用试井方法确定注水后地层渗透率的变化

大港油田已进入开发中后期，高含水油田占73％，开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法，对大港油田的增储上产具有重要意义。     

On the hollowness ratio effect on the dynamics of a spinning Rayleigh beam

The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

复合沉淀氯化镨钕工艺研究

针对草酸沉淀成本高的问题，提出了复合沉淀的方法，试验结果及生产应用都证明了此方法能达到降耗同效的目的。     

承压水漏斗地区地下水位时空分布预报的BP网络模型

依据水均衡原理，导出承压水漏斗区任意一点水位与其影响因素之间的复杂的非线性关系，在此基础上提出承压水漏斗水位时空分布预报的BP神经网络模型。该模型具有 分布参数模型的特征，且不需用到区域的水文地质参数。最后针对某实例进行了模型设计及预报分析，通过对部分观测井后期实测数据的训练，优选出双隐层的网络结构及其网络参数。随后用这些观测井的前3年数据进行了检验，并对其他观测井数据进行预报。计算表明，该模型对地下水位拟合与预报的合格率较高，可以获得研究区域某一时刻水位在空间上的分布。     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。     

波流环境中污染物混合的分析

本文根据垂向二维数值模型计算求解和分析了波流环境中的一维对流扩散方程中的混合系数。此二维数值模型采用非线性k-ε紊流模型封闭雷诺时均方程，应用VOF方法处理自由面。分析方法是用该二维模型计算波流环境中污染物瞬时源产生的浓度场，计算该浓度场的断面平均浓度，求此断面平均浓度的概率分布，由概率分布的方差随时间的导数得到一维对流扩散问题中的混合系数。通过算例分析，发现波流环境混合系数随着波浪周期和波 高的不同，可能大于纯流和纯波的混合系数之和，也可能比纯流情况下小；波周期与混合系数呈正比。且存在一个使混合系数最大的波高。     

房间空调器高效节能技术分析

本文主要介绍了高效节能型空调器的优化设计，包括选用高效压缩机、增大换热面积，增大风量、管路的合理设计，旨在提高制冷量，降低功耗，提高能效比。     

基于自然地理形态的道路测设及其曲线方程的拟合

在山区村镇及风景旅游名胜区的建设中，其道路的曲线测设，往往要基于自然地理形态进行，也就是路径的选择，有时具有不可选择性，且要求与实地具有最大的符合性。因此，其测设的作业方法不同于一般意义的道路测设；其曲线方程的建立，也是极其困难的。本就基于自然地理形态的道路测设工作的曲线类型的选择、曲线的拟合方法、曲线方程的建立及其数据的计算，提出了利用CAD技术进行曲线拟合、曲线方程的建立、曲线计算的实用技术方法。     

磨料高压水除鳞系统设计研究

磨料高压水除鳞系统取代酸洗线，原机械部分和磨料高压水部分都作了较大改进，才能保证除鳞彻底。