The method of testing of XLPE cable insulation resistance to partial discharges and electrical treeing

The paper gives a method of model XLPE medium voltage cable insulation testing for partial discharges and electrical treeing with a point to plane test geometry. Based on this method, a comparative estimate of insulation resistance to treeing and partial discharges have been made. XLPE crosslinked by different methods (steam medium and hot nitrogen medium) and with varying contents of inorganic filler kaolin were tested. The characteristics of partial discharges were measured by means of a pulse height analyser characterized with a microscope. The data have been analysed statistically.     

S—135钢板热轧工艺研究

S—135钢板是水电站用高强耐磨不锈钢板,既要求强度高、韧性好,又要求耐磨、耐蚀性强,生产难度较大。除我厂外,目前国内尚无其它厂家能够生产这种钢板。该钢板在加热轧制,冷却过程中要解决很多技术难点。我们通过采用特殊的控制轧制和控制冷却工艺,很好地解决了诸多技术难点,使S—135钢板的开发研制取得了成功。为电站用高强度耐磨不锈钢生产提供了宝贵的经验,也为控制轧制及控制冷却技术在中板生产行业的应用起到了积极的推动作用。     

Synthesis of nanophase tungsten carbide by electrical discharge machining

Tungsten carbide nanopowders were synthesized successfully by electric discharge machining followed by annealing under a nitrogen atmosphere. The tungsten workpieces were initially melted and evaporated on the working surface during the electric discharge machining process, and then the tungsten powders were reacted with the carbon electrode and the working medium of kerosene to form the nanocrystalline WC_1−x powders. The powders produced were characterized by XRD, SEM, and TEM. When annealing the powders under an N₂ atmosphere, the cubic phases of WC_1−x gradually changed to hexagonal W₂C and then were transformed fully to nanocrystalline hexagonal WC at 1200 °C, with the nanocrystalline tungsten carbide encapsulated in a carbon shell. On the other hand, under an H₂ atmosphere, the WC_1−x phase changed via a W₂C phase to reduced powders of pure tungsten at 1000 °C or were reduced directly from WC_1−x to elemental W.     

残余应力对55SiMnVB弹簧钢疲劳性能的影响

研究了５５ＳｉＭｎＶＢ弹簧钢板疲劳断口特征及裂扩展过程。结果表明，喷丸强化在表层产生的残余压应力可明显提高疲劳抗力，增强裂纹闭合效应，降低裂纹扩展速度。     

功率GaAs MESFET的热阻测试

阐述了功率ＧａＡｓＭＥＳＦＥＴ器件热阻测试中温敏参数ＶＧＳＦ和测试电流Ｉｍ的选取，给出了１～５Ｗ器件典型温敏参数的温度测试系数Ｍ与测试电流Ｉｍ的关系。讨论了测试延迟时间ｔｍｄ对△ＶＧＳＦ测量值的影响和三种校正方法。     

两种具有电双稳态的全有机络合物

首次发现两种在室温下即具有电双稳态的全有机（有机-有机）络合物，分别称为MCA＋TCNQ和BBDN＋TCNQ。它们可在真空中制备成薄膜，在数伏电压的作用下，从高电阻至低电阻的跃迁时间小于100ns，因此可作为一次写入的存储器材料。根据我国目前最小刻线宽度的水平，可望在1．6cm2的SiO2平面上做出64Mb的存储器。     

一种新型硅三端负阻器件

提出并研制成一种新型硅三端负阻器件。该器件由一n沟耗尽型MOS管、一横向pnp双极晶体管和一个电阻集成而得。它具有“双负阻”特性和正阻区阻值易于控制等特点。由理论计算出的器件I_c—V_(CB)特性和负阻参数与实验结果符合良好。     

Synthesis,Micellization, and Surface Activity of Novel Linear-Dendritic Carboxylate Surfactants

Two generations of novel linear-dendritic carboxylate surfactants C₁₈-G₁-(COONa)₂ and C₁₈-G₂-(COONa)₄ have been synthesized by the divergent method and their structures are characterized by ¹H Nuclear Magnetic Resonance and Infrared analysis. The electrical conductivity measurement is used to measure the Krafft temperatures of C₁₈-G₁-(COONa)₂ and C₁₈-G₂-(COONa)₄, which are much smaller than those of the corresponding conventional surfactant sodium stearate. The markedly enhanced solubility of two linear-dendritic surfactants is ascribed to the high hydrophilicity of surfactant headgroups induced by the carboxylate and ester groups. The critical micelle concentration (CMC) values obtained from both the electrical conductivity and surface tension measurements indicate that the micellizations of linear-dendritic surfactants become favorable with the increase in the number of the surfactant headgroup. However, the surface activity parameters including the surface tension at the CMC, maximum surface excess, and minimum surface area reveal that C₁₈-G₁-(COONa)₂ exhibits greater efficiency in absorbing at the air/water interface compared to C₁₈-G₂-(COONa)₄, owing to their different steric repulsions of the surfactant headgroups. In addition, C₁₈-G₁-(COONa)₂ and C₁₈-G₂-(COONa)₄ have higher emulsifying ability than the conventional surfactants sodium stearate and sodium octadecyl sulfate.     

稀土元素对钯室温电学性能的影响

研究了稀浓度(0.6at％以下)稀土元素(La、Ce、Pr、Nd、Sm、Eu、Gd、Tb、Dy、Er、Yb)对钯的室温电学性能的影响。所有稀土元素均提高钯的电阻率(p)、降低电阻温度系数(α),实验结果与理论分析证明(p·α)_((?)d-RE)d=(p·α)_(Pd)。Gd以前的稀土元素降低钯的对铜热电势(ε),其余重稀土元素增大钯的对铜热电势。按0.1at％RE归一化处理的实验数据表明,轻稀土元素对钯电阻率的影响稍大于重稀土,但Ce、Eu、Yb呈反常影响,化合价和尺寸因素是影响电学性能的主要因素。     

耐腐蚀高压柱塞泵用新型双相不锈钢的研究

叙述了新型双相不锈钢－ＷＳＤ钢的组织及其耐蚀性能。试验结果表明，ＷＳＤ钢在氯化物介显示出优异耐蚀性能，其抗点蚀性能远超过Ｃｒ１３，１８－８Ｔｉ，３１６Ｌ等钢种，达到国外Ａｌ－６Ｘ，ＳＡＦ２２０５等钢种的水平。