Mid-Temperature Synthesis of CeO2-TiO2 Complex Compound and Its XRD Structure Study

TiO2 andCeO2 aresemiconductormaterials .TiO2hasthepropertiesofphoto catalysis[1] whileCeO2 hastheabilityofoxygenstorageandcanpromotethedispersionofprecionsmetalsonthesupporter[2 ] .CeO2 TiO2 com plexcompoundwasusedascatalystandspecialfunction almaterial[3～ 5] .ThetraditionalsynthesisofCeO2 TiO2complexcompoundisbyceramicmethodthatusesoxidesasrawmaterialsanditiscalcinedabove 130 0℃[6～ 8] .However ,thestructureandmicrostructureofthecomplexcompoundarenotsuitableforcatalystandfunctionalm…     

深部调剖驱油交联剂的研究

为提高非均质性严重的地层原油采出率 ,合成了用于聚合物驱油的 4种交联剂 ,并对聚合物种类、用量和其与交联剂组成的体系进行了评价。 4 0℃下铝交联剂凝胶粘度低 ,酚醛树脂交联剂低温下不成胶 ,而有机铬交联剂 (J2 )和有机复合胺 (J3)交联效果好。当选用HPAM/有机铬交联剂 /有机酸交联体系时 ,其中HPAM相对分子质量为 2 1× 10 7,可通过改变体系pH值调节成胶速度 ,pH值 6 5时 ,14 0 0mg/LHPAM和 4 0 0mg/LJ2组成的体系在 4 0℃、30d可形成粘度为12 0mPa·s以上的凝胶 ,且热稳定性好 ,成胶时间能满足现场施工需要。 14 0 0mg/LHPAM和10 0 0mg/LJ3交联剂组成的体系 ,成胶时间长 ,有利于油田深部调剖驱油     

香豆胶衍生物的化学结构及稳定性研究

将市售商品溶于水,用异丙醇沉析提纯,溶于0.1 mol/L NaNO3纯水溶液中,经0.5μm滤膜过滤后用水相凝胶渗透色谱法(GPC)测定,测得香豆胶(FG)、羟丙基香豆胶(HPFG)、阳离子香豆胶(CFG)的数均、重均相对分子质量Mn、Mw分别为:1.19×105、3.36×105,8.52×104、2.85×105,9.33×104、2.87×105。用甘露聚糖链在碱性条件下醚化时发生降解,解释两种改性FG的相对分子质量较FG低而多分散性(Mw/Mn)较FG高的测试结果。认为商品FG的1%水溶液黏度(1300 mPa.s)高于商品HPFG和CFG(分别为705和610 mPa.s)的原因是前者相对分子质量较高且残渣含量也较高(~10%,后二者为1%~2%)。HPFG的取代度为0.12,根据文献发表的13C-NMR数据确认HPFG分子链上羟丙基取代位置为C6。讨论了香豆胶(半乳甘露聚糖)的化学结构。热重分析法测定的热稳定性,HPFG高于CFG,CFG又高于FG。图6表3参13。     

溶胶-凝胶生物玻璃多孔材料显微结构和生物活性的扫描电镜及红外光谱分析

本文利用溶胶．凝胶法制备了CaO-P2O5-SiO，系统生物活性玻璃，并以其为原料制备了用于骨修复及骨组织工程支架的块状生物活性材料。利用体外实验方法(invitro)结合x射线衍射(XRD)、扫描电子显微镜(SEM)和傅立叶变换红外光谱分析(FTIR)技术对不同烧结工艺制备的材料结构、晶相和生物活性的影响进行了分析研究。研究表明，经800℃和1100℃烧结5min的两种材料均有硅磷酸钙Ca5(PO4)2SjO4微晶相析出。烧结温度越高，析出微晶相的体积比例越大，材料的生物活性则越低。在模拟生理溶液中碳酸羟基磷灰石(HCA)只在烧结体中的玻璃颗粒表面形成，而在其硅磷酸钙Ca5(PO4)2SiO4微晶相表面未发现HCA形成。     

Use of pyrogenic silicas for petroleum oil polar fraction characterisation. Fourier transform infrared spectroscopy and microelectrophoresis studies

In the power transformer, the presence of polar or charged species in the insulating oil can cause failure and electric discharges. Solid substrates such as silica can be used to extract the polar species and to refine the oil in order to prevent future failure in the power transformer. However, the use of silica for petroleum oil separation and refining will depend on the silica characteristics such as surface charge, surface composition, specific surface area and particle size.Various pyrogenic silicas having various specific surface areas (49-200 m² g⁻¹) and particle sizes (207-500 nm) were used to extract the polar fractions from the neat transformer insulating oils (a new, NO, and used, UO2, oils). The oil covered silica samples were investigated by diffuse reflectance infrared Fourier transform (DRIFT) spectroscopy in the range 4000-600 cm⁻¹. The bare silica surfaces present two main hydroxyl components, a sharper peak at 3745 cm⁻¹, I₃₇₄₅, due to isolated silanols and a second broad, which spreads over 3745-3000 cm⁻¹, I_3745-3000, due to H-bonded silanols. The relative intensities of the two components, I₃₇₄₅/I_3745-3000, varied for the bare and the oil covered silicas depending on the solid surface characteristics. The adsorption of the NO polar fraction onto silica leads to strong reduction in intensity of the sharper peak in favour of the broad one. However, the adsorption of the UO2 polar fraction onto silica leads in all cases to the decrease in the intensity of the both silica OH components. Further, the UO2 adsorption on the silica leads to the apparition of a broad peak at low frequency in the region 3250-3300 cm⁻¹ which, is due to the associated phenolic groups of UO2 oil polar fraction. The analysis of the DRIFT spectra for various samples indicates that the oil polar fraction resembles to asphaltenes compounds.The microelectrophoresis method used to investigate the surface charge at the water/oil polar fraction covered silica interface, indicates negatively charged particles. Further, the negative charge increased with the pH, as resulting from the increase of the ionisation and/or the amount of the oil polar carboxylic and phenolic groups. The oil polar fraction, i.e. the asphaltene components, in contact with both the silica surface and water at high pH values rearrange, due to their amphiphilic character.Finally, the use of the silica substrates seems to be suited to extract and analyse polar species present in petroleum oil. A correlation is found between the nature of the oil, its functionalities, and the magnitude of its zeta potential value at the water/oil covered silica interface.     

Silica removal from Mokai, New Zealand, geothermal brine by treatment with lime and a cationic precipitant

Preliminary experiments using two chemicals (CaO, a quicklime, and a cationic nitrogen-bearing precipitant, EC-004) to remove silica from geothermal brine were undertaken at the Mokai geothermal plant, New Zealand. The brine was mixed with the reagent (CaO or EC-004). The reaction was studied from the start of the experiment (NRT, 0 min, no retaining time) and after 15 min (15RT) at 90 °C. The concentration of silica in the brine was initially 954 mg/l, and decreased linearly with increasing reagent concentration. When CaO is added, the silica concentration at 15RT was 200 mg/l lower than at NRT and became almost zero on addition of 1.5 g/l. In contrast, when EC-004 is added, the total silica concentration nearly reaches the solubility of amorphous silica at 90 °C. In order to prevent silica scaling in Mokai brines cooled to 90 °C, the CaO and EC-004 added should be individually adjusted to 0.5 g/l and 80 mg/l, respectively.     

Monitoring Proteolysis During Cheddar Cheese Ripening Using Two-Dimensional Gel Electrophoresis

A 2-D gel electrophoretic method, consisting of isoelectric focusing and alkaline urea-PAGE was used to monitor proteolysis during ripening (180d, 5°C and 8°C) of full- and reduced-fat Cheddar cheese. The method enabled quantifying changes in levels of peptides in cheese with good spot-resolution. Results can complement those from other analyses, especially those for determining low MW peptides. Notable effects were found for cheese composition and ripening temperature on gel pattern and on relative levels of selected proteolysis products. In both cheese varieties, most peptides reached a maximum during the first 3 ripening months and gradually disappeared as ripening advanced.     

Eight-year exploration of shrinkage in high-performance concrete

In this paper, an experimental and analytical exploration on the effect of water-binder ratio (w/b), silica fume and age on autogenous, carbonation, drying and total shrinkage of high-performance concrete (HPC) is outlined. Eight types of HPC were studied. Carbonation, internal relative humidity (RH) and strength were studied on specimens from the same batch of HPC that was used in the studies of shrinkage. The results indicate fairly good correlation between carbonation, shrinkage, w/b and RH. The type and amount of silica fume affected shrinkage.     

CoFe2O4超细微粒催化剂的制备,性能与表征

用溶胶－凝胶法制备了钴铁复合氧化物超细微粒催化剂，用ＴＧ－ＤＴＡ、ＴＥＭ、ＸＲＤ等手段考察了加入聚乙二醇２００对其粉体特性及催化性能的影响，结果表明，添加金属量３％的聚乙二醇２００，可显著改善粒子团聚，得到平均粒径为３０ｎｍ、分散均匀的超细粒子，在３５０℃下焙烧２ｈ，可得到前驱体分解完全，非完整晶态的ＣｏＦｅ２Ｏ４，其对对甲酚催化氧化制取对羟基苯甲醛的性能较好。     

Inter- and intra-molecular ionic interactions of polyampholyte: Carboxymethyl-2-diethylaminoethylcellulose

Carboxymethyl-2-diethylaminoethylcellulose (CM-DEAE cellulose) was prepared by etherification of carboxymethylcellulose with diethylaminoethyl chloride in a NaOH solution. The behaviour of CM-DEAE cellulose in aqueous solution was studied by viscosity and GPC measurements. The degree of substitution (DS) and existing states of DEAE substituents were examined by the use of proton NMR, and those of the CM substituents were observed with FT-IR. The results reveal that the reduced viscosity and apparent molecular size of CM-DEAE cellulose vary with the concentration of sodium chloride and changes in pH and DS. These phenomena can be explained in terms of inter- and intra-molecular ionic interactions.