稳定同位素井间示踪技术在深层块状稠油油藏水驱特征研究的应用

经对冷43块深层块状普通稠油水驱注水5个试验井组开展的稳定同位素示踪测试，利用中子活化技术分析样品，采用先进的示踪剂定量分析与流动模拟相互结合的方法，以示踪数值模拟为手段，评价了油井连通、油层平面及纵向上的非均质性、隔层的封隔性等因素对水驱控制程度及动用状况的影响，通过优化注水推进方向及速度，强化动态调整措施，提高了稳产基础。     

节能降耗提高矿山效益

节能降耗是每一个矿山提高经济效益的有效途径。我们采取提高球磨机处理能力，降低单耗；利用“分时计价”政策，采用“避峰作业”；使用新设备等措施节能降耗，提高矿山经济效益。     

论普通型胶辊表面不处理的合理工艺参数

论述了普通胶辊表面不处理的性能特点和存在问题，技术措施和合理工艺参数，提高了成纱条干水平，减少缠绕和磨损。     

化学成分和固溶温度对1Cr17Mn9Ni4N不锈钢组织和性能的影响

为提高1Crl7Mn9Ni4N钢固溶处理后的力学性能(特别是钢的强度)，研究了化学成分及固溶处理温度对其组织和性能的影响。结果表明，1000—1125℃固溶处理后，该钢的组织为单相奥氏体。在标准成分范围内，随着镍、锰含量的增加，该钢的强度降低，塑性有所改善。氮明显提高该钢的强度。根据试验结果，每增加0．01％的氮钢的室温强度可提高大约5MPa，且塑性基本上不受影响。当合金成分(质量分数，％)控制在C0．08—0．12、Crl6．5—17．5、Ni3．5—4．2、Mn8．0—9．0、N0．22—0．28时，1Crl7Mn9Ni4N钢经1050—1100℃固溶处理后强度较高、塑性好，室温强度σ0．2和σb可分别达到400MPa和800MPa。     

Intensive filial therapy with child witnesses of domestic violence: A comparison with individual and sibling group play therapy.

The rationale for utilizing filial therapy as a treatment intervention with child witnesses of domestic violence while residing with their mothers in a shelter facility is explored and the effectiveness of an intensive 12-session filial therapy parent training group, conducted within 2-3 weeks, is described (n=11; aged 4-10 yrs). Results of analysis of covariance revealed that child witnesses in the experimental group significantly reduced behavior problems prevalent in child witnesses and significantly increased their self-concept as compared to child witnesses in the non-treatment comparison group. In addition, t-test results showed that mothers who facilitated treatment of the experimental group scored significantly higher after training on both their attitudes of acceptance and their empathic behavior. Comparative analysis revealed that intensive filial therapy as facilitated by the children's mothers was as effective in reducing behavior problems as was intensive individual play therapy and intensive sibling group play therapy as facilitated by professionally trained therapists. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Austenitizing treatment influence on the electrochemical corrosion behavior of 0.3C-14Cr-3Mo martensitic stainless steel

Effects of austenitizing treatment temperatures on aqueous corrosion properties of martensitic stainless steels were investigated by electrochemical tests (potentiodynamic test, potentiostatic test and electrochemical impedance spectroscopy), and surface analyses (optical microscopy and XRD). The results of potentiodynamic test revealed that the breakdown potential increased with the increased austenitizing temperature, indicating increased relative resistance to initiation of localized corrosion. EIS measurements showed that MSS3 (1030 °C) exhibits larger polarization resistance value than MSS1 (970 °C) and MSS2 (1000 °C) at passive and breakdown states. This was caused by decreasing the amount of Cr-rich M₂₃C₆ carbide which acts as preferential sites for pitting corrosion.     

换填法建筑地基处理的工程实录

结合某工程的地基处理，对换填法的应用作了较详细的阐述。     

巴彦浩特探区钻井液技术初探

巴彦浩特探区钻井液工艺技术的重点是，解决疏松砂砾岩地层水涌漏同层、侏罗系地层水的HCO3^-污染及可能出现的火成岩地层井塌复杂。结合内蒙古巴彦浩特探区地层和井身结构特点，采用了两性聚合物／氯化钾钻井液和氯化钾／石膏-聚磺钻井液体系。该体系抑制能力强，性能稳定．容易实现低固相、低密度近平衡钻井，保护储层效果好。对复杂情况采取了有针对性的处理办法：平稳操作和合理的钻井工程措施是预防水层涌漏同层和火成岩井塌复杂的重要手段；用井场易得的固井水泥或石膏配合烧碱处理HCO3^-污染简便易行；处理火成岩井塌复杂，控制合适的钻井液性能是必要的。     

Corrosion Condition Evaluation at Muddy Creek Bridge

Corrosion rates were measured at the exposed spots of rebars near three corners of Muddy Creek Bridge located in northern West Virginia using a 3LP device. Also, chloride contents of the concrete samples taken from the vicinity of the spots were analyzed using a wet chemical method that had been developed in this study. The average corrosion rate over the three spots was 4.66 mA/m2, which is in the range of corrosion damage possible in 10–15 years. The average chloride content of the concrete over the three spots was 703 parts per million (ppm), which is well above the threshold limit value of 260 ppm. Although the corrosion rate measurement method using a 3LP device is by manual operation, it is found to be reliable and effective, and, thus, recommended for future studies of this kind of research. The wet chemical method developed in this study is found to be effective.     

Allocation of Scarce Water Resources Using Deficit Irrigation in Rotational Systems

On irrigation schemes with rotational irrigation systems in semiarid tropics, the existing rules for water allocation are based on applying a fixed depth of water with every irrigation irrespective of the crops, their growth stages, and soils on which these crops are grown. However, when water resources are scarce, it is necessary to allocate water optimally to different crops grown in the irrigation scheme taking account of different soils in the command area. Allocating water optimally may lead to applying less water to crops than is needed to obtain the maximum yield. In this paper, a three stage approach is proposed for allocating water from a reservoir optimally based on a deficit irrigation approach, using a simulation-optimization model. The allocation results with a deficit irrigation approach are compared for a single crop (wheat) in an irrigation scheme in India, first with full irrigation (irrigation to fill the root zone to field capacity) and second with the existing rule. The full irrigation with a small irrigation interval was equivalent to adequate irrigation (no stress to the crop). It is found that practicing deficit irrigation enables the irrigated area and the total crop production in the irrigation scheme used for the case study to be increased by about 30–45% and 20–40%, respectively, over the existing rule and by 50 and 45%, respectively, over the adequate irrigation. Allocation of resources also varied with soil types.