Determination of oxidized and reduced glutathione, by capillary zone electrophoresis, in Brassica juncea plants treated with copper and cadmium

A rapid method of capillary zone electrophoresis is described to determine the oxidized (GSSG) and reduced (GSH) form of glutathione in plant tissue. In order to separate both analytes in a fused-silica capillary, the pH and composition of the electrolyte solution were optimized. The electrolyte composition was 100 mmol/L, borate 25 mmol/L Tris, and 0.2% w/v metaphosphoric acid (MPA), pH 8.2. Some instrumental conditions used to run the samples were hydrostatic injection for 30 s, 30 kV applied voltage, and UV detection (185 nm) at 25 degrees C. Linearity and useful range obtained for the calibration curves were optimum, with correlation coefficients about 0.999 in the 0-120 micromol/L range. The migration time was highly reproducible, less than 5 min being afforded to run a sample. Electrolyte buffer and samples required a careful pH control for optimal separation of both analytes. This aspect constitutes a critical analytical step when acids are used in the procedure for sample preparation. Simultaneous analysis of GSH and GSSG may provide a useful tool for comparative studies of plants in order to select those species with a potential capacity for detoxification from toxic elements or those appearing promising from phytoremediation for these elements.     

胶束增溶光度法同时测定铂、铑、钯和金的研究

本文研究了贵金属Pt、Rh、Pd和Au在SnCl_2-BRB-AG-乳化剂OP离子缔合物体系中显色反应的条件,采用偏最小二乘回归法对上述体系重迭光谱进行解析及数据处理。结果表明,该体系灵敏度高,表观摩尔吸光系数可达1.74×10～6～2.47×10～6L·mol～-1·cm～-1;体系稳定性较好。应用本文方法对混合试样中Pt、Rh、Pd、Au进行同时测定,取得较满意的结果。     

Electrocatalytic properties of surface oxides on gold,platinum, and stainless steel electrodes in electrooxidation of malic acid

Electrocatalytic properties of oxides formed at gold, platinum, and stainless steel electrodes in the malic acid electrooxidation in 0.1 M Na₂SO₄ are studied. Gas chromatographic analysis of the electrolyte after holding the potential at 1.0 V for 8 h shows that on platinum and gold electrodes 2 mmol of acetaldehyde are produced and on stainless steel, 45 mmol. The acetaldehyde yield is the highest on stainless steel.From Elektrokhimiya, Vol. 41, No. 3, 2005, pp. 304–309.Original English Text Copyright © 2005 by Avramov Ivi, Popi, Antonovi.This article was submitted by the authors in English.     

Probing the water coordination of protein-targeted MRI contrast agents by pulsed ENDOR spectroscopy.

A novel methodology based on electron-nuclear double resonance (ENDOR) spectroscopy is used for the direct determination of the water coordination number (q) of gadolinium-based magnetic resonance imaging (MRI) contrast agents. Proton ENDOR spectra can be obtained at approximately physiological concentrations for metal complexes in frozen aqueous solutions either in the presence or absence of protein targets. It is shown that, depending on the structure of the co-ligand, the water hydration number of a complex in aqueous solution can be significantly different to when the complex is noncovalently bound to a protein. From the ENDOR spectra of the exchangeable protons, precise information on the metal-proton distance can be derived as well. These essential parameters directly correlate with the efficacy of MRI contrast agents and should therefore aid the development of novel, highly efficient compounds targeted to various proteins.     

Simultaneous determination of traces of heavy metals by solid-phase spectrophotometry

A coupling sensitive solid phase spectrophotometric (SPS) procedure for determination of traces of heavy metals (Me-SPS) and multicomponent analysis by multiple linear regressions (MA), a simple methodology for simultaneous determination of metals in mixtures was inaugurated. The Me-SPS procedure is based on sorption of heavy metals on PAN-resin and direct absorbance measurements of colour product Me-PAN sorbed on a solid carrier in a 1-mm cell. This methodology (Me-SPS-MA) was checked by simultaneous determination of metals in synthetic mixtures with different compositions and contents of metals important in pharmaceutical practice: Zn, Pb, Cd, Cu, Co, and Ni. Good agreement between experimental and theoretical amounts of heavy metals is obtained from the recovery test (78.3–110.0%). The proposed method enables determination of particular metal ion at the ng mL⁻¹ level and it was successfully applied to the determination impurities from heavy metal traces in pharmaceutical substances (Cu in ascorbic acid, Pb in glucose, and Zn in insulin). The proposed procedure could be possible contribution to the development of pharmacopoeial methodology for a heavy metals test.     

