Measurement and prediction of pressure drop in two-phase flow

Experimental data for air–water two-phase co-current flow in two different pipe diameters were used to test the prediction of pressure drop by a number of existing theories and correlations. Several models are shown to be useful for prediction, particularly with the stratified regimes which have proved difficult to handle in the past. The model suggested by Olujic proved to be of particular value.     

AN EXPERIMENTAL AND NUMERICAL INVESTIGATION OF THE STARTING FLOW OF A UNIFORMLY ACCELERATING CIRCULAR CYLIINDER

The starting flow around a uniformly accelerated circular cylinder is investigatedby flow visualization techncque and solving N-S equations numerically in detail.The results ofthe starting flow are similar with those of the impulsively started one.At lower Re_α,numbers the“phenomenon a”is revealed;the“phenomenon β”appears at higher Re_α numbers,but withonly one secondary vortex.At the early stage of the starting vortex formation,the flow islaminar;at the later stage,the flow transforms into turbulent flow.The velocity distribution inthe flow field is measured with the multiwires installment.The calculational results are comparedwith the results of experiment,and both are in agreement with each other.     

NUMERICAL MODEL FOR DYNAMIC SIMULATION OF TRAFFIC FLOW

ＮＵＭＥＲＩＣＡＬＭＯＤＥＬＦＯＲＤＹＮＡＭＩＣＳＩＭＵＬＡＴＩＯＮＯＦＴＲＡＦＦＩＣＦＬＯＷＷｕＺｈｅｎｇ；ＺｅｎｇＬｉ－ｎｏｎｇ（ＤｅｐａｒｔｍｅｎｔＡｐｐｌｉｅｄＭｅｃｈａｎｉｃｓ，ＦｕｄａｎＵｎｉｖｅｒｓｉｔｙ，Ｓｈａｇｈａｉ２００４３３，Ｐ...     

用试井方法确定注水后地层渗透率的变化

大港油田已进入开发中后期，高含水油田占73％，开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法，对大港油田的增储上产具有重要意义。     

紫坪铺水电站AGC的设计与实现

本文首先介绍自动发电控制的基本原理和基本功能，然后介绍紫坪铺电厂AGC程序基本功能。作为水利枢纽工程，紫坪铺电厂的AGC有自身的特点，如电调服从水调，在保证下游供水的条件下实现自动发电控制，限制功率调节速度等，所以在实际运行中碰到许多特殊问题。为保证AGC功能的正常实现，采用一些特殊的方法解决以上问题。如通过设置最小下泄流量保证下游供水，限制功率调节步长解决功率变化过大等问题。通过试验。紫坪铺电厂在保证下游供水的前提下，顺利实现AGC各项功能，为作为水利枢纽工程的电站实现AGC提供了宝贵的经验。     

稀疏气泡流动的粒子跟踪测速技术研究

采用动态阈值技术实现了对气泡图像的正确分割，利用灰度加权方法提高了气泡颗粒的定位精度。根据稀疏气泡流动图像的特点，提出了一种新的基于相关的粒子跟踪测速算法（2-HPTV）。通过进行两时刻中围绕待研究气泡所取的两个小的诊断窗口的相关运算，成功实现了气泡颗粒的轨迹追踪。实验表明本文算法较传统的PIV技术在测速精度上有很大程度的提高，与4帧粒子跟踪测速算法相比，降低了对摄像机帧频的要求，具有较强的实用性。     

膜片式流量调节阀

介绍了用于油田开采工艺的膜片式流量调节阀的结构及其特点,分析了调节阀出口压力、进口压力对其流量的影响。受力分析和现场使用表明:该阀流量恒定精度(即恒流偏差)取决于膜片有效面积S与阀心下端有效面积S′之比,此值为12,其恒流比偏差为0·03,说明该阀的流量恒定精度高;该阀不易被杂质卡死,稀油中直径1mm的砂粒能顺利通过,而不影响阀的功能;膜片式流量调节阀是没有高加工精度要求的部件,普通车床即可生产,因此造价较低。     

Structure and dynamics of dipolar fluids under strong shear

Molecular dynamical simulation has been carried out to investigate the structure and dynamics of a dipolar fluid under strong shear. Dipolar fluid consists of polarizable particles, which have an induced dipole moment in the applied field direction. Shear stress is perpendicular to the field direction. When shear stress is small, the flow has a flowing-chain structure. If shear stress increases to pass a critical value, flowing-chain structure changes to flowing layer structure. Each layer is parallel to the flow direction and shear direction. Within one layer, particles form strings in the flow direction.     

西藏拉洛水利枢纽及配套灌区工程下泄流量的初步研究

回顾了国内外有关河流生态环境需水的研究进展以及目前较常用的河道内生态环境需水量的计算方法。以西藏拉洛水利枢纽及配套灌区工程为实例,采用多种计算方法对工程拟定的下泄流量方案进行分析比较,并指出工程下泄流量方案存在的问题。分析结果表明,工程拟定的方案在下泄水量方面是满足下游生态环境需水要求的,但下泄流量过程可进一步优化,以减缓引水对下游生态环境的影响。     

Quantitating Fluorescence Intensity from Fluorophore: The Definition of MESF Assignment

The quantitation of fluorescence radiance may at first suggest the need to obtain the number of fluorophore that are responsible for the measured fluorescence radiance. This goal is beset by many difficulties since the fluorescence radiance depends on three parameters 1) the probability of absorbing a photon (molar extinction), 2) the number of fluorophores, and 3) the probability of radiative decay of the excited state (quantum yield). If we use the same fluorophore in the reference solution and the analyte then, to a good approximation, the molar extinction drops out from the comparison of fluorescence radiance and we are left with the comparison of fluorescence yield which is defined as the product of fluorophore concentration and the molecular quantum yield. The equality of fluorescence yields from two solutions leads to the notion of equivalent number of fluorophores in the two solutions that is the basis for assignment of MESF (Molecules of Equivalent Soluble Fluorophore) values. We discuss how MESF values are assigned to labeled microbeads and by extension to labeled antibodies, and how these assignments can lead to the estimate of the number of bound antibodies in flow cytometer measurements.