聚醚醚酮及其复合材料的摩擦学研究进展

评述了聚醚醚酮（PEEK）及其复合材料的摩擦磨损性能，在滑动过程中形成的摩擦转移膜以及磨屑的研究，总结了聚合物基复合材料摩擦学研究的一般方法及规律，介绍了关于用PEEK复合材料制造的轴承，齿轮等进行的摩擦学研究，以及等离子体表面处理和颗粒增强对PEEK及其复合材料摩擦学性能的影响。     

磁场对泡沫钻井液电导率的影响研究

磁处理技术是利用磁场对非铁磁性流体作用．使被作用物的性质产生某些期望的变化，从而改善生产效果和使用效益。磁处理对常规钻井液流变性能的影响研究结果表明，磁化能明显改善钻井液性能。通过研究磁化后泡沫钻井液的性质．测定与控制钻井液的电导率，以便从电测曲线上取得更好的地层特性评价。泡沫钻井液的电导率与密度基本呈线性关系，电导率随密度的升高而变大；磁处理后泡沫钻井液的性质发生明显改变．泡沫钻井液的电导率有不同程度的下降，在磁场强度为100mT、蜂数为2的磁场条件下泡沫钻井液的电导率变化率降低最大，电导率平均下降16％左右。     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Effects of Surface Concentration on Drying Behavior of Carbohydrate Solutions

As the surface properties of the drying materials are very important not only for the drying rate but also for the quality change during drying, the effects of surface concentration on the drying behavior of liquid foods (sugar solutions) were investigated by isothermal drying experiments and by numerical calculation experiments. The isothermal drying experiments with gelled sugar solution systems (sucrose and maltodextrin) were carried out at various relative humidity (RH) values (RH = 0 to 84%). Separate experiments were carried out for determination of the desorption isotherms.

The isothermal drying curves of sugar solutions at RH = 0 to 51% were very similar. Numerical simulations also showed that the drying curves of these sugars at the surface concentration = 0 and 0.1 are almost the same, although the concentration distributions are different.

When a small amount of gelatin was added to sugar solutions, the drying rate decreased remarkably as the gelatin might form a thin film (skin) near the surface, and consequently the retention of ethanol increased.     

安徽省水资源宏观经济优化模型研究

以水资源可持续发展为出发点,探讨了一种可以同时兼顾经济发展、水资源利用和社会效益的多目标水资源宏观经济模型的建立方法,通过引入带权2-模评价函数,将多目标优化问题转变成单目标优化问题。以2002年为现状水平年,对安徽省2010年的产业结构及产业规模进行优化分析。结果表明,多目标模型求得的总用水量较单目标模型明显降低,而两模型优化的产业规模与结构差别不大,体现了高用水效率行业优先发展的要求。     

摩擦焊在钢制实心抽油杆修复中的应用

通过对焊接工艺及焊后热处理工艺优化，采用摩擦焊接技术对报废抽油杆中仍有使用寿命的杆头与杆体进行了拼接，获得了性能达标的抽油杆。从而提高了旧杆的修复率．降低了采油成本。该技术可在抽油杆修复及相关行业进行推广应用。     

探讨电石法PVC烟气治理方法

分析了电石法PVC生产链中电石炉烟气及电厂烟气二氧化硫的排放情况,指出利用电石炉烟气中的CO合成氨、再将合成氨用于燃煤电厂烟气的"氨法"脱硫是具有较大应用潜力的循环经济产业链。     

环境敏感因素对电站正常蓄水位选择的影响

卜寺沟水电站预可阶段正常蓄水位是考虑规划成果、地形、地质务件、梯级衔接、水库淹没、筑坝技术、水能资源利用等因素综合初选的.从理论角度分析,水库淹没时水库内寺庙的影响,按全部淹没进行经济补偿处理代价较小;其社会环境敏感因素对正常蓄水位的选择不应起决定性作用.但是,考虑到少数民族群众、僧侣和地方政府的要求,适当降低正常蓄水位,以减少对扎西日岗寺庙的影响,将带来较积极的社会影响.     

调整水量法(代用法)测定水泥标准稠度用水量方法的改进

结合兰州市的水泥标准稠度用水量方法测定 (代用法 )的实例 ,分析代用法测定标准稠度用水量的缺点 ,并对此方法提出了一些改进措施     

宾馆酒店蒸汽冷凝水回收问题剖析

分析了宾馆酒店进行冷凝水回收所遇到的各种问题，提出了应对策略和解决方法，介绍了取得的应用效果。