuous LFM signal in the FRFD are analyzed,and then the spectral distribution characteristics of a LFM signal in the discrete FRFD are analyzed.Second,the critical resolution distance between the peaks of two LFM signals in the FRFD is deduced,and the relationship between the dimensional normalization parameter and the distance between two LFM signals in the FRFD is also deduced.It is discovered that selecting a proper dimensional normalization parameter can increase the distance.Finally,a method to select the parameter is proposed,which can improve the resolution ability of the fractional Fourier transform (FRFT).Its effectiveness is verified by simulation results.