频域吸收边界条件的构造理论

在频域中推导了适用于差分类数值方法的吸收边界条件的构造方法，并通过选取不同参数导出了几种现有的吸收边界条件。在计算了一般形式的吸收边界条件的反射系数之后，提出了一种简单实用的自适应吸收边界条件。     

离心泵叶片边界层方程的解析解

给出了离心泵叶片表面的边界层动量积分方程的解的构造及其计算方法，并以计算实例说明了该解的唯一性和算法的稳定性、收敛性。它是分析离心泵流体在叶片表面边界层参数的基础。     

Effect of nitrocarburizing on sulphide layer during nitrocarburizing-sulphurating treatment

Compared with the single sulphurating treatment, the duplex treatment of nitrocarburizing-sulphurating can more effectively improve the properties of steel such as friction-reducing, wear resistance and anti-scuffing. Under the same processing parameters, the sulphide layers were fabricated on the surface of CrMoCu alloy cast iron by single ion-sulphurating treatment and nitrocarburizing-sulphurating duplex treatment, respectively. Through the analysis of the sulphide, the effect of the nitrocarburizing on the fabrication of the sulphide layer was investigated. And the result shows that the fabrication of sulphide layer is promoted by the nitrocarburizing treatment.     

Reduction of low-frequency pressure fluctuations in wind tunnels

The determination of dynamic wind loads on buildings, i.e. pressure and deflection, has gained increasing interest (European Prestandard ENV 1991-2-4, Eurocode 1: basis of design and actions on structures—Part 2-4: actions on structures—wind actions, European Committe for Standardization, Brussels, 1995; DIN 1055 Teil 4 Lastannahmen für Bauten, Verkehrslasten, Windlasten bei nicht schwingungsanfälligen Bauwerken, 1991; N. Hölscher, M. Hortmanns, J. Sahlem, Praxisnahe Erfassung von Windwirkung an Industrie- und Hochbauten, Windwirkung im Bauwesen, Braunschweig, 7, Dreiländertagung D-A-CH 2001, Windtechnologische Gesselschaft, 2001 [1], [2] and [3]). Therefore, the spectral distributions of velocity and pressure fluctuations in wind tunnels are an important quality aspect. While velocity fluctuations can be manipulated by the obstacles used to create the turbulence, pressure fluctuations are influenced by acoustic noise as well. Especially, the first eigenfrequency of the longitudinal mode of the wind tunnel tends to disturb the pressure spectrum.In this paper, a solution for the reduction of low-frequency acoustic pressure fluctuation is presented and its application in the atmospheric boundary layer wind tunnel at the IAG is shown.     

长输管道外防护层的选择与应用

文章介绍了目前国内外长输管道外防护技术的特点和防护层应用的现状,分析了常用防腐蚀材料的防腐蚀性能。指出在山区复杂地形条件下,应考虑环境条件和施工条件,并通过技术经济分析对管道外防腐蚀层进行合理选择。     

硅外延片中的杂质控制

有5类掺杂源影响硅的外延片中的杂质分布。主掺杂质控制外延层的杂质浓度，决定外延层的电阻率。固态外扩散、气相自掺杂和系统自掺杂影响衬底界面附近的外延层杂质浓度的深度分布。该文介绍了此3类掺杂源的掺杂过程和抑制方法。金属杂质在外延层中对器件有害，防止沾污和使用吸杂技术能降低金属杂质在外延层中的浓度。     

The Adhesion and Formation Mechanism of Blast Furnace Gunning Layer

1 Introduction Gunning refractories are unshaped refractories commonly used in iron and steel industry for the main- tenance of furnace linings. The specific way of gunning processing requires the refractory to have specific rheo- logical properties so as…     

Homogenization of hardness distribution and distortion in high pressure gas quenching

Quenching with gases rather than oil or other liquid media has the advantages of reducing the risks concerning health and environment, while simultaneously homogenizing the quenching results and minimizing distortion due to a wide range of possible process parameter variations and the pure convective heat transfer. In this contribution, a coupled solution for increasing homogenization of quenching results within high pressure gas quenching will be presented. In the first stage, an experimental test facility was set up for flow investigations and in the second stage a numerical simulation model was generated. The numerical and experimental results of the flow through the chamber were compared for several boundary conditions. Finally, after complete verification of the simulation, the model may be used to assist in parameter variation for optimization of homogeneous high pressure gas quenching.     

Application of boundary element method to 3-D problems of coupled thermoelasticity

This paper deals with a new boundary element method for analysis of the quasistatic problems in coupled thermoelasticity. Through some mathematical manipulation of the Navier equation in elasticity, the heat conduction equation is transformed into a simpler form, similar to the uncoupled-type equation with the modified thermal conductivity which shows the coupling effects. This procedure enables us to treat the coupled thermoelastic problems as an uncoupled one, A few examples are computed by the proposed BEM, and the results obtained are compared with the analytical ones available in the literature, whereby the accuracy and versatility of the proposed method are demonstrated.