Free energies of transfer of complexes of the type MCl2py4 between pyridine and other solvent media

Solubility isotherms are reported for the NiCl₂·4py, MnCl₂·4py, and MnCl₂·2py solid pyridinates in a number of pyridine+diluent mixtures at 25°C. Activity coefficients of the solvent components have been derived from the total vapor pressures measured by a static method. The standard free energies of transfer for the NiCl₂py₄ and MnCl₂py₄ complexes are the same, within the experimental error, in the pyridine+aprotic diluent mixtures, while marked differences are observed in the pyridine+chloroform mixtures. Marked deviations are observed for chloroform and 1,2-dichloroethane from a correlation between the standard free energy of transfer of the complexes, on one hand, and the Hildebrand's solubility parameter of the solvent, on the other, the latter correlation being roughly valid for aprotic solvents. The deviations are tentatively ascribed to hydrogen bond formation of the type H... between the protic solvents and the coordinated pyridine molecules, enhanced by the d electron delocalization.     

Self-consistent relativistic effective core potentials for transition metal atoms: Cu,Ag, and Au

A development of the RECP method for the case of transition and rare earth elements is suggested. New terms with projectors on the occupation numbers ofd andf outermost shells respectively (which can be determined in SCF iterations) are added to the standard RECP operator and the corresponding self-consistent RECP terms are generated for atoms Cu, Ag and Au. Significant improvement is achieved in reproduction of atomic excitation energies as compared with the conventional shape-consistent RECP calculation.     

Ion chromatographic determination of alkali and alkaline earth metals in mineral waters

Summary The rapid, simultaneous, suppressed ion chromatographic determination of alkali, alkaline earth metals and ammonium in highly mineralized waters has been examined using the novel cation exchange IonPac CS12 column. General ability for the determination of lithium, sodium, ammounium, potassium, magnesium, calcium and strontium in concentrations from a few g to several mg per liter was studied. The relative standard deviations of retention times of all seven cations were below 0.7% and the relative standard deviations of the measurements of peak areas and peak heights were mostly below 5%. Six natural mineral waters of different types were selected for evaluation of the method. It was not possible to determine lithium in the one run and ammonium usually partially coelutes with sodium precluding quantitative determination. Strontium was undetectable because of the necessary dilutions. All the reltionships between peak areas and concentrations or peak height and concentrations were linear and there was also no evidence of the effect of different matrices on the slope of regression lines.     

High-temperature TG/DSC/QMS applications in environmental protection

The decomposition reactions of polystyrene, phenolic resin and a protective undercoating material for automobiles which contains PVC were tested using a new type of thermal analysis — mass spectrometry coupling system for measurements to 1500C or 2000C, which is based on the principle of a two-step skimmer orifice system. The results will be presented, with particular emphasis on the detection sensitivity of the new system for the products of decomposition.The capability of this coupling system to detect even heavy metals such as lead and silver in the waste gases from decomposition or after evaporation at high temperatures will also be demonstrated.     

Bond-length fluctuations in transition-metal oxoperovskites

Bond-length fluctuations in transition-metal oxoperovskites may give rise to two-phase fluctuations in what appears to be a single phase to a diffraction experiment. Orbital disorder at Jahn-Teller ions results in bond-length fluctuations that give 3D-ferromagnetic, vibronic Mn(III)-O-Mn(III) superexchange interactions and allow disproportionation into Mn(IV) and Mn(II) in LaMnO₃; where orbitally ordered and disordered phases coexist, an external magnetic field stabilizes the orbitally disordered, ferromagnetic phase relative to the orbitally ordered, antiferromagnetic phase. Spin-lattice interactions in the paramagnetic phase of charge-transfer compounds give bond-length fluctuations arising from the semicovalent component of the superexchange interactions. At the crossover from localized to itinerant electronic behavior, the coexistence of two-phase fluctuations has been demonstrated in both the single-valent RNiO₃ family (R=rare-earth, A=alkaline-earth) and the mixed-valent R_0.5A_0.5MnO₃ perovskites. “Bad-metal” behavior is found to be associated with bond-length fluctuations